Special Parental Allowance for Totally Disabled Employees (a) An employee who: (i) fails to satisfy the eligibility requirement specified in subparagraph 17.05(a)(ii) solely because a concurrent entitlement to benefits under the Disability Insurance (DI) Plan, the Long-term Disability (LTD) Insurance portion of the Public Service Management Insurance Plan (PSMIP) or via the Government Employees Compensation Act prevents the employee from receiving Employment Insurance or Québec Parental Insurance Plan benefits, and (ii) has satisfied all of the other eligibility criteria specified in paragraph 17.05(a), other than those specified in sections (A) and (B) of subparagraph 17.05(a)(iii), shall be paid, in respect of each week of benefits under the parental allowance not received for the reason described in subparagraph (i), the difference between ninety-three per cent (93%) of the employee's rate of pay and the gross amount of his or her weekly disability benefit under the DI Plan, the LTD Plan or via the Government Employees Compensation Act. (b) An employee shall be paid an allowance under this clause and under clause 17.05 for a combined period of no more than the number of weeks during which the employee would have been eligible for parental, paternity or adoption benefits under the Employment Insurance or Québec Parental Insurance Plan, had the employee not been disqualified from Employment Insurance or Québec Parental Insurance Plan benefits for the reasons described in subparagraph (a)(i).
Overtime Meals When employees are required to work more than two (2) hours beyond their regular work days, the Employer will provide hot meals at no cost to the employees, up to a maximum of sixteen dollars ($16.00) (receipts to be submitted) plus paid meal periods of one-half (1/2) hour at the prevailing rate and thereafter at four (4) hour intervals. Any early morning start before regular starting time is entitled to a paid meal. The breakfast limit is thirteen dollars ($13.00) (receipts to be submitted). Employees called out on overtime shall be paid for meals as above, after four (4) hours work.
Minimum scope of coverage Commercial general coverage shall be at least as broad as Insurance Services Office Commercial General Liability occurrence form CG 0001 (ed. 11/88) or Insurance Services Office form number GL 0002 (ed. 1/73) covering comprehensive General Liability and Insurance Services Office form number GL 0404 covering Broad Form Comprehensive General Liability. Automobile coverage shall be at least as broad as Insurance Services Office Automobile Liability form CA 0001 (ed. 12/90) Code 1 (“any auto”). No endorsement shall be attached limiting the coverage.
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
Weighing and Scaling Costs Purchaser agrees to pay for all weighing costs for logs delivered regardless if logs are purchased on a weight or scale basis. In addition, Purchaser agrees to pay for all scaling costs for logs delivered on a scale basis. Purchaser also agrees to pay for all costs associated with the transmission and reporting of scale or weight data.
Working and Labor Synergies The Contractor shall be responsible for maintaining a tranquil working relationship between the Contractor work force, the Contractor Parties and their work force, State employees, and any other contractors present at the work site. The Contractor shall quickly resolve all labor disputes which result from the Contractor's or Contractor Parties’ presence at the work site, or other action under their control. Labor disputes shall not be deemed to be sufficient cause to allow the Contractor to make any claim for additional compensation for cost, expenses or any other loss or damage, nor shall those disputes be deemed to be sufficient reason to relieve the Contractor from any of its obligations under the Contract.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Training and Promotion a. The contractor will assist in locating, qualifying, and increasing the skills of minorities and women who are applicants for employment or current employees. Such efforts should be aimed at developing full journey level status employees in the type of trade or job classification involved. b. Consistent with the contractor's work force requirements and as permissible under Federal and State regulations, the contractor shall make full use of training programs, i.e., apprenticeship, and on-the-job training programs for the geographical area of contract performance. In the event a special provision for training is provided under this contract, this subparagraph will be superseded as indicated in the special provision. The contracting agency may reserve training positions for persons who receive welfare assistance in accordance with 23 U.S.C. 140(a). c. The contractor will advise employees and applicants for employment of available training programs and entrance requirements for each. d. The contractor will periodically review the training and promotion potential of employees who are minorities and women and will encourage eligible employees to apply for such training and promotion.