ELECTRICAL AND MECHANICAL SYSTEMS Sample Clauses

ELECTRICAL AND MECHANICAL SYSTEMS. The Building Shell work shall include but be limited to the design and installation of a 1,200-amp, 480/277-volt, 3-phase main service electrical system; including main switch gear and a house sub-panel to the electrical room. All power distribution from the main switchgear to all subpanels shall be a part of the tenant improvements. The design and installation of all mechanical and ventilation systems shall be a part of the Tenant Improvements.
Sample 1Sample 2
AutoNDA by SimpleDocs
ELECTRICAL AND MECHANICAL SYSTEMS. The Building Shell work shall include but be limited to the design and installation of a 1,200-amp, 480/277-volt, 3-phase main service electrical system; including main switch gear and a house sub-panel to the electrical room. All power distribution from the main switchgear to all subpanels shall be a part of the tenant improvements. The design and installation of all mechanical and ventilation systems shall be a part of the Tenant Improvements. SECURITY AND EXTERIOR LIGHTING Exterior security lighting for the building shall be a part of the Building Shell. The sprinkler system monitoring alarm shall be part of the Building Shell. II. TENANT IMPROVEMENTS: The tenant improvement funds provided by SCI are intended for use only in the physical construction of the interior improvements of the facility and fees associated with design and engineering costs. Prohibited uses include but are not limited to costs of moving, furnishings, equipment, temporary occupancy of other space, and consulting other than for the design and construction of the project. It is the intent of the parties that the Tenant Improvement allowance may be used only for items materially consistent with the scope of work shown on the Tenant Improvement Scope of Work attached as Exhibit 2 to the Construction Addendum. Landlord shall have the right to refuse to disburse any portion of the Tenant Improvement Allowance if in Landlord's reasonable opinion the work which is the basis for the disbursement request does not materially conform to the Tenant Improvement Scope or is not consistent with the preceding paragraph. If the Landlord does not disburse the entire Tenant Improvement Allowance to Tenant pursuant to the terms of the Lease, then the amount not used shall be retained by Landlord and Tenant's TI Amortization will be reduced accordingly. 3 <PAGE> FOURTH AMENDMENT TO LEASE AGREEMENT THE FOURTH AMENDMENT TO LEASE AGREEMENT ("Fourth Amendment") made this 18th day of June, 2003 by and between ProLogis formerly known as Security Capital Industrial Trust as "Landlord" and Celerity Group, Inc., a California Corporation formerly known as Kinetics Fluid Systems Inc., hereinafter referred to as "Tenant", in Premises known as Xxxxxxxx Xxxx Xxxxxxxxx Xxxxxx, Xxxxxxxx 0, located at 000-X Xxxxxx Xxxxx, Suite 600, situated in the city of Austin, State of Texas.
Sample 1
ELECTRICAL AND MECHANICAL SYSTEMS. The Lessor shall keep the Premises in compliance with all applicable requirements of local codes and ordinances. When codes conflict, the more stringent standard shall apply.
Sample 1

Related to ELECTRICAL AND MECHANICAL SYSTEMS

  • ELECTRICAL SERVICES The Company must construct and reticulate electrical requirements for all amenities and facilities. The Company must construct sub-station and distribution boards necessary to reticulate power to all Company owned or leased facilities which provide amenities to the public. The electrical installation must be to the design and installation standards of the State Energy Commission of Western Australia. All electrical reticulation must be placed underground.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.

  • Electrical Provide drawings for the following systems: .1 Lighting including circuiting and luminaire identification and switching. Also provide illuminance computer printout for all indoor typical indoor spaces and parking lots. .2 Convenience outlets and circuiting, special outlets and circuiting, television outlets, and power systems and equipment. Provide riser diagrams for all electrical systems including master clock, intercom, fire alarm, ITV, computer networking/telephone. Also, provide for emergency and normal power distribution. Provide luminaire schedule. .3 Panel schedule may be in preliminary form but circuitry must be included. .4 Applicable installation details. .5 General legend and list of abbreviations. .6 Voltage drop computation for all main feeders. .7 Short circuit analysis .8 Provide 1/2" scale floor plan and wall elevations for all electrical rooms.

  • Systems The details of any systems work will be determined after a thorough business analysis. System's work will be billed on a time and material basis. Investors Bank provides an allowance of 10 systems hours for data extract set up and reporting extract set up. Additional hours will be billed on a time and material basis.

  • Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts.

  • Mechanical (i) Large scale mechanical details complete. (ii) Mechanical schedules for equipment completed. (iii) Completed electrical schematic for environmental cooling and exhaust equipment. (iv) Complete energy conservation calculations and report.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!