Owner Furnishing Equipment or Fixtures Sample Clauses

Owner Furnishing Equipment or Fixtures. The Owner may directly furnish any and all of the equipment or fixtures required for the Project. In the event the Owner elects to do so, the Lump Sum Price shall be reduced by the amount which was to be charged by Contractor for such equipment or fixtures as set forth and included in the Contract Documents. A Contract Amendment reducing the Lump Sum Price for that item of Work shall be executed by Owner and Contractor to reflect a reduction in the Lump Sum Price for that item of Work and that the Owner is to furnish the equipment or fixtures. The Contractor shall assume responsibility for and be fully responsible for the care, custody, and control of all Owner furnished equipment or fixtures after said equipment or fixtures arrives on the Work Site or in any approved offsite storage facility, as set forth in Section 60-08 of the FAA’s General Provisions.
AutoNDA by SimpleDocs
Owner Furnishing Equipment or Fixtures. The Owner may directly furnish any and all of the equipment or fixtures required for the Project. In the event the Owner elects to do so, the Lump Sum Price shall be reduced by the amount which was to be charged by Contractor for such equipment or fixtures as set forth and included in the Contract Documents. A Change Order reducing the Lump Sum Price for that item of Work shall be executed by Owner and Contractor to reflect a reduction in the Lump Sum Price for that item of Work and that the Owner is to furnish the equipment. The Contractor shall assume responsibility for and be fully responsible for the care, custody and control of all Owner furnished equipment after said equipment arrives on the job site or in any approved off site storage facility. AS BUILT DRAWINGS AND DATA As Built Drawings. A complete set of drawings shall be maintained by the Contractor at the construction site for the purpose of accurately indicating all as built conditions which shall be measured and dimensioned to known permanent buildings and floor levels. The drawings shall be kept up-to-date and marked each day to show all changes and variations and each entry shall be dated and verified as made. Reproducible tracings of “as built” drawings shall be furnished by the Contractor to the Architect. At the completion of the Work and prior to final payment, a complete set of reproducible “as built” drawings shall be furnished by the Contractor to the Architect. If the as built drawings are not kept current each month, the Owner shall have no obligation to pay the Contractor until the as built drawings are made current. Operation and Maintenance Data.

Related to Owner Furnishing Equipment or Fixtures

  • Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.

  • STANDARD EQUIPMENT All items of standard equipment which are provided by the OEM shall be furnished unless such items are expressly deleted by the Authorized User or are specified to be other than standard in the Mini-Bid. When Optional equipment is specified, all components listed in the OEM’s data book as being included with the Option shall be furnished.

  • Supplies and Equipment The Union and employees will not use state-purchased supplies or equipment to conduct union business or representational activities. This does not preclude the use of the telephone for representational activities if there is no cost to the Employer, the call is brief in duration and it does not disrupt or distract from the Employer’s business.

  • Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling a service or installation visit, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.

  • Premises and equipment 6.1 If necessary, the Customer shall provide the Supplier with reasonable access at reasonable times to its premises for the purpose of supplying the Services. All equipment, tools and vehicles brought onto the Customer’s premises by the Supplier or the Staff shall be at the Supplier’s risk.

  • Safe Equipment The City shall furnish and maintain in the best possible working condition, within the limits of its financial capability, the necessary tools, facilities, vehicles, supplies, and equipment required for members to safely carry out their duties. Members are responsible for reporting unsafe conditions or practices, for avoiding negligence, and for properly using and caring for tools, facilities, vehicles, supplies, and equipment provided by the City.

  • Fittings & Fixtures Except those provided by the Promoter, all fitouts to be put-up, erected and installed at or inside the Designated Apartment including the interior decoration shall be done and completed by the Allottee at its own costs and expenses. In doing and carrying out the said fitout works, the Allottee shall be obliged to do all works in a good and xxxxxxx-like manner and without violating any laws, rules or regulations of the municipal, National Building Code and Fire rules and others and with minimum noise and without causing any disturbance or annoyance to the other Co-owners. The Allottee shall ensure that there shall be no stacking of debris or materials in any Common Areas and there shall be regular clearing of all debris arising out of the Fitout works. The Allottee hereby unequivocally and categorically undertakes not to drill, break, maim, hammer or in anyway damage or destroy the beams and columns on the floor, ceiling and walls of the Designated Apartment. The Allottee shall be responsible for all consequences, loss of life and property, damages or accidents that may occur due to breach or default on the part of the Allottee while carrying out any fitout or other activity.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Title to Equipment Title shall vest in the Contractor to all equipment purchased hereunder.

  • Fixtures All Equipment now owned, or the ownership of which is hereafter acquired, by Borrower which is so related to the Land and Improvements forming part of the Property that it is deemed fixtures or real property under the law of the particular state in which the Equipment is located, including, without limitation, all building or construction materials intended for construction, reconstruction, alteration or repair of or installation on the Property, construction equipment, appliances, machinery, plant equipment, fittings, apparatuses, fixtures and other items now or hereafter attached to, installed in or used in connection with (temporarily or permanently) any of the Improvements or the Land, including, but not limited to, engines, devices for the operation of pumps, pipes, plumbing, cleaning, call and sprinkler systems, fire extinguishing apparatuses and equipment, heating, ventilating, plumbing, laundry, incinerating, electrical, air conditioning and air cooling equipment and systems, gas and electric machinery, appurtenances and equipment, pollution control equipment, security systems, disposals, dishwashers, refrigerators and ranges, recreational equipment and facilities of all kinds, and water, gas, electrical, storm and sanitary sewer facilities, utility lines and equipment (whether owned individually or jointly with others, and, if owned jointly, to the extent of Borrower's interest therein) and all other utilities whether or not situated in easements, all water tanks, water supply, water power sites, fuel stations, fuel tanks, fuel supply, and all other structures, together with all accessions, appurtenances, additions, replacements, betterments and substitutions for any of the foregoing and the proceeds thereof (collectively, the "FIXTURES"). Notwithstanding the foregoing, "Fixtures" shall not include any property which tenants are entitled to remove pursuant to leases except to the extent that Borrower shall have any right or interest therein;

Time is Money Join Law Insider Premium to draft better contracts faster.