Plant Data Sample Clauses

Plant Data. To the extent not provided with respect to a previous Operating Year, all hydroelectric and thermal plant data regarding the Firm Resources of such Party including Project Unregulated Streamflows for the Historical Period of Record, reservoir capacity, conversion factors and peaking capacities throughout the operating range, operating restrictions, minimum flow limitations, limitations required for non-power uses, fuel conversion rates, and any other data reasonably anticipated by such Party to be necessary for the determination of FLCC.
AutoNDA by SimpleDocs
Plant Data. Notwithstanding the provisions of Sections II.1 and II.2 of this Agreement, Prior Operator and its affiliates may continue to receive from Operator meteorological and other data produced from Counterparty’s facility under Section 13.4 of the O&M Agreement (as in effect immediately prior to the Closing, the “Prior O&M Agreement”) on the terms and conditions set forth in the Prior O&M Agreement) as if Prior Operator and its affiliates were authorized contractors under the Prior O&M Agreement, and shall have any of the same rights as Operator may have under the Prior O&M Agreement with respect to such data, for the purposes of assessing and improving photovoltaic modules of Prior Operator and its affiliates and such other purposes as permitted by the Prior O&M Agreement; provided, however, that Prior Operator continues to be bound by the confidentiality obligations of the O&M Agreement related to the handling and use of such facility data.
Plant Data. Power: Amp Volt Phase Rail Heat
Plant Data. Attached hereto as Schedule 3.11, is the following selected historical operating or performance data of the generating units included in the Assets (the "Operating Data"): (i) PacifiCorp's most recent recorded measurement of the "dependable operating capacity" (as defined in such Schedule) of each such unit for which PacifiCorp has historical records of such measurements and the dependable operating capacity recorded by PacifiCorp at such time in accordance with the procedures and parameters described in such Schedule; (ii) PacifiCorp's most recent annual so-called "wide-open valve heat rate test" for each such unit and the outcomes of such tests recorded by PacifiCorp, subject to the procedures, parameters and assumptions that are further described in such Schedule; and (iii) the last major scheduled turbine overhaul recorded for each unit included in the Assets and the results recorded by PacifiCorp, if any (as part of its customary overhaul procedure), of a so-called "wide-open valve heat rate test" immediately prior to such overhaul and immediately after such overhaul, subject to the procedures, parameters and assumptions that are further described in such Schedule. To Sellers' Knowledge, the measurements and tests referred to in clauses (i) through (iii) above were all conducted in accordance with practices reasonably likely to result in information that was materially accurate as of the dates on which it was recorded, subject to the accuracy of the measurement devices used and the other assumptions and qualifications contained in such Schedule. Since the date of the Independent Engineer Report referred to in Section 3.8, Sellers have operated the Plant only in the usual and ordinary course, except as identified in Schedule 3.11, and there has not been: Page 25 - CENTRALIA PLANT PURCHASE AND SALE AGREEMENT (a) Any material casualty, physical damage, destruction or physical loss respecting, or, to Sellers' Knowledge, material adverse change in the physical condition of, the Plant, subject to ordinary wear and tear and to routine maintenance; (b) Any sale or other disposition other than in the ordinary course of business of any fixed Asset that has a net book value in excess of $100,000; (c) Any material pledge or imposition of lien on any of such Assets, except for such as will be removed as of the Closing or except for Permitted Encumbrances; or (d) Any material amendment (other than general amendments which the insurance carrier makes for a category ...

Related to Plant Data

  • Client Data The Subrecipient shall maintain client data demonstrating client eligibility for services provided. Such data shall include, but not be limited to, client name, address, income level or other basis for determining eligibility, and description of service provided. Such information shall be made available to Grantee monitors or their designees for review upon request.

  • Customer Data 5.1 The Customer shall own all rights, title and interest in and to all of the Customer Data and shall have sole responsibility for the legality, reliability, integrity, accuracy and quality of the Customer Data. 5.2 The Supplier shall follow its archiving procedures for Customer Data as set out in its Back-Up Policy available at XxxxxXXX.xxx or such other website address as may be notified to the Customer as such document may be amended by the Supplier in its sole discretion from time to time the current version of which is set out at Schedule 3 of this Agreement. In the event of any loss or damage to Customer Data, the Customer's sole and exclusive remedy shall be for the Supplier to use reasonable commercial endeavours to restore the lost or damaged Customer Data from the latest back-up of such Customer Data maintained by the Supplier in accordance with the archiving procedure described in its Back-Up Policy. The Supplier shall not be responsible for any loss, destruction, alteration or disclosure of Customer Data caused by any third party (except those third parties sub-contracted by the Supplier to perform services related to Customer Data maintenance and back-up). 5.3 The Supplier shall, in providing the Services, comply with its Privacy and Security Policy as such document may be amended from time to time by the Supplier in its sole discretion. 5.4 If the Supplier processes any personal data on the Customer’s behalf when performing its obligations under this agreement, the parties record their intention that the Customer shall be the data controller and the Supplier shall be a data processor and in any such case: (a) the Customer shall ensure that the Customer is entitled to transfer the relevant personal data to the Supplier so that the Supplier may lawfully use, process and transfer the personal data in accordance with this agreement on the Customer's behalf; (b) the Customer shall ensure that the relevant third parties have been informed of, and have given their consent to, such use, processing, and transfer as required by all applicable data protection legislation; (c) the Supplier shall process the personal data only in accordance with the terms of this agreement and any lawful instructions reasonably given by the Customer from time to time; and (d) each party shall take appropriate technical and organisational measures against unauthorised or unlawful processing of the personal data or its accidental loss, destruction or damage. 5.5 The Supplier and the Customer shall comply with their respective obligations as set out in Schedule 4 of this Agreement

  • Product Data Illustrations, standard schedules, performance charts, instructions, brochures, diagrams, and other information furnished by Developer to illustrate a material, product, or system for some portion of the Work.

  • CONTRACT DATA The Consultant is advised to read the NEC3 Professional Service Contract (Third edition with amendments of June 2006 and April 2013) and the relevant Guidance Notes and Flow Charts, published by the Institution of Civil Engineers, in order to understand the implications of this Data which is required. Copies of these documents may be obtained from the Engineering Contract Strategies (telephone (00) 000 000 0000). Each item of data given below is cross-referenced to the clause in the NEC3 Professional Service Contract to which it mainly applies.

  • Device Data We may share certain personal information and device-identifying technical data about you and your devices with third party service providers, who will compare and add device data and fraud data from and about you to a database of similar device and fraud information in order to provide fraud management and prevention services, which include but are not limited to identifying and blocking access to the applicable service or Web site by devices associated with fraudulent or abusive activity. Such information may be used by us and our third party service providers to provide similar fraud management and prevention services for services or Web sites not provided by us. We will not share with service providers any information that personally identifies the user of the applicable device.

  • Metering Data At Developer’s expense, the metered data shall be telemetered to one or more locations designated by Connecting Transmission Owner, Developer and NYISO. Such telemetered data shall be used, under normal operating conditions, as the official measurement of the amount of energy delivered from the Large Generating Facility to the Point of Interconnection.

  • Stored Materials The Department shall not be required to pay for materials stored at the site or stored at other locations absent prior written authorization to do so, which authorization may be withheld at the Department's sole discretion. If the Department expressly agrees to pay for materials stored at the site but not yet incorporated into the Work, the Application for Payment may also include a request for payment of the cost of such materials, if the materials have been delivered to the site, and suitably stored. Such requests shall be documented by appropriate invoices and bills of sale. Payment for stored materials shall be conditioned also on the Design-Builder’s representation that it has inspected the material and found it to be free from defect and otherwise in conformity with this Agreement, and on satisfactory evidence that the materials are insured under the builder’s risk policy. Further, if the Design-Builder requests the Department to allow payments for storage of materials offsite, the Design-Builder shall be required, inter alia, to agree to execution of proper documentation to afford the Department a secured interest in the materials upon payment.

  • STUDENT DATA Contractor acknowledges that student data is protected by both federal and state law. See Wis. Stat. § 118.125; 20 U.S.C. § 1232g(b); 34 C.F.R. § 99.1

  • Outputs Analogue and digital outputs of protected content are allowed if they meet the requirements in this section and if they are not forbidden elsewhere in this Agreement..

  • SHOP DRAWINGS, PRODUCT DATA AND SAMPLES 4.12.1 Shop Drawings are drawings, diagrams, schedules and other, data specially prepared for the Work by the Contractor or any Subcontractor, manufacturer, supplier or distributor to illustrate some portion of the Work. 4.12.2 Product Data are illustrations, standard schedules, performance charts, instructions, brochures, diagrams and other information furnished by the Contractor to illustrate a material, product or system for some portion of the Work. 4.12.3 Samples are physical examples which illustrate materials, equipment or workmanship and establish standards by which the Work will be judged. 4.12.4 The Contractor shall review, approve and submit, with reasonable promptness and in such sequence as to cause no delay in the Work or in the work of the State or any separate contractor, all Shop Drawings, Product Data and Samples required by the Contract Documents. 4.12.5 By approving and submitting Shop Drawings, Product Data and Samples, the Contractor represents that he / she has determined and verified all materials, field measurements, and field construction criteria related thereto, or will do so, and that he / she has checked and coordinated the information contained within such submittals with the requirements of the Work and of the Contract Documents. 4.12.6 The Contractor shall not be relieved of responsibility for any deviation from the requirements of the Contract Documents by the Architect's approval of Shop Drawings, Product Data or Samples under Subparagraph 2.2.7 of these General Conditions unless the Contractor has specifically informed the Architect and the State in writing of such deviation at the time of sub- mission and the Architect and the State has given written approval to the specific deviation. The Contractor shall not be relieved from responsibility for errors or omissions in the Shop Drawings, Product Data or Samples by the Architect's approval thereof. 4.12.7 The Contractor shall direct specific attention, in writing or on resubmitted Shop Drawings, Product Data or Samples, to revisions other than those requested by the Architect on previous submittals. 4.12.8 No portion of the Work requiring submission of a Shop Drawing, Product Data or Sample shall be commenced until the submittal has been approved by the Architect as provided in Subparagraph 2.2.7 of these General Conditions. All such portions of the Work shall be in accordance with approved submittals.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!