Training a. The employer, in consultation with the local, shall be responsible for developing and implementing an ongoing harassment and sexual harassment awareness program for all employees. Where a program currently exists and meets the criteria listed in this agreement, such a program shall be deemed to satisfy the provisions of this article. This awareness program shall initially be for all employees and shall be scheduled at least once annually for all new employees to attend. b. The awareness program shall include but not be limited to: i. the definitions of harassment and sexual harassment as outlined in this Agreement; ii. understanding situations that are not harassment or sexual harassment, including the exercise of an employer's managerial and/or supervisory rights and responsibilities; iii. developing an awareness of behaviour that is illegal and/or inappropriate; iv. outlining strategies to prevent harassment and sexual harassment; v. a review of the resolution of harassment and sexual harassment as outlined in this Agreement; vi. understanding malicious complaints and the consequences of such; vii. outlining any Board policy for dealing with harassment and sexual harassment; viii. outlining laws dealing with harassment and sexual harassment which apply to employees in B.C.
Training Program It is agreed that there shall be an Apprenticeship Training Program, the provisions of which are set forth in Exhibit "D", which is attached hereto and forms part of this Agreement.
Curriculum U The Academy Trust must provide for the teaching of religious education and a daily act of collective worship at the Academy.
Development Work The Support Standards do not include development work either (i) on software not licensed from CentralSquare or (ii) development work for enhancements or features that are outside the documented functionality of the Solutions, except such work as may be specifically purchased and outlined in Exhibit 1. CentralSquare retains all Intellectual Property Rights in development work performed and Customer may request consulting and development work from CentralSquare as a separate billable service.
Training Services Training Services may include pre-packaged training Products, and/or the development or customization of training programs as requested, including Live Training, Computer Based/Multi-Media Training which encompasses Internet-Delivered Training, and/or Video Based Training.
Work Scheduling Except at the request of an affected employee, no employee shall have the number of hours they are normally scheduled to work reduced as the result of the use of non-permanent employees such as, but not limited to: seasonal, intermittent, student interns, interns, interim, established term, or temporary employees, due to the performance of such employee’s duties by the nonpermanent employee.
Overtime Scheduling 1. Each employee interested in working overtime may volunteer by requesting, in writing, to be added to the voluntary overtime list within his/her building and/or the district-wide voluntary overtime list. They will also indicate whether they wish to work during their vacation period. Such written request to be added to or deleted from the overtime lists may be made at any time; however, if the employee is requesting to be deleted from the list(s), he/she shall not be allowed to rejoin the list(s) for a ninety (90) calendar day period. Such lists shall be maintained on a yearly basis, from September 1st to August 31st of each year. The employer will serve notice to the employees, by a memo into each work area, that overtime lists are being formulated, by August 15th of each year. 2. The list will be compiled for September with the volunteers listed in seniority order. Overtime shall be rotated among volunteers. The rotation shall be continuous through the year until a new list is compiled the following September. If an employee volunteers who was not on the list he/she shall be placed on the list according to his/her seniority and he/she shall be eligible to work overtime in accordance with the normal rotation. 3. To the extent possible, employees will be notified at least four (4) hours prior to the end of the shift of any overtime for that day and by noon on Friday for any Saturday overtime. Any employee who has volunteered to work overtime and is notified in accordance with this paragraph shall be obligated to work the overtime hours in their building unless excused by the supervisor. 4. Overtime assignments will be on a rotating schedule among the qualified employees within each classification who have expressly volunteered for such overtime work. The employer’s obligation to rotate overtime shall be satisfied by calling employees who are working at the time the overtime determination is made (i.e., not on vacation or other leave of absence) in seniority order and offering them the opportunity to work. 5. If there are insufficient volunteers available for any specific assignment, the employer may require the least senior employee in the division to perform the work. 6. Substantiated errors made in the rotation of overtime (Article XIII Section G.4) will be corrected on the basis of offering the by-passed employee an amount of overtime equal to the time lost due to the error of assignment. Depending on the number of hours involved, it is possible that this may take more than (1) one overtime offer/assignment. Acceptance of the compensatory overtime will not change the employees spot in the overtime rotation, thus the employee will remain eligible for overtime in the same rotation as before the error. The compensatory overtime will not be offered at such a time or in such a manner that would purposefully cause inconvenience or inability to the effected employee to comply. In the event the employee declines the offered overtime work, the employee shall forfeit any future claim to the overtime hours in dispute.
Training Programs All employees shall successfully complete all necessary training prior to being assigned work (e.g., all employees will complete health and safety training prior to being assigned to task). Nothing in this Article or provision shall constitute a waiver of either party’s bargaining obligations or defenses. The Employer still has an obligation to notify and bargain changes in terms and conditions of employment with the exclusive representative.
Trainings Appointment of any length involving two (2) or more Consumers who might need to split up to join different trainings, group discussions, etc.
Training Courses 16.4.1 Training courses, as well as the minimum and maximum numbers of trainees per course provided for the Buyer’s personnel, are defined in the applicable training course catalog published by ANACS (the “Training Course Catalog”) and will be scheduled as mutually agreed upon during a training conference (the “Training Conference”) that will be held as soon as practicable after signature of this Agreement and no later than May 31, 2007. AVA - A320 Family PA AMENDED AND RESTATED 16.4.2 The following terms will apply when training is performed ANACS: (i) Subject to 16.4.2(ii) below, training courses will be standard Airbus courses as described in ANACS applicable Training Course Catalog valid at the time of execution of the course. ANACS will be responsible for all training course syllabi, training aids and training equipment (not to include aircraft) necessary for the organization of the training courses. (ii) Where ANACS agrees to perform training using Buyer’s standard courses, Buyer will be responsible for taking all steps necessary to assure approval by applicable Aviation Authorities of such training (including any needed approvals of specific ANACS instructors). (iii) The training curricula and the training equipment used for flight crew, cabin crew and maintenance training will not be fully customized but will be configured in order to obtain the relevant Aviation Authority’s approval and to support the Seller’s training programs. Notwithstanding the foregoing, the training curricula used for training performed under such circumstances shall enumerate any differences that exist between the non-customized material and Buyer’s detailed specification. (iv) Training data and documentation necessary for training detailed in Appendix A to this Clause 16 will be and will not be revised. Training data and documentation will be marked “FOR TRAINING ONLY” and as such will be supplied for the sole and express purpose of training. (v) Upon the request of the Buyer [*], the Seller will collect and pack for consolidated shipment to the Buyer’s facility, all training data and documentation of the Buyer’s trainees attending training at the Seller’s Training Center. This training data and documentation will be delivered [*]. It is understood that title to and risk of loss of the training data and documentation will pass to the Buyer [*]. 16.4.3.1 If the Buyer decides to cancel fully or partially or reschedule, a training course, a minimum advance notification of at least [*] calendar days prior to the relevant training course start date is required. 16.4.3.2 If such notification is received by the Seller or ANACS less than [*] but more than [*] calendar days prior to such training, a cancellation fee corresponding to [*] of such training will be deducted from the training allowance defined in Appendix A to the extent sufficient allowance then remains, with any balance invoiced at the price corresponding to such training in the then current ANACS Customer Services Catalog. 16.4.3.3 If such notification is received by the Seller less than [*] calendar days prior [*] of such training will be deducted from the training allowance defined in Appendix A to the extent sufficient allowance then remains, with any balance invoiced at the price corresponding to such training in the then current ANACS Customer Services Catalog. 16.4.3.4 [*]