TRANSIT FLIGHTS Sample Clauses

TRANSIT FLIGHTS. 1. Transit flights conducted by an observing Party to and from the territory of an observed Party for the purposes of this Treaty shall originate on the territory of the observing Party or of another State Party. 2. Each State Party shall accept transit flights. Such transit flights shall be conducted along internationally recognized Air Traffic Services routes, unless otherwise agreed by the States Parties involved, and in accordance with the instructions of the national air traffic control authorities of each State Party whose airspace is transited. The observing Party shall notify each State Party whose airspace is to be transited at the same time that it notifies the observed Party in accordance with Article VI. 3. The operation of sensors on an observation aircraft during transit flights is prohibited. In the event that, during the transit flight, the observation aircraft lands on the territory of a State Party, that State Party shall, upon landing and prior to departure, inspect the covers of sensor apertures or other devices that inhibit the operation of sensors to confirm that they are in their proper position. PROHIBITIONS, DEVIATIONS FROM FLIGHT PLANS AND EMERGENCY SITUATIONS Section I. Prohibition of observation flights and changes to mission plans 1. The observed Party shall have the right to prohibit an observation flight that is not in compliance with the provisions of this Treaty. 2. The observed Party shall have the right to prohibit an observation flight prior to its commencement in the event that the observing Party fails to arrive at the point of entry within 24 hours after the estimated time of arrival specified in the notification provided in accordance with Article VI, Section I, paragraph 5, unless otherwise agreed between the States Parties involved. 3. In the event that an observed State Party prohibits an observation flight pursuant to this Article or Annex F, it shall immediately state the facts for the prohibition in the mission plan. Within seven days the observed Party shall provide to all States Parties, through diplomatic channels, a written explanation for this prohibition in the mission report provided pursuant to Article VI, Section I, paragraph 21. An observation flight that has been prohibited shall not be counted against the quota of either State Party. 4. The observed Party shall have the right to propose changes to the mission plan as a result of any of the following circumstances: (A) the weather conditions affect f...
AutoNDA by SimpleDocs
TRANSIT FLIGHTS. 1. Transit flights conducted by an observing Party to and from the territory of an observed Party for the purposes of this Treaty shall originate on the territory of the observing Party or of another State Party. 2. Each State Party shall accept transit flights. Such transit flights shall be conducted along internationally recognized Air Traffic Services routes, unless otherwise agreed by the States Parties involved, and in accordance with the instructions of the national air traffic control authorities of each State Party whose airspace is transited. The observing Party shall notify each State Party whose airspace is to be transited at the same time that it notifies the observed Party in accordance with Article VI. 3. The operation of sensors on an observation aircraft during transit flights is prohibited. In the event that, during the transit flight, the observation aircraft lands on the territory of a State Party, that State Party shall, upon landing and prior to departure, inspect the covers of sensor apertures or other devices that inhibit the operation of sensors to confirm that they are in their proper position.

Related to TRANSIT FLIGHTS

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Network Services Local Access Services In lieu of any other rates and discounts, Customer will pay fixed monthly recurring local loop charges ranging from $1,200 to $2,000 for TDM-based DS-3 Network Services Local Access Services at 2 CLLI codes mutually agreed upon by Customer and Company.

  • Data Location 1.1. The CONTRACTOR shall not store or transfer non-public COUNTY data outside of the United States. This includes backup data and Disaster Recovery locations. The CONTRACTOR will permit its personnel and contractors to access COUNTY data remotely only as required to provide technical support. (Remote access to data from outside the continental United States is prohibited unless approved in advance and in writing by the County.) 1.2. The CONTRACTOR must notify the COUNTY in advance and in writing of any location changes to CONTRACTOR’s data center(s) that will process or store County data.

  • Verizon Operations Support Systems Verizon systems for pre- ordering, ordering, provisioning, maintenance and repair, and billing.

  • Customer Equipment Customer represents and warrants that it owns or has the legal right and authority, and will continue to own or maintain the legal right and authority during the term of this Agreement, to place and use the Customer Equipment as contemplated by this Agreement. Customer further represents and warrants that its placement, arrangement, and use of the Customer Equipment in the Internet Data Centers complies with the Customer Equipment Manufacturer's environmental and other specifications.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Program Location A. Unless otherwise agreed upon in writing, the parties acknowledge and agree that the Work of this Agreement will be performed at the following Property address: Ktr Address1 Address2

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Aircraft This peril includes self-propelled missiles and spacecraft.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!