Warranty Standards Sample Clauses

Warranty Standards. The standards by which all warranty claims and repair work will be evaluated are set out in the attached document. The terms of that document are incorporated herein.
AutoNDA by SimpleDocs
Warranty Standards. A. The applicability of these Warranty Standards is conditioned upon the purchaser’s proper maintenance of the home to prevent damage due to neglect, abnormal use or improper maintenance. Common elements will be covered for the same periods and to the same extent as comparable items which are part of individual homes. B. The applicability of these Warranty Standards is conditioned upon the fact that your home is constructed in compliance with the local building codes as well as one of each group of the following model codes or the Minimum Property Standards of the U.S. Department of Housing and Urban Development: International Building Code International Residential Code One and Two Family Dwelling Code BOCA Basic Building Code Standard Building Code, Southern Building Code Congress Uniform Building Code National Building Code International Mechanical Code BOCA Basic Mechanical Code Uniform Building Code, Volume 11, Mechanical Standard Mechanical Code, Southern Building Code Congress Electrical Code for One and Two Family Dwelling National Electrical Code International Plumbing Codes BOCA Basic Plumbing Code Uniform Plumbing Code Standard Plumbing Code, Southern Building Code Congress C. The table below establishes the standards by which it will be determined whether your home has a problem or defect covered by this warranty and whether it is the obligation of your Builder or QBW or its insurer to correct these defects. Where specific standards and obligations are not set forth, the standards shall be the generally accepted industry practice for workmanship and materials. (1) Ground settlement around foundation and utility trenches. (a) Standard. Ground settlement should not disrupt water drainage away from the structure although some settlement may occur.
Warranty Standards. 1. PURPOSE OF THE STANDARDS
Warranty Standards. The following Warranty Standards are applicable only to warranted items installed by the Builder and expressly stated in an exhibit to of this Limited Warranty, such exhibits being incorporated herein by reference, as may be conditioned by the Warranty Standards or other conditions set forth in this Agreement.
Warranty Standards. A. SITEWORK
Warranty Standards. A. The applicability of these Warranty Standards is conditioned upon the Purchaser’s proper maintenance of the home to prevent damage due to neglect, abnormal use or improper maintenance. Common elements will be covered for the same periods and to the same extent as comparable items which are part of individual homes. B. The applicability of these Warranty Standards is conditioned upon the fact that your home is constructed in compliance with the local building codes as well as one of each group of the following model codes or the Minimum Property Standards of the U.S. Department of Housing and Urban Development: One and Two Family Dwelling Code BOCA Basic Building Code Standard Building Code, Southern Building Code Congress Uniform Building Code National Building Code BOCA Basic Mechanical Code Uniform Building Code, Volume II, Mechanical Standard Mechanical Code, Southern Building Code Congress Electrical Code for One and Two Family Dwelling National Electrical Code BOCA Basic Plumbing Code Uniform Plumbing Code Standard Plumbing Code, Southern Building Code Congress C. The table below establishes the standards by which it will be determined whether your home has a problem or defect covered by this policy and whether it is the obligation of your Builder, QBW or its Insurer to correct these defects. Where specific standards and obligations are not set forth, the standards shall be the generally accepted industry practice for workmanship and materials. 1. Grading: Settling of ground around Settling of ground around foundation, walls, If Builder/Warrantor has provided final foundation walls, utility trenches or other utility trenches or other filled areas: which grading, Builder shall fill settled areas areas on the property where excavation and exceeds a maximum of six inches from affecting proper drainage, one time only, back fill have taken place that affect finished grade established by the during the first year Warranty period. drainage away from the house. Builder/Warrantor. Builder/Warrantor is then responsible for removal and replacement of shrubs and other landscaping installed by the Builder/Warrantor affected by placement of the fill.
Warranty Standards. Buyer agrees that, in the event of any claim, dispute, controversy or legal action related to or connected with this Agreement or the Property, the standards applicable to any issue related to construction shall be the standards set forth in the Hidden Valley Homes Warranty.
AutoNDA by SimpleDocs

Related to Warranty Standards

  • Property Standards Owner must maintain the Unit, and any common areas of the property accessible to the Tenant under the Lease, in decent, safe and sanitary condition and comply with all applicable state or local codes and requirements for rental properties. Upon notice by the Program Administrator following any inspection (whether conducted in-person or virtually in accordance with the Program guidelines), Owner will promptly correct any violations of Program requirements and this Contract. If the Owner fails to correct such violations, the Program Administrator may terminate this Contract and the Rental Assistance Payment even if the Tenant continues occupancy under the Lease. Owner/Representative Initials:

  • Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.

  • Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.

  • Security Standards The Provider shall implement and maintain commercially reasonable security procedures and practices that otherwise meet or exceed industry standards designed to protect Student Data from unauthorized access, destruction, use, modification, or disclosure, including but not limited to the unauthorized acquisition of computerized data that compromises the security, confidentiality, or integrity of the Student Data (a "Security Breach"). For purposes of the DPA and this Exhibit G, "Security Breach" does not include the good faith acquisition of Student Data by an employee or agent of the Provider or LEA for a legitimate educational or administrative purpose of the Provider or LEA, so long as the Student Data is used solely for purposes permitted by SOPPA and other applicable law, and so long as the Student Data is restricted from further unauthorized disclosure.

  • Service Level Standards In addition to all other requirements in this Agreement, and in accordance with the Best Claims Practices & Estimating Guidelines, Vendor shall use reasonable and good faith efforts to meet the Service Level Standards set forth below.

  • Content Standards You agree that you will not upload or provide content or otherwise post, transmit, distribute, or disseminate through the Zelle® Payment Service any material that: (1) is false, misleading, unlawful, obscene, indecent, lewd, pornographic, defamatory, libelous, threatening, harassing, hateful, abusive, or inflammatory; (2) encourages conduct that would be considered a criminal offense or gives rise to civil liability; (3) breaches or infringes any duty toward or rights of any person or entity, including rights of publicity, privacy or intellectual property; (4) contains corrupted data or any other harmful, disruptive, or destructive files; (5) advertises products or services competitive with Zelle®, as determined by Zelle® in its sole discretion; or (6) in Zelle®’s or our sole judgment, is objectionable, restricts or inhibits any person or entity from using or enjoying any portion of the Zelle® Payment Service, or which may expose us, Zelle® or our respective affiliates or customers to harm or liability of any nature.

  • OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.

  • Specifications and Standards a) All articles supplied shall strictly conform to the specifications, trademark laid down in the bidding document and wherever articles have been required according to ISI/ ISO/ other applicable specifications/ certifications/ standards, those articles should conform strictly to those specifications/ certifications/ standards. The supply shall be of best quality and description. The decision of the competent authority/ purchase committee whether the articles supplied conforms to the specifications shall be final and binding on the supplier/ selected bidder.

  • Applicable Standards The requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.

  • Standards Any additions, modifications, or replacements made to a Party’s facilities shall be designed, constructed and operated in accordance with this Agreement, NYISO requirements and Good Utility Practice.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!