Water Mains and Service Pipes. (1) The Developer shall be responsible for extending the existing water main to serve all lots on the Property. The Developer shall also install any pipe, hydrants, tees, valves, crosses and related appurtenances and water service laterals as required by the plans, specifications, and requirements of the Municipality and approved by the State of Wisconsin Department of Natural Resources, in addition to the other approvals required by this Agreement. Developer shall also install one water lateral to a point 15 feet beyond the right of way line for each lot at a location to be approved by the Municipal Engineer. All materials used shall conform to the Municipal Standard Specifications for Water Main Construction.
(2) The water main and any respective service laterals shall not be accepted until as built plans and a complete breakdown of all construction, engineering and administrative costs incurred by the Developer is submitted to the Municipal Engineer and Municipal Clerk. (This is necessary to aid in determining the Water Utility’s plant value.) In addition, the water system installation shall not be accepted until two bacteriologically safe samples are obtained, 24 hours apart, by a certified agency testing at the Madison Board of Health. The Developer shall be responsible to flush the main, obtain the samples, and have all tests completed as may be required for the Municipality’s acceptance.
Water Mains and Service Pipes. Subject to the approval of the VILLAGE as to size, depth and slope:
i. the DISTRICT shall install water mains, including pipe, hydrants, tees, valves, crosses and related appurtenances and water service laterals to the limits of the PROPERTY and as required by the plans, specifications, and requirements of the VILLAGE Water Utility and approved by the DNR, in addition to the other approvals required by this AGREEMENT. All hydrants shall include an attached fiberglass Rodon Corp. 5 foot Hydrafinder. All water service laterals two (2) inches in diameter and smaller shall be completed with a curb stop and box. All other water service laterals three (3) inches and larger shall be completed with a controlling valve and roadbox. All materials used shall conform to the VILLAGE Standard Specifications for Watermain Construction.
ii. The watermain shall be looped around the FACILITY site as approved by the VILLAGE, with a service connection at Mourning Dove Drive and a secondary service location to be determined by the DISTRICT and the VILLAGE. The on-site watermain will be maintained as private watermain in conformance with State and VILLAGE standards. Maintenance of the on-site private water main includes the flushing of the hydrants periodically or as directed by the VILLAGE. The watermain loop shall be completed prior to occupancy of the FACILITY.
iii. The incremental cost for pipe sizes greater than ten inches (10”) in diameter (“oversizing”) will be borne by the VILLAGE and either credited or reimbursed to the DISTRICT. The reimbursement is based on the approximate cost of pipe material only for the different pipe sizes and will be made in accordance with the amounts indicated in EXHIBIT E.
iv. The DISTRICT shall install a water main to the Northern boundary of the PROPERTY from Mourning Dove Drive and connect this line with the water main on Red Hawk Trail as prescribed by the VILLAGE.
v. The DISTRICT shall install a water main to the Southern boundary of the PROPERTY from Pheasant Run as prescribed by the VILLAGE to provide for future looping to the south.
vi. Private fire hydrants and other fire protection equipment shall be installed and located according to the applicable fire code and as approved by the Cottage Grove Fire Department.
vii. Connection to the mains shall include valves and temporary hydrants to allow for proper flushing of the water system. The DISTRICT shall provide utility easements for any facilities installed outside of the public righ...
Water Mains and Service Pipes. The Developer shall install water mains, including pipe, hydrants, tees, valves, crosses and related appurtenances and water service laterals to serve all lots within the land division and as required by the plans, specifications, and requirements of the Town and approved by the State of Wisconsin Department of Natural Resources, in addition to the other approvals required by this Agreement.
Water Mains and Service Pipes. The Developer shall install water mains, including pipes, hydrants, tees, valves, crosses and related appurtenances and water service laterals to serve Lots 1-4 within CSM 14444 and as required by the plans and specifications approved by Windsor’s Engineer and approved by the State of Wisconsin Department of Natural Resources in addition to the other approvals required by this Agreement. Windsor agrees to allow connection of the water mains, laterals and appurtenances to the existing Windsor Water Utility and will thereafter provide Windsor Water Utility Service. No curb boxes shall be located within areas intended for sidewalk and/or driveway installations.
Water Mains and Service Pipes a. SUBDIVIDER shall install water mains, including pipe, hydrants, tees, valves, crosses and related appurtenances and water service laterals to serve all lots within the PHASE then being completed and as required by the plans, specifications, and requirements of the Water Utility and approved by the State of Wisconsin Department of Natural Resources (DNR), in addition to the other approvals required by this AGREEMENT. All hydrants shall include an attached Radon Corp.
Water Mains and Service Pipes. The Developer shall install 8-inch water mains
