Scheduling Vacations Vacations are to be scheduled in advance and taken at such reasonable times as approved by the employee's department with particular regard to the needs of the Employer, seniority of employee, and, insofar as practicable, with regard to the wishes of the employee. No vacation shall be assigned by the Employer or deducted from the employee's account as disciplinary action.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site.
Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer.
Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations.
Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage.
Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer.
Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized.
Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel.
Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations.
Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job.
Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours.
Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement.
Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
HOLIDAYS AND VACATIONS If work is performed on Buyer's premises, Buyer shall not be obligated to make any payments to Seller for days designated by Buyer as holidays or shutdown periods, except for work specifically authorized in writing by Xxxxx's Authorized Procurement Representative and performed by Seller on such days.
PAID VACATIONS 41.1 The Board shall grant paid vacation periods to each Member in accordance with the terms and conditions outlined in this Article.
(a) The Board shall maintain a record of paid vacation entitlement for each Member based on the years, and parts thereof, of service from the most recent date of hire with the Board completed by August 31st prior to the vacation period to be taken.
(b) For the purpose of this Article, the most recent date of hire shall be the date of last hire where there has been no termination of employment since that date.
(c) A Member who was given credit for split service prior to the signing of this Agreement shall continue to retain such service for vacation entitlement.
(a) Every Member shall be granted by the Board an annual paid vacation according to the following schedule: Years of Service Prior Entitlement to September 1st less than 1 year 3 weeks pro rated to time worked 1 year 3 weeks 8 years 4 weeks 17 years 5 weeks 24 years 6 weeks
(b) The pay for any vacation period shall be calculated on the Member's annual salary as provided in Schedule A.
(a) Vacations will normally be taken during the months of July and August but alternate scheduling may be permitted with the approval of the Member’s immediate Supervisor. Such requests for alternate scheduling shall not unreasonably be withheld.
(b) The Member shall inform the Board about the Member’s request for paid vacation by completing the vacation schedule form provided by the Board.
(c) If more than one (1) Member in a work location or department requests the same vacation time off, then, the most senior Member shall be granted the first choice the initial year after ratification of this Agreement. Thereafter, vacation time shall be on a rotation basis beginning with the next most senior Member having first choice.
(d) The choice of vacation time by seniority referred to in clause 41.4 (b) is to be implemented only when a problem may occur in a department whereby two or more Members have chosen the same vacation period and it is necessary that one of those Members must be available to maintain the efficient operation of the department.
(e) There will be a minimum of two (2) Members in a Composite Secondary School Office at all times.
41.5 (a) A ten (10) or twelve (12) month Member working in elementary schools shall take their vacation during regular scheduled breaks. This provision will also apply to ten (10) month Members working in Instructional Services and Media Services.
Vacations and Sick Leave The Executive shall be entitled to paid annual vacation leave in accordance with the policies as established from time to time by the Board of Directors, which shall in no event be less than four weeks per annum. The Executive shall also be entitled to an annual sick leave benefit as established by the Board for senior management employees of the Bank. The Executive shall not be entitled to receive any additional compensation from the Bank for failure to take a vacation or sick leave, nor shall he be able to accumulate unused vacation or sick leave from one year to the next; provided, however, such Executive may carry forward from year to year a maximum of ten days of unused vacation leave.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
General Exceptions For purposes of Chapter 2 (National Treatment and Market Access for Goods), Chapter 3 (Rules of Origin and Operational Procedures Related to Origin), Chapter 4 (Customs Procedures and Trade Facilitation), Chapter 5 (Trade Remedies), Chapter 6 (Sanitary and Phytosanitary Measures), Chapter 7 (Technical Barriers to Trade), Article XX of the GATT 1994 and its interpretative notes are incorporated into and made part of this Agreement, mutatis mutandis. The Parties understand that the measures referred to in Article XX(b) of the GATT 1994, as incorporated into this Agreement, can include any measure necessary to protect human, animal, or plant life or health, and that Article XX(g) of the GATT 1994 applies to measures relating to the conservation of any exhaustible natural resource.
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:
i. Prohibiting the use of all forms of tobacco products, including but not limited to cigarettes, cigars, pipes, water pipes (hookah), bidis, kreteks, electronic cigarettes, smokeless tobacco, snuff and chewing tobacco;
ii. Designating the property to which this Policy applies as a "designated area,” which must at least comprise all buildings and structures where activities funded under this Grant Agreement are taking place, as well as Grantee owned, leased, or controlled sidewalks, parking lots, walkways, and attached parking structures immediately adjacent to this designated area;
iii. Applying to all employees and visitors in this designated area; and
iv. Providing for or referring its employees to tobacco use cessation services.
B. If Grantee cannot meet these minimum standards, it must obtain a waiver from the System Agency.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift.
9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon.
9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee.
9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided.
9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months.
9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire.
9.07 Adequate time will be allowed prior to quitting time for picking up tools.
9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required.
9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived.
(a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required.
(b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change.
(c) All shops shall provide adequate clean-up facilities.
9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement.
9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union.
9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job.
9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions.
9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
ANNUAL VACATIONS 15.01 Employees shall be entitled to an annual vacation after one (1) year of employment with pay, calculated as follows:
(a) 3/52nds of the earnings of that year of service after one (1) year and each subsequent year thereafter, up to and including five (5) completed years of service;
(b) 4/52nds of the earnings for the year commencing after five (5) completed years of service and each subsequent year thereafter, up to ten (10) completed years of service;
(c) 5/52nds of the earnings after ten (10) completed years of service and each subsequent year thereafter.
15.02 For other than full-time employees, all vacation pay will be paid to employees on December 15th in each year unless the employee requests vacation pay when a holiday is taken. In such circumstances, the employee will receive vacation pay requested at that time or a portion of the payment at that time and the balance on December 15th. Part-time employees will be allowed to make two (2) such requests per year based on earnings to June 30th. Full-time employees will receive vacation pay when they take their vacation.
15.03 Employees who are hospitalized or make use of compassionate leave during their vacation period shall be credited with extra vacation time equivalent to the time used.
15.04 Vacations cannot be accumulated from one year to another.
15.05 When a statutory holiday occurs during an employee’s vacation, an extra day’s vacation shall be granted if the holiday is one for which the employee would have received pay if he/she had been working.
15.06 If the employment of an employee is terminated, the Employer shall pay him/her for any vacation time he/she has earned.
15.07 A vacation list shall be submitted to the employees requesting them to indicate their preference as to vacation dates. Both parties agree, however, that the vacation schedule must be practical insofar as the operation of the business is concerned and therefore the Employer is able to make a final decision as to how many and which employees would be able to take vacation at any particular time. Seniority shall prevail in the event of a conflict of vacation requests between employees.
