Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract.
b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
ELECTRICAL SERVICES The Company must construct and reticulate electrical requirements for all amenities and facilities. The Company must construct sub-station and distribution boards necessary to reticulate power to all Company owned or leased facilities which provide amenities to the public. The electrical installation must be to the design and installation standards of the State Energy Commission of Western Australia. All electrical reticulation must be placed underground.
Nonpayment and Procedures for Disconnection 12.1 If a Party is furnished Interconnection Services under the terms of this Agreement in more than one (1) state, Section 12.2 below through Section 12.19 below, inclusive, shall be applied separately for each such state.
12.2 Failure to pay charges shall be grounds for disconnection of Interconnection Services furnished under this Agreement. If a Party fails to pay any charges billed to it under this Agreement, including but not limited to any Late Payment Charges or Unpaid Charges, and any portion of such Unpaid Charges remain unpaid after the Bill Due Date, the Billing Party will send a Discontinuance Notice to such Non-Paying Party. The Non-Paying Party must remit all Unpaid Charges to the Billing Party within fifteen (15) calendar days of the Discontinuance Notice.
12.3 AT&T-21STATE will also provide any written notification to any Commission as required by any State Order or Rule.
12.4 If the Non-Paying Party desires to dispute any portion of the Unpaid Charges, the Non-Paying Party must complete all of the following actions not later than fifteen (15) calendar days following receipt of the Billing Party’s notice of Unpaid Charges:
12.4.1 notify the Billing Party in writing which portion(s) of the Unpaid Charges it disputes, including the total Disputed Amounts and the specific details listed in Section 13.4 below of this Agreement, together with the reasons for its dispute; and
12.4.2 pay all undisputed Unpaid Charges to the Billing Party; and
12.4.3 pay all Disputed Amounts (other than Disputed Amounts arising from Intercarrier Compensation) into an interest bearing escrow account that complies with the requirements set forth in Section 11.10 above; and
12.4.4 furnish written evidence to the Billing Party that the Non-Paying Party has established an interest bearing escrow account that complies with all of the terms set forth in Section 11.10 above and deposited a sum equal to the Disputed Amounts into that account (other than Disputed Amounts arising from Intercarrier Compensation). Until evidence that the full amount of the Disputed Charges (other than Disputed Amounts arising from Intercarrier Compensation) has been deposited into an escrow account that complies with Section
Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts.
System Logging The system must maintain an automated audit trail which can 20 identify the user or system process which initiates a request for PHI COUNTY discloses to 21 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY, 22 or which alters such PHI. The audit trail must be date and time stamped, must log both successful and 23 failed accesses, must be read only, and must be restricted to authorized users. If such PHI is stored in a 24 database, database logging functionality must be enabled. Audit trail data must be archived for at least 3 25 years after occurrence.
Dispatching 1. Dispatchers will schedule and assign drivers and vehicles in accordance with the trips scheduled for each day;
2. Dispatchers will assist drivers while they are in service to carry out the assigned trips on time by providing address assistance and telephoning passengers as needed.
3. Dispatchers will monitor the performance of scheduled trips, reassigning trips and/or adjusting the number of vehicles in service as needed to ensure on-time performance in the most efficient manner.
4. Dispatchers will provide continuous monitoring of assigned radio frequencies during all hours that vehicles are in service, answer and respond to telephone calls on the Ride Status line, and respond to calls from drivers and OoA staff.
Food Service Waste Reduction Requirements Contractor shall comply with the Food Service Waste Reduction Ordinance, as set forth in San Francisco Environment Code Chapter 16, including but not limited to the remedies for noncompliance provided therein.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Freedom has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Freedom. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Freedom (e.g. hairpinning):
1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises.
2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated.
3. If capacity exists, provide "side-door" porting through the switch.
4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch).
2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases.
2.6.3 If no alternate facility is available, and upon request from Freedom, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Freedom will then have the option of paying the one-time SC rates to place the Loop.
COMPLAINTS HANDLING 44.1 Either Party shall notify the other Party of any Complaints made by Other Contracting Bodies, which are not resolved by operation of the Supplier's usual complaints handling procedure within five (5) Working Days of becoming aware of that Complaint and, if the Supplier is the Party providing the notice, such notice shall contain full details of the Supplier's plans to resolve such Complaint.
44.2 Without prejudice to any rights and remedies that a complainant may have at Law (including under this Framework Agreement and/or a Call Off Agreement), and without prejudice to any obligation of the Supplier to take remedial action under the provisions of this Framework Agreement and/or a Call Off Agreement, the Supplier shall use its all reasonable endeavours to resolve the Complaint within ten (10) Working Days and in so doing, shall deal with the Complaint fully, expeditiously and fairly.
44.3 Within two (2) Working Days of a request by the Authority, the Supplier shall provide full details of a Complaint to the Authority, including details of steps taken to achieve its resolution.