HEAVY EQUIPMENT REQUIREMENTS Sample Clauses

HEAVY EQUIPMENT REQUIREMENTS. The following shall be considered minimum requirements for the Heavy Equipment offered for Rental. The Authorized Users shall include supplemental required specifications in the Rental Quote Requests.
AutoNDA by SimpleDocs
HEAVY EQUIPMENT REQUIREMENTS. The following shall be considered minimum requirements for the Heavy Equipment offered for Rental. The Authorized Users shall include supplemental required specifications in the Rental Quote Requests. A. Standards, Codes, Rules and Regulations: Heavy Equipment shall comply with all applicable governmental statutes, regulations, and directives including, but not limited to, those listed below. If applicable, the appropriate decals indicating compliance shall be affixed to the Heavy Equipment. 1. New York Codes, Rules and Regulations (NYCRR), New York State Vehicle and Traffic Law (NYSVTL), and New York State Dept. of Motor Vehicles (NYSDMV). 2. Federal Motor Vehicle Safety Standards (FMVSS), Federal Motor Carrier Safety Administration (FMCSA), National Highway Traffic and Safety (NHTSA), Environmental Protection Agency (EPA), and Occupational Safety & Health Administration (OSHA) requirements. 3. Federal Government and New York State regulations governing the control of air pollution from new motor vehicles and new motor vehicle engines in effect on the date of manufacture. See NYCRR (NY Codes Rules and Regulations), Title 6 Environmental Conservation, Part 218, Emissions Standards for Motor Vehicles and Motor Vehicle Engines.

Related to HEAVY EQUIPMENT REQUIREMENTS

  • Equipment Requirements No Equipment is provided to Customer as part of this Service.

  • Project Requirements 1. Project must conform to regulations under 24 CFR Part 92, commonly known as the HOME Regulations.

  • Payment Requirements ‌ A. Contract Amount: It is expressly agreed and understood that the total amount to be paid by County under this Contract shall not exceed the total County funding as set forth in Attachment B-Payment/Compensation to Subrecipient attached hereto and incorporated herein by reference. B. County will reclaim any unused balance of funds for reallocation to other County approved projects.

  • Agreement Requirements This agreement will be issued to cover the Janitorial Service requirements for all State Agencies and shall be accessible to any School District, Political Subdivision, or Volunteer Fire Company.

  • Safety Equipment Should the employment duties of an employee in the bargaining unit require use of any equipment or gear to insure the safety of the employee or others, the District agrees to furnish such equipment or gear.

  • Minimum Balance Requirements To be a member and maintain Accounts with Us You must purchase 1 share in the Credit Union. The par value of a share in this Credit Union is $5.00. If the balance in Your primary share Account drops below 1 share ($5.00), at any time, We may, at Our option, close Your Account. Nonsufficient Funds Returns. Any share draft or pre-authorized transfer, or transaction made through the use of a debit card, or other electronic means, as is applicable (including any in-person transaction), that is presented to Us for payment on Your Account when Your Account lacks sufficient collected funds to pay any such item may, at Our option, be returned for nonsufficient funds or We may honor any such item and charge You a fee for doing so. Overdraft Balance Calculation. When processing transactions that debit or credit Your Account, We start each Business Day with Your final Account balance from the preceding Business Day. The final balance takes into account all of the debit and credit transactions that were settled that Business Day pursuant to Our Funds Availability Policy, as well as any other debits or credits to Your Account that were finally settled that day, as described above in the "Deposit of Items" and "Collection and Processing of Items" sections of the Account Agreement. This starting balance at the beginning of a Business Day (the preceding Business Day's final balance) is sometimes referred to as Your "actual balance."

  • CONTRACT REQUIREMENTS A. Project area boundaries are marked with two blue paint slashes and block boundaries are designated with one blue paint slash. B. All blocks are accessible by foot only. Xxxxxx’x Creek must be crossed on foot from the PGC railroad grade. C. Block 1, All trees 1” DBH and over, except for red and blue paint marked trees are to be cut. All conifers are reserved. Block 1 will be cut during the dormant season; October 15 through March 15. D. Block 2, All American beech, sweet birch, aspen, stripped maple, and ironwood 1” DBH and greater will be cut. All yellow marked trees will be cut. Block 2 will be cut during the dormant season; October 15 through March 15. E. Block 3, All trees 1” DBH and over, except for red and blue paint marked trees are to be cut. All conifers are reserved. Block 3 will be cut during the dormant season; October 15 through March 15. F. All employees must be able to identify species. G. Usable material may not be removed from site. X. Xxxxx material felled with clean cuts must have stumps that are parallel to the ground surface and shall not exceed six (6) inches in height measured on the side next to the highest ground or the diameter of the xxxxx, whichever is smaller, except when in the opinion of the Field Contract Coordinator, said height is impractical. I. Cut trees must be removed from trails, roads, tail drains, streams, and utility rights-of- way. J. All trees shall be felled so tops do not pile on one another but lie singly on the ground. K. Slash shall be lopped to no higher than 4’ and pulled apart as directed by the Regional Forester. L. Operator shall exercise care and caution in all operations to prevent damage to all trees not specified for treatment. M. All tops must be pulled back 25 feet from the State Game Land boundary, (blazed & painted white), all roads, parking lots, herbaceous openings, utility Right of Ways and deer exclosures. Tops, branches, and slash will be removed from all ponds, lakes, and streams. N. Damage to trails, roads, streams, or utility rights-of-way caused by the Operator’s equipment must be repaired by the Operator at their expense. O. Any trash resulting from the Operator’s operations must be removed from the area and properly disposed. P. The Operator shall not block any roads or trails in the area during performance of this contract. The Operator shall not in any way hinder the progress of any Timber Sale Contracts in these areas. Q. All labor, equipment, tools, etc., needed to complete contracted projects are to be provided by the Operator. R. Timber Damages – when in the opinion of Field Contract Coordinator, damage to the residual stand becomes excessive, the Operator shall pay the Commission a fair base current value determined by the Field Contract Coordinator per unit of volume. If this value for damage due to Operator’s carelessness or negligence is less than $10.00 per tree, then a minimum charge of $10.00 per tree will be made whether the tree is commercial, non-commercial, merchantable, or non-merchantable.

  • Subcontract Requirements As required by Section 6.22(e)(5) of the Administrative Code, Contractor shall insert in every subcontract or other arrangement, which it may make for the performance of Covered Services under this Agreement, a provision that said subcontractor shall pay to all persons performing labor in connection with Covered Services under said subcontract or other arrangement not less than the highest general prevailing rate of wages as fixed and determined by the Board of Supervisors for such labor or services.

  • Minimum Vendor License Requirements Vendor shall maintain, in current status, all federal, state, and local licenses, bonds and permits required for the operation of the business conducted by Vendor. Vendor shall remain fully informed of and in compliance with all ordinances and regulations pertaining to the lawful provision of goods or services under the TIPS Agreement. TIPS and TIPS Members reserve the right to stop work and/or cancel a TIPS Sale or terminate this or any TIPS Sale Supplemental Agreement involving Vendor if Vendor’s license(s) required to perform under this Agreement or under the specific TIPS Sale have expired, lapsed, are suspended or terminated subject to a 30‐day cure period unless prohibited by applicable statue or regulation.

  • REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!