HSE Requirements Sample Clauses

HSE Requirements a.) Purchaser shall take necessary measures to prevent health hazards and risk of injury or damage on any Purchaser premises or sites as required by applicable laws or as set out as XxXxxxxxx’x minimum HSE requirements below and shall provide XxXxxxxxx sufficient access to such premises or sites as required for work under the Contract. XxXxxxxxx shall comply with all reasonable safety, induction and other site regulations provided to XxXxxxxxx prior to its representatives entering such premises or sites. b.) XxXxxxxxx’x minimum HSE requirements include radiation levels not exceeding 0.4 uSv/h, safe transportation, safe working conditions at heights, use of proper safety devices and personnel protective clothing, strict avoidance of asbestos, chemical and toxic exposure, relevant sorting, recovery, treatment and handling of electronic, electrical and other waste, chemicals and hazardous substances, and compliance with all registration and reporting obligations. Failure to comply with XxXxxxxxx’x minimum HSE requirements shall be a material default for the purpose of clause 21.
Sample 1Sample 2See All (5)
AutoNDA by SimpleDocs
HSE Requirements a.) Purchaser shall take necessary measures to prevent health hazards and risk of injury or damage on any Purchaser premises or sites as required by applicable laws or as set out as McCloskey’s minimum HSE requirements below and shall provide XxXxxxxxx sufficient access to such premises or sites as required for work under the Contract. XxXxxxxxx shall comply with all reasonable safety, induction and other site regulations provided to XxXxxxxxx prior to its representatives entering such premises or sites. b.) McCloskey’s minimum HSE requirements include radiation levels not exceeding 0.4 uSv/h, safe transportation, safe working conditions at heights, use of proper safety devices and personnel protective clothing, strict avoidance of asbestos, chemical and toxic exposure, relevant sorting, recovery, treatment and handling of electronic, electrical and other waste, chemicals and hazardous substances, and compliance with all registration and reporting obligations. Failure to comply with McCloskey’s minimum HSE requirements shall be a material default for the purpose of clause 21.
Sample 1Sample 2See All (4)
HSE Requirements a.) Purchaser shall take necessary measures to prevent health hazards and risk of injury or damage on any Purchaser premises or sites as required by applicable laws or as set out as Lippmann’s minimum HSE requirements below and shall provide Lippmann sufficient access to such premises or sites as required for work under the Contract. Lippmann shall comply with all reasonable safety, induction and other site regulations provided to Lippmann prior to its representatives entering such premises or sites. b.) Lippmann’s minimum HSE requirements include radiation levels not exceeding
Sample 1Sample 2Sample 3
HSE Requirements a.) Purchaser shall take necessary measures to prevent health hazards and risk of injury or damage on any Purchaser premises or sites as required by applicable laws or as set out as Lippmann’s minimum HSE requirements below and shall provide Lippmann sufficient access to such premises or sites as required for work under the Contract. Lippmann shall comply with all reasonable safety, induction and other site regulations provided to Lippmann prior to its representatives entering such premises or sites. b.) Lippmann’s minimum HSE requirements include radiation levels not exceeding 0.4 uSv/h, safe transportation, safe working conditions at heights, use of proper safety devices and personnel protective clothing, strict avoidance of asbestos, chemical and toxic exposure, relevant sorting, recovery, treatment and handling of electronic, electrical and other waste, chemicals and hazardous substances, and compliance with all registration and reporting obligations. Failure to comply with Xxxxxxxx’x minimum HSE requirements shall be a material default for the purpose of clause 21.
Sample 1Sample 2
HSE Requirements. 16.1 You must ensure that you have prepared, submitted and obtained our approval in relation to a risk assessment completed by you in the form required by us (Risk Assessment), prior to accessing the Site or commencing the Services. 16.2 Any approval of a Risk Assessment may be subject to site- specific conditions in our absolute discretion. 16.3 You must, and must ensure that your Personnel, adhere to any site-specific permits, procedures, conditions noted on Risk Assessments and other reasonable WHSE requirements notified to you. 16.4 You must ensure that any Supplier Equipment used in the performance of the Services complies with all Legislative Requirements. 16.5 You must ensure that all of your Personnel hold any relevant industry safety training card (blue card/white card) and are equipped at all times with the following personal protective equipment, prior to commencement of the Services: safety helmet; safety footwear; hi-vis vest; safety glasses; long sleeved shirt and long trousers; and any other Site-specific requirement that we communicate to you.
Sample 1
HSE Requirements. Spark will comply and shall use reasonable efforts to cause its cause its Approved Subcontractors to comply with the HSE requirements set forth in this Agreement including without limitation (i) any applicable Law in the United States relating to HSE protection; and (ii) any terms of the Quality Agreement relating to HSE (collectively, the “HSE Requirements”).
Sample 1
HSE Requirements a.) Purchaser shall take necessary measures to prevent health hazards and risk of injury or damage on any Purchaser premises or sites as required by applicable laws or as set out as Metso’s minimum HSE requirements below and shall provide Metso sufficient access to such premises or sites as required for work under the Contract. Metso shall comply with all reasonable safety, induction and other site regulations provided to Metso prior to its representatives entering such premises or sites. b.) Metso’s minimum HSE requirements include radiation levels not exceeding 0.4 uSv/h, safe transportation, safe working conditions at heights, use of proper safety devices and personnel protective clothing, strict avoidance of asbestos, chemical and toxic exposure, relevant sorting, recovery, treatment and handling of electronic, electrical and other waste, chemicals and hazardous substances, and compliance with all registration and reporting obligations. Failure to comply with Metso’s minimum HSE requirements shall be a material default for the purpose of clause 21.
Sample 1
AutoNDA by SimpleDocs
HSE Requirements. SUPPLIER shall fully comply (and shall cause its Approved Subcontractors and suppliers to fully comply) with the HSE Requirements set forth in this Agreement, including without limitation (i) any Applicable Standards relating to HSE protection (including REACH (Regulation (EC) No. 1907/2006)); (ii) any terms of the Quality Agreement relating to HSE; and (iii) ANNEX 8 (collectively, the “HSE Requirements”).
Sample 1
HSE Requirements. CBMG China shall fully comply (and shall cause its Approved Subcontractors and Suppliers to fully comply) with the HSE requirements set forth in this Agreement including without limitation (i) any Applicable Standards relating to HSE protection (including REACH (Regulation (EC) No. 1907/2006)); (ii) any terms of the Quality Agreement relating to HSE; and (iii) ANNEX 6 (collectively, the “HSE Requirements”). Failure to comply with the HSE Requirements will constitute a material breach of this Agreement.
Sample 1

Related to HSE Requirements

  • Time Requirements The Independent Contractor will not be required to follow or establish a regular or daily work schedule, but shall devote during the term of this Agreement the time, energy and skill as necessary to perform the services of this engagement and shall, periodically or at any time upon the request of the Company, submit information as to the amount of time worked and scope of work performed.

  • License Requirements The Hotel’s alcoholic beverage license requires that the Hotel shall: (i) request proper identification (photo ID) of any person of questionable age and refuse alcoholic beverage service if the person is either under age or proper identification cannot be produced, and (ii) refuse alcoholic beverage service to any person who, in the Hotel’s judgment, appears to be intoxicated; and (iii) instruct its personnel to avoid encouraging patrons to consume alcoholic beverages (commonly referred to as “over-pouring”).

  • Check Requirements Any image of a check that I transmit to you must accurately and legibly provide all the information on the front and back of the check at the time presented to me by the drawer. Prior to capturing the original check, I will indorse the back of the original check. My endorsement will include "For Directions E- Deposit Only" in addition to my signature. The image of the check transmitted to you must accurately and legibly provide, among other things, the following information: (1) the information identifying the drawer and the paying bank that is preprinted on the check, including complete and accurate MICR information and the signature(s); and (2) other information placed on the check prior to the time an image of the check is captured, such as any required identification written on the front of the check and any endorsements applied to the back of the check. The image quality for the check will meet the standards for image quality established by the American National Standards Institute ("ANSI"), the Board of Governors of the Federal Reserve, and any other regulatory agency, clearing house or association. Rejection of Deposit. You are not liable for any service or late charges levied against me due to your rejection of any item. In all cases, I am responsible for any loss or overdraft plus any applicable fees to my Account due to an item being returned. Items Returned Unpaid. A written notice will be sent to me of transactions you are unable to process because of returned items. With respect to any item that I transmit to you for remote deposit that you credit to my Account, in the event such item is dishonored, I authorize you to debit the amount of such item from the Account.

  • Work Requirements The following Partner(s) is/are required to work for the Partnership: (choose one) ☐ - No Partners. No Partners are required to work for the Partnership. ☐ - Specific Partners. The following Partner(s) are required to work for the Partnership: [PARTNER(S')] NAME(S)]. Compensation, if any, shall be agreed to in a separate document.

  • Basic Requirements To be eligible for PayPal’s Seller Protection program, all of the following basic requirements must be met, as well as any applicable additional requirements: • The primary address for your PayPal account must be in the United States. • The item must be a physical, tangible good that can be shipped, except for items subject to the Intangible Goods Additional Requirements. Transactions involving items that you deliver in person in connection with payment made in your physical store, may also be eligible for PayPal’s Seller Protection program so long as the buyer paid for the transaction in person by using a PayPal goods and services QR code. • You must ship the item to the shipping address on the Transaction Details page in your PayPal account for the transaction. If you originally ship the item to the recipient’s shipping address on the Transaction Details page but the item is later redirected to a different address, you will not be eligible for PayPal’s Seller Protection program. We therefore recommend not using a shipping service that is arranged by the buyer, so that you will be able to provide valid proof of shipping and delivery. • The shipping requirement does not apply to eligible transactions involving items that you deliver in person; provided, however, that you agree to provide us with alternative evidence of delivery or such additional documentation or information relating to the transaction that we may request. • You must respond to PayPal’s requests for documentation and other information in a timely manner as requested in our email correspondence with you or in our correspondence with you through the Resolution Center. If you do not respond to PayPal’s request for documentation and other information in the time requested, you may not be eligible for PayPal’s Seller Protection program. • If the sale involves pre-ordered or made-to-order goods, you must ship within the timeframe you specified in the listing. Otherwise, it is recommended that you ship all items within 7 days after receipt of payment. • You provide us with valid proof of shipment or delivery. • The payment must be marked “eligible” or “partially eligible” in the case of Unauthorized Transaction claims, or “eligible” in the case of Item Not Received claims, for PayPal’s Seller Protection program on the Transaction Details page. • In the case of an Unauthorized Transaction claim, you must provide valid proof of shipment or proof of delivery that demonstrates that the item was shipped or provided to the buyer no later than two days after PayPal notified you of the dispute or reversal. For example, if PayPal notifies you of an Unauthorized Transaction claim on September 1, the valid proof of shipment must indicate that the item was shipped to the buyer no later than September 3 to be eligible for PayPal’s Seller Protection program. PayPal determines, in its sole discretion, whether your claim is eligible for PayPal’s Seller Protection program. PayPal will make a decision, in its sole discretion, based on the eligibility requirements, any information or documentation provided during the resolution process, or any other information PayPal deems relevant and appropriate under the circumstances. To be eligible for PayPal’s Seller Protection program for a buyer’s Item Not Received claim, you must meet both the basic requirements and the additional requirements listed below: • Where a buyer files a chargeback with the issuer for a card-funded transaction, the payment must be marked “eligible” for PayPal’s Seller Protection on the Transaction Details page. • You must provide proof of delivery as described below.

  • Specific Requirements compensation insurance with statutory limits required by South Dakota law. Coverage B-Employer’s Liability coverage of not less than $500,000 each accident, $500,000 disease-policy limit, and $500,000 disease-each employee.

  • Overtime requirements No contractor or subcontractor contracting for any part of the contract work which may require or involve the employment of laborers or mechanics shall require or permit any such laborer or mechanic in any workweek in which he or she is employed on such work to work in excess of forty hours in such workweek unless such laborer or mechanic receives compensation at a rate not less than one and one-half times the basic rate of pay for all hours worked in excess of forty hours in such workweek.

  • Service Requirements Grantee shall:

  • Interface Requirements 2.4.5.1 The NID shall be equal to or better than all of the requirements for NIDs set forth in the applicable industry standard technical references.

  • Vehicle Requirements The following shall be considered minimum Vehicle requirements. The Authorized User shall include supplemental required specifications for Vehicles specified in a Mini-Bid. Unless otherwise indicated, all items specified which are listed on the OEM Pricelist as standard or optional equipment shall be factory installed and operative. Vehicles delivered to an Authorized User in a condition considered to be below retail customer acceptance levels will not be accepted. Items which determine this acceptance level shall include, but not be limited to, the general appearance of the interior and exterior of the vehicle for completeness and quality of workmanship, lubrication and fluid levels, with any leaks corrected, mechanical operation of the vehicle and all electrical components operational. Product specified to be furnished and installed which is not available through the OEM shall conform to the standards known to that particular industry, both product and installation.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!