Installation and Dismantling. The specific requirements as to time for installation and dismantling of exhibits shall be sup- plied to Exhibitor. Such requirements shall be binding upon the Exhibitor as though fully set forth herein. All displays must be in place and set up at least one hour prior to the official opening of the Exposition Facility. Space not occupied by that time may be re-assigned for other purposes by MBA. If the booth is not set up during official installation hours, MBA will instruct the exhibit company to set the booth and this cost will be charged to the Exhibitor. No Exhibitor will be permitted to dismantle a booth prior to the official close of the show.
Installation and Dismantling. Complete information, instructions and schedule of prices regarding drayage, labor for erecting and dismantling, electrical work, furniture, cleaning etc., will be included in the Exhibitor Service Manual. Such requirements shall be binding upon the Exhibitor as though fully set forth herein.
Installation and Dismantling. Exhibitor explicitly agrees that, in the event Exhibitor fails to install products in assigned space or fails to remit payment for required space rental prior to move in date, CII shall have the right to take possession of said space and lease same to such parties and upon such terms that it may deem proper. All displays must be fully set up prior to the opening of the Event, and all exhibits must be open for business during all Event hours. In addition, the Exhibitor may not dismantle the display until the Event closes according to the time and date specified by CII. When vacated, all exhibit space shall be left in good order. Early Break-Down: available upon request, CII will assign a pre-determined time to break-down to mitigate risk of injuries. Exhibitors that break-down prior to this pre-determined time will pay an early break-down penalty fee of $500 to CII.
Installation and Dismantling. The specific requirements as to time for installation and dismantling of exhibits shall be supplied to each exhibitor. Such requirements shall be binding. All displays must be in place and set up by the time of the official opening of the show. Space not occupied or set up by that time may be reassigned for other purposes. No exhibits shall be dismantled before the official closing time of the show. The exhibitor must comply with all union regulations applicable to installation/dismantle and display of exhibits.
Installation and Dismantling. All displays must be set up prior to the official opening of the show. Space not occupied or set up by 8:00 am Wednesday, January 17, 2024 may be reassigned for other purposes. Exhibitors may not change assigned space. Show man- agement reserves the right to substitute comparable exhibit space due to unforeseen circumstances. Exhibitors may not break down prior to 2:00 pm on Thursday, January 18, 2024. Early dismantling will be subject to a $500 fine.
Installation and Dismantling. If Exhibitor fails to set up its display in its assigned space by 8 am Thursday, Sept. 27, 2012, leaves its space unattended, or fails to remit payment at times specified, GCSCS shall have the right to take possession of the space and utilize such space in any manner GCSCS chooses. Exhibitor may not dismantle the display until the Exhibition is finally closed to the public, at the date and time indicated by GCSCS.
Installation and Dismantling. Information on installation and dismantling of exhibits will be sent to the Exhibitor. Exhibitor agrees to abide by the schedule for set-up and teardown as outlined above. Exhibitor shall be liable for monetary damages caused to MEC as result of its delay. No exhibitor shall remove any part of its booth’s display until the Expo is officially closed. Exhibitors shall be responsible for any expenses incurred by MEC caused by their delay in removing its equipment. Exhibitors must not injure or deface property, including but not limited to, the property of MEC, AASP/NJ and other exhibitors. Should exhibitor cause any property damage, the exhibitor will be solely liable to the damaged party.
Installation and Dismantling. All exhibitors will keep the exhibit space open and staffed at all times during trade show hours. NO EXHIBITOR MAY START DISMANTLING PRIOR TO CLOSE OF SHOW. Individual displays must not block view or intrude on space of neighboring booths. ECBCC reserves the right to restrict noise levels or music, PA systems, speakers, smoke or other distracting agents. If complaints continue after warning by Committee, exhibitor will be required to turn off distracting agents.
Installation and Dismantling. Move in will be on Thurs., Feb, 4, 2021, 8am - 5pm. Booths must be fully completed by Thurs., Feb, 4, 2021, at which time there will be an inspection by Show Management. Removal and storage of crates will be at the Exhibitor’s expense. Exhibitors will be required to accept delivery of all incoming shipments within the confines of their own booths. Dismantling will start only after the close of the show on Friday, Feb. 5,2021 and end at 11 pm. Failure to remove an exhibit in the allotted time will afford the Management the right to remove same and place in a warehouse subject to the Exhibitor’s disposition, with all charges to follow, and at no liability to the Management.
Installation and Dismantling. If Exhibitor fails to set up its display in its assigned space by 8:30 am, leaves its space unattended, or fails to remit payment at times specified, TGE shall have the right to take possession of the space and utilize such space in any manner TGE chooses. Exhibitor may not dismantle the display until the Exhibition is finally closed to the public, at the time indicated by TGE.
