Seat. Except in the case of tests on restraint systems, the seat shall be of rigid construction and present a smooth surface. The particulars given in Figure 1 of this annex shall be respected, care being taken that no metal part can come into contact with the belt.
Seat. 1. The seat of the Academy shall be located in Laxenburg, Austria, under such terms and conditions as agreed between the Academy and the Republic of Austria.
2. The Academy may establish facilities in other locations as required to support its activities.
Seat. (1) The Seat of the Academy shall comprise the land, installations and offices that the Academy occupies for its activities. Its area shall be defined by common understanding between ICPO-Interpol and the Government of the Republic of Austria.
(2) All office and conference premises in Austria used with the agreement of the Government for meetings convened by the Academy shall be deemed temporarily to form part of the Seat.
Seat. (a) The seat of the Partnership will be located in Amsterdam, The Netherlands. To the extent necessary, the parties declare that when the Partnership was formed, the center of its external activities (centrum van optreden naar buiten) was located in the Netherlands.
(b) The address of the Partnership and of the General Partner shall be Xxxxx 00, 0000 XX Xxxxxxxxx, Xxx Xxxxxxxxxxx, or such other place in The Netherlands as the General Partner shall determine in its discretion. If the General Partner shall determine to change its business address, it shall notify the Limited Partners in advance in writing.
Seat. 1) The Seat area shall be defined by common understanding between the Centre and the Government of the Republic of Austria.
2) All office and conference premises in Austria used with the agreement of the Government for meetings convened by the Centre shall be deemed temporarily to form part of the Seat.
Seat. 1. The Seat of the Organization shall be determined by the Governing Council, subject to the consent of the Member concerned.
2. The Host Government shall provide free of charge or at a nominal rent, such accommodation and facilities as are necessary for the efficient conduct of work at the Seat of the Organization.
3. If necessary, the Governing Council may establish subsidiary offices, subject to the consent of the Members concerned; in so doing account should be taken of the possibility of utilizing accommodation in existing centres.
Seat. 1. The Seat of the Agency shall comprise the land, installations and offices that the Agency occupies for its activities. Its area shall be defined by common understanding between the Government of the Republic of Austria and the Agency.
2. Any building in or outside Vienna used with the agreement of the Government for meetings convened by the Agency shall be deemed temporarily to form part of the seat precinct.
Seat. 3.1. The seat shall be constructed as follows:
3.1.1. A rigid back, fixed, dimensions of which are given in appendix 1 to this annex. The lower part and the upper part is made of a 20 mm diameter tube;
3.1.2. Rigid seating, dimensions of which are given in appendix 1 to this annex. The rear part of the seating is made from a rigid sheet metal, the upper edge of which is a 20 mm diameter tube. The front part of the seating is also made of a 20 mm diameter tube;
3.1.3. For access to the anchor brackets, openings shall be made at the rear of the cushion of the seat, as prescribed in appendix 1 to this annex;
3.1.4. The width of the seat shall be 800 mm;
3.1.5. The back and the seating shall be covered with polyurethane foam, the characteristics of which are given in Table 1. The dimensions of the cushion are given in appendix 1 to this annex; Annex 6 Density according to ISO 485 (kg/m3) Bearing strength according to ISO 2439B (N) 43 p - 25% 125 p - 40% 155 Bearing strength factor according to ISO 3386 (kPa) 4 Elongation at rupture according to ISO 1798 (%) 180 Breaking strength according to ISO 1798 (kPa) 100 Compression set according to ISO 1856 (%) 3
3.1.6. The polyurethane foam shall be covered with a sun shade cloth, made of poly-acrylate fibre, the characteristics of which are given in Table 2. 290 Specific mass (g/m2) Breaking strength according to DIN 53587 on test specimen 50 mm wide: lengthwise (kg): breadthwise (kg):
3.1.7. Covering the seat and the seat back 1/
3.1.7.1. The seat foam cushion is produced out of a square foam block (800 x 575 x 135 mm) in such a way (see Figure 1 of appendix 1 to this annex) that its shape resembles the shape of the aluminium bottom-plate specified in Figure 2 of appendix 1 to this annex.
3.1.7.2. Six holes are drilled in the bottom-plate in order to fasten it to the trolley with bolts. The holes are drilled alongside the longest side of the plate, three on each side, their position being dependent on the construction of the trolley. Six bolts are put through the holes. It is recommended to glue the bolts on the plate with an appropriate adhesive. Afterwards, the bolts are fastened with nuts. __________________
3.1.7.3. The cover material (1250 x 1200 mm, see Figure 3 of appendix 1 to this annex) is cut across the width in such a way that it is not possible for the material to overlap after covering. There should be a gap of about 100 mm between the edges of the cover material. Therefore the material has to be cut at...
Seat. (1) The seat of the Office shall comprise the land, installations and offices that the Office occupies for its activities. Its area shall be defined by common understanding between the Organizations and the Government of the Republic of Austria.
(2) Any building in or outside Vienna used with the agreement of the Government for meetings convened by the Office shall be deemed temporarily to form part of the seat precinct.
Seat. (1) The seat of the Secretariat shall comprise the land, installations and offices that the Energy Community occupies for its activities. Its area shall be defined by common understanding between the Energy Community and the Government of the Republic of Austria.
(2) Any building in or outside Vienna used with the agreement of the Government for meetings convened by the Secretariat shall be deemed temporarily to form part of the seat precinct.
