Seniority Tie Breaker The Employer and the Union agree that where there is a tie in seniority between two or more Employees, a determination of seniority shall be made in the following manner:
Seniority Date Employees shall acquire seniority upon completion of the probationary period as defined in Article XIII and upon acquiring seniority, the seniority date shall relate back to the first date of continuous service in the bargaining unit. If more than one employee commences work on the same date, lot shall determine seniority ranking for such employees. A District-Wide seniority list will be provided for the exclusive representative no later than November 1 of each year.
Seniority Frozen When an Agency intends to initiate a layoff, the Agency will notify the Union in writing that all seniority will be frozen from the date of notice for a period not to exceed three (3) months. However, during the period when seniority is frozen, the employee will continue to accumulate time towards seniority for purposes of future computations. The three (3) month freeze may be extended by mutual written agreement of the Union and the Agency.
Seniority Verification Process i. The new school district shall provide the employee with the necessary verification form at the time the employee achieves continuing contract status.
Seniority Dates Upon request, the Employer agrees to make available to the Union the seniority dates of any employees covered by this Agreement. Such seniority dates shall be subject to correction for error on proper representation by the Union.
Seniority Roster The District shall maintain an updated seniority roster, indicating employee's class seniority and hire date seniority. Such rosters shall be available to CSEA.
Seniority Lost Seniority will be lost when an employee:
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Seniority List The Employer shall maintain a seniority list showing the date upon which each employee's service commenced. An up-to-date seniority list shall be sent to the Union and posted on all bulletin boards in January of each year.
Interest Calculation Interest on the outstanding principal balance of the Loan shall be calculated by multiplying (a) the actual number of days elapsed in the period for which the calculation is being made by (b) a daily rate based on a three hundred sixty (360) day year by (c) the outstanding principal balance.
