Downward Reclassification a. When a position is reclassified to another class at the same pay level or to a class that carries a lower salary range, the incumbent trial service or regular employee shall be accorded corresponding status in the new class.
Price Reduction Notwithstanding any other provision set forth in this Warrant, at any time and from time to time during the period that this Warrant is exercisable, the Company in its sole discretion may reduce the Purchase Price or extend the period during which this Warrant is exercisable.
Reduction A. No regular employee or limited-term regular employee shall be reduced to a position in a lower class for reasons of unsatisfactory performance or physical disability except for reasonable cause.
Upward Reclassification When a position is reclassified upward a regular incumbent shall be continued in the position. He/she shall be advanced to the higher class with the same status held in the lower class if he/she meets minimum experience and training requirements. When a position is reclassified upward and the incumbent does not have regular status, the position will be filled competitively at the higher level.
Reduction of Compensation If the Firm fails to meet the submission date by less than thirty days for the draft report and/or working papers submitted to the Office of the State Auditor for review and approval or by less than thirty days from the completion date for the final reports and/or corrections to the working papers prescribed herein, the District may, with the consent of the Office of the State Auditor, reduce the agreed compensation by an amount not to exceed ten percent of the total contract price for the applicable fiscal year. If reports and/or corrections to the working papers are overdue by 30 days or more, the District may reduce, with the consent of the Office of the State Auditor, the agreed compensation by an amount not to exceed twenty percent of the total contract price for the Rev. 10/20 applicable fiscal year.
REDUCTION OF STAFF 34.01 When the Company proposes to terminate (other than for cause) an employee as a result of a decision to reduce the number of Permanent Employees:
Staff Reduction In the event the District adopts a reduced educational program by reason of financial necessity, including but not limited to, levy failure and/or decreased State or Federal support, certificated employees who will be retained to implement the District’s reduced or modified program and those certificated employees who will be non-renewed from employment or adversely affected in contract status shall be identified by the provisions contained in this Article. If the District is only reducing provisional employees, the following procedures do not need to be implemented.
Workforce Adjustment (a) The Parties recognize that workforce adjustment may be necessary due to the elimination of positions resulting from a reduction in the amount of work required to be done by the Commission, reorganization or program termination.
WORKFORCE REDUCTION In the event that funding reductions or shortfalls in funding occur in a department or are expected, which may result in layoffs, the department will notify the union and take the following actions:
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
