Chemical Characteristics Sample Clauses

Chemical Characteristics. No. Properties Test Method Typical Values Specification min Max 10 % Magnesium Chloride PNS 22.4 21.4 23.4 11 % Sodium Chloride PNS - 0.0 1.0 12 % Calcium Chloride PNS - 0.0 1.0 13 % Potassium Chloride PNS - 0.0 1.0 14 Arsenic (ppm) EPA 200.7 <1.0 0.0 5.0 15 Barium (ppm) EPA 200.7 <0.5 0.0 100.0 16 Cadmium (ppm) EPA 200.7 <0.05 0.0 0.2 17 Chromium (ppm) EPA 200.7 <0.5 0.0 1.0 18 Copper (ppm) EPA 200.7 1.3 0.0 4.0 19 Cyanide (ppm) EPA 335.4 <0.05 0.0 0.2 20 Lead (ppm) EPA 200.7 <0.5 0.0 1.0 21 Mercury (ppm) EPA 245.1 <0.02 0.0 0.05 22 Selenium (ppm) EPA 200.7 <1.0 0.0 5.0 23 Zinc (ppm) EPA 200.7 <0.1 0.0 10.0 24 Phosphorus (ppm) EPA 365.4 191.0 0.0 2500.0 PROMELT Magic Minus Zero Effective Date: January 2015 xxx.xxxxxxxxxxxxxxxxx.xxx Submission date: 18 October 2022, 2:43PM Receipt number: 581 Related form version: 17 The requirements herein apply to contracts to be issued by the City of Lincoln, Lancaster County, the Xxxxxxx- Xxxxxxxxx County Public Building Commission, and the West Haymarket Joint Public Agency. For purposes of certificates, endorsements and other proof required herein, only include the entity issuing the contract.
Sample 1
AutoNDA by SimpleDocs
Chemical Characteristics. Product reliability throughout product lifecycle
Sample 1
Chemical Characteristics. 5.1.3.1. The dissolved oxygen concentration shall not at any time be depressed more than 10 percent from that which occurs naturally, as the result of the discharge of oxygen demanding waste materials. 5.1.3.2. The pH shall not be changed at any time more than 0.2 units from that which occurs naturally. 5.1.3.3. The dissolved sulfide concentration of waters in and near sediments shall not be significantly increased above that present under natural conditions. 5.1.3.4. The concentration of substances set forth in chapter II, Table 3 of the Ocean Plan, shall not be increased in marine sediments to levels that would degrade indigenous biota. 5.1.3.5. The concentration of organic materials in marine sediments shall not be increased to levels that would degrade marine life. 5.1.3.6. Nutrient materials shall not cause objectionable aquatic growths or degrade indigenous biota. 5.1.3.7. Numerical water quality objectives established in chapter II, Table 3 of the Ocean Plan shall not be exceeded. Unless otherwise specified, all metal concentrations are expressed as total recoverable concentrations.
Sample 1
Chemical Characteristics. ADC shall neither contain nor constitute Hazardous or Designated Wastes, as determined by laboratory analysis. For inorganic constituents, the classification of “hazardous” is made per criteria listed in the California Code of Regulations, Title 22. The classification of “designated” is made in accordance with the current soluble designated limits established for the YCCL which are included below as Table 1. The County may modify these levels in the future in response to new regulations or other operating considerations. If modifications are made, the Contractor will be provided a copy of the new levels. Table 1: Soluble Designated Limits for Processed Green Material ADC Parameter Soluble Designated Parameter Soluble Designated Level (mg/L)* Level (mg/L)* Arsenic 0.08 Cobalt 0.5 Mercury 0.012 Copper 17 Selenium 0.2 Lead 0.09 Antimony 0.06 Molybdenum 0.1 Barium 4.9 Nickel 1.85 Beryllium 0.04 Silver 0.35 Cadmium 0.0007 Thallium 0.001 Total Chromium 0.85 Vanadium 0.63 Zinc 200 * Measured on the extract of the California Waste Extraction Test performed with the deionized water buffer. Any ADC delivered to the YCCL that fails to meet the above specification shall be removed and disposed in accordance will all applicable regulations by the Contractor at Contractors expense.
Sample 1
Chemical Characteristics. CITY will not deliver to EKO any biosolids where test results exceed maximum contaminant limits established by the USEPA or the Montana Department of Water Quality. If the biosolids contain any physical, chemical, or organic chemical characteristics that render it unsuitable for use by EKO, EKO has the right to refuse acceptance of the biosolids and shall have the option, upon ninety (90) days written notice to CITY, to terminate this agreement with no penalty to EKO.
Sample 1
Chemical Characteristics. Seller, at Seller's expense, will ------------------------- furnish Purchaser with such mill test records of chemical characteristics as Purchaser may require, as set forth in Exhibit B. Purchaser may test each slab at its Fontana plant within the schedule as per Article 11. If Purchaser's test demonstrates that a slab does not meet the specifications for its type as specified in Exhibit B, the provisions of Article 11 shall apply.
Sample 1
Chemical Characteristics 
Sample 1Sample 2Sample 3See All (11)
AutoNDA by SimpleDocs

Related to Chemical Characteristics

  • Individual Characteristics Each Receivable has the following individual characteristics as of the Cut-Off Date: (i) each Receivable is secured by a new or used automobile, minivan or sport utility vehicle; (ii) each Receivable has an APR of no less than 0.00% and not more than 13.94; (iii) each Receivable had an original term to maturity of not more than 72 months and not less than 18 months and each Receivable has a remaining term to maturity, as of the Cut-Off Date, of 12 months or more; (iv) each Receivable has an Outstanding Principal Balance as of the Cut-Off Date of greater than or equal to $2,394.67; (v) no Receivable has a scheduled maturity date later than October 7, 2020; (vi) no Receivable was more than 30 days past due as of the Cut-Off Date; (vii) as of the Cut-off Date, no Receivable was noted in the records of VCI or the Servicer as being the subject of any pending bankruptcy or insolvency proceeding; (viii) no Receivable is subject to a force-placed Insurance Policy on the related Financed Vehicle; (ix) each Receivable is a Simple Interest Receivable; (x) each of the Receivables were selected using selection procedures that were not known or intended by VCI or the Servicer to be adverse to the Purchaser; and (xi) the Dealer of the Financed Vehicle has no participation in, or other right to receive, any proceeds of such Receivable.

  • Pool Characteristics The Mortgage Loans in the related Mortgage Loan Package have the characteristics as set forth on Exhibit 2 to the related Assignment and Conveyance.

  • Characteristics The Contracts have the following characteristics: (i) all the Contracts are secured by Motorcycles; (ii) no Contract has a remaining maturity of more than 84 months; and (iii) the final scheduled payment on the Contract with the latest maturity is due no later than July 27, 2030. Approximately 63.90% of the Pool Balance as of the Cutoff Date is attributable to loans for purchases of new Motorcycles and approximately 36.10% is attributable to loans for purchases of used Motorcycles. No Contract was originated after the Cutoff Date. No Contract has a Contract Rate less than 0.010%.

  • Physical File Characteristics 7.2.1 The EODUF feed will be distributed to Comcast Phone over their existing Optional Daily Usage File (ODUF) feed. The EODUF messages will be intermingled among Comcast Phone’s Optional Daily Usage File (ODUF) messages. The EODUF will be a variable block format (2476) with an LRECL of 2472. The data on the EODUF will be in a non-compacted EMI format (175 byte format plus modules). It will be created on a daily basis (Monday through Friday except holidays). 7.2.2 Data circuits (private line or dial-up) may be required between BellSouth and Comcast Phone for the purpose of data transmission. Where a dedicated line is required, Comcast Phone will be responsible for ordering the circuit, overseeing its installation and coordinating the installation with BellSouth. Comcast Phone will also be responsible for any charges associated with this line. Equipment required on the BellSouth end to attach the line to the mainframe computer and to transmit successfully ongoing will be negotiated on an individual case basis. Where a dial-up facility is required, dial circuits will be installed in the BellSouth data center by BellSouth and the associated charges assessed to Comcast Phone. Additionally, all message toll charges associated with the use of the dial circuit by Comcast Phone will be the responsibility of Comcast Phone. Associated equipment on the BellSouth end, including a modem, will be negotiated on an individual case basis between the Parties. Version 4Q01 12/01/01 All equipment, including modems and software, that is required on Comcast Phone’s end for the purpose of data transmission will be the responsibility of Comcast Phone.

  • ODUF Physical File Characteristics 6.2.1 ODUF will be distributed to TWTC via Secure File Transfer Protocol (FTP). The ODUF feed will be a variable block format. The data on the ODUF feed will be in a non-compacted EMI format (175 byte format plus modules). It will be created on a daily basis Monday through Friday except holidays. Details such as dataset name and delivery schedule will be addressed during negotiations of the distribution medium. There will be a maximum of one dataset per workday per OCN. If AT&T determines the Secure FTP Mailbox is nearing capacity levels, AT&T may move the customer to CONNECT: Direct file delivery. 6.2.2 If the customer is moved, CONNECT: Direct data circuits (private line or dial-up) will be required between AT&T and TWTC for the purpose of data transmission. Where a dedicated line is required, TWTC will be responsible for ordering the circuit, overseeing its installation and coordinating the installation with AT&T. TWTC will also be responsible for any charges associated with this line. Equipment required on the AT&T end to attach the line to the mainframe computer and to transmit messages successfully on an ongoing basis will be negotiated on an individual case basis. Any costs incurred for such equipment will be TWTC's responsibility. Where a dial-up facility is required, dial circuits will be installed in the AT&T data center by AT&T and the associated charges assessed to TWTC. Additionally, all message toll charges associated with the use of the dial circuit by TWTC will be the responsibility of TWTC. Associated equipment on the AT&T end, including a modem, will be negotiated on an individual case basis between the Parties. All equipment, including modems and software, that is required on TWTC end for the purpose of data transmission will be the responsibility of TWTC. 6.2.3 If TWTC utilizes FTP for data file transmission, purchase of the FTP software will be the responsibility of TWTC.

  • CHARACTERISTICS OF THE ACADEMY The characteristics of the Academy set down in Section 1(6) of the Academies Act 2010, are that:

  • Mortgage Loan Characteristics The characteristics of the related Mortgage Loan Package are as set forth on the description of the pool characteristics for the applicable Mortgage Loan Package delivered pursuant to Section 11 on the related Closing Date in the form attached as Exhibit B to each related Assignment and Conveyance Agreement;

  • Characteristics of Receivables Each Receivable (A) shall have been originated in the United States by a Dealer for the retail sale of the related Financed Vehicle in the ordinary course of such Dealer’s business, shall have been fully and properly executed by the parties thereto, shall have been purchased by the Seller from such Dealer under an existing agreement with the Seller, shall have been validly assigned by such Dealer to the Seller in accordance with its terms and, to the best knowledge of the Seller, shall have been sold by a Dealer without fraud or misrepresentation, (B) shall have created or shall create a valid, subsisting and enforceable first priority security interest in favor of the Seller in the related Financed Vehicle, (C) shall contain customary and enforceable provisions such that the rights and remedies of the holder thereof shall be adequate for realization against the collateral of the benefits of the security, (D) shall provide for level Monthly Payments (provided that the first or last payment in the life of the Receivable may be minimally different from the level payment) that fully amortize the Amount Financed over its original term and shall provide for a finance charge or shall yield interest at its APR, (E) shall provide for, in the event that such Receivable is prepaid, a prepayment that fully pays the Principal Balance and includes accrued but unpaid interest at least through the date of prepayment in an amount calculated by using an interest rate at least equal to its APR, (F) shall have an Obligor that is not a federal, state or local governmental entity and (G) is a retail installment contract.

  • Quality All products will be new and unused. All products provided by the Contractor must meet all federal, state, and local standards for quality and safety requirements. Products not meeting the requirements of this section will be deemed unacceptable and returned to the Contractor for credit at no charge to the State.

  • Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!