CLOTHING ISSUE AND SAFETY FOOTWEAR AND EQUIPMENT Sample Clauses

CLOTHING ISSUE AND SAFETY FOOTWEAR AND EQUIPMENT. 70.1. MANDATORY EQUIPMENT All Employees engaged to work on site will be supplied with appropriate safety footwear, high visibility apparel, safety glasses and clean safety helmets with name clearly displayed before commencing work on the Project. These items must be worn at all times, or, as instructed during the site induction process. Where there is evidence that Employees are not wearing the mandatory equipment whilst engaged to work on the site they will be dealt with in accordance with the Counselling and Disciplinary Procedure set out in this Agreement. 70.2. WORK CLOTHING Two sets of cotton drill protective clothing will be issued to all Employees, upon request, within two weeks of commencing work with the Company. Employees will be made aware of these entitlements at the time of engagement. A set of clothing will consist of either: • Three pairs of overalls; or • Three pairs of long trousers and three long sleeved shirts; or • Work denims at cost no greater than the above three choices. • One 32oz bluey jacket or equivalent Clothing and footwear will be replaced on a fair wear and tear basis.
AutoNDA by SimpleDocs
CLOTHING ISSUE AND SAFETY FOOTWEAR AND EQUIPMENT. 38.1 Mandatory equipment (a) All Employees engaged to work on site will be supplied with appropriate safety footwear and safety helmets before commencing work on a project. (b) These items must be worn at all times as instructed during the site induction process. Helmets must not be painted, drilled or structurally modified in any way. Damaged and/or worn footwear and helmets will be replaced on demand. 38.2 Work clothing‌ (a) The following items must be supplied to each full-time Employee by the Employer, upon the completion of five working days:‌ (i) 1 pair safety boots, to the value of $120.00, that must be replaced on a fair wear and tear basis; (ii) 3 pairs of long pants that must be replaced on a fair wear and tear basis; (iii) 5 long sleeve shirts that must be replaced on a fair wear and tear basis; and (iv) 1 bluey jacket per year that must be replaced on a fair wear and tear basis. (b) The Employer must also make available to each Employee, when requested by them, sunscreen lotion and sun brims to fit over safety helmets. (c) The Employer must not agree with Employees to pay cash in lieu of supplying clothing and footwear in accordance with clause 38.2(a).
CLOTHING ISSUE AND SAFETY FOOTWEAR AND EQUIPMENT 

Related to CLOTHING ISSUE AND SAFETY FOOTWEAR AND EQUIPMENT

  • CLOTHING AND EQUIPMENT (a) Employees required by the Employer to wear uniforms will be supplied with an adequate number of uniforms appropriate to the occupation free of cost to Employees. Such items are to remain the property of the Employer and be laundered and maintained by such Employer free of cost to the Employee. (b) Instead of the provision of such uniforms, the Employer may, by agreement with the Employee, pay such Employee a uniform allowance at the rate set out in Item 1 of Table 5. This rate is expressed as per shift or part thereof, or as a weekly rate – an Employee is to be paid whichever is the lesser amount. (c) Where an Employee’s uniforms are not laundered by or at the expense of the Employer, the Employee will be paid a laundry allowance. For Aged Care, Health Professionals and Home Care Employees this will be paid at the rate set out in Item 2 of Table 5. This allowance is also expressed as a payment per shift of part thereof of as a weekly payment – an Employee is to be paid whichever is the lesser amount. For Nursing Employees this will be paid at the rate set out in Item 3 of Table 5. (d) The uniform allowance, but not the laundry allowance, will be paid during all absences on paid leave, except absences on long service leave and absence on personal/carer’s leave beyond 21 days. Where, prior to the taking of leave, an Employee was paid a uniform allowance other than at the weekly rate, the rate to be paid during absence on leave will be the average of the allowance paid during the four weeks immediately preceding the taking of leave. (e) Where an Employer requires an Employee to wear rubber gloves, special clothing or where safety equipment is required for the work performed by an Employee, the Employer must reimburse the Employee for the cost of purchasing such special clothing or safety equipment, except where such clothing or equipment is provided by the Employer.

  • Protective Clothing and Equipment The Employer shall provide and pay for all protective devices, clothing and other equipment necessary to properly protect employees from injury and unhealthy conditions. The Employer shall make provisions for the proper cleaning and maintenance of all safety equipment, devices and clothing at no cost to the employees.

  • OCCUPATIONAL HEALTH AND SAFETY 34.01 The parties recognize the need for a safe and healthy workplace. The Employer shall be responsible for providing safe and healthy working conditions. The Employer and Employees will take all reasonable steps to eliminate, reduce or minimize all workplace safety hazards. Occupational health and safety education, training and instruction provided by the Employer, shall be paid at the Basic Rate of Pay, to fulfill the requirements for training, instruction or education set out in the Occupational Health and Safety Act, Regulation or Code. (a) There shall be an Occupational Health and Safety Committee (Committee), which shall be composed of representatives of the Employer and representatives of the Local and may include others representing recognized functional bargaining units. This Committee shall meet once a month, and in addition shall meet within 10 days of receiving a written complaint regarding occupational health or safety. An Employee shall be paid the Employee’s Basic Rate of Pay for attendance at Committee meetings. A request to establish separate committees for each site or grouping of sites shall not be unreasonably denied. The Employer shall provide training at no cost to all Employees on the Committee to assist them in performing their duties on the Committee. Training shall be paid at the Employee’s Basic Rate of Pay. (b) Minutes of each meeting shall be taken and shall be approved by the Employer, the Local, and other bargaining groups, referred to in (a), prior to circulation. (c) The purpose of the Committee is to consider such matters as occupational health and safety and the Local may make recommendations to the Employer in that regard. (d) If an issue arises regarding occupational health or safety, the Employee or the Local shall first seek to resolve the issue through discussion with the applicable immediate supervisor in an excluded management position. If the issue is not resolved satisfactorily, it may then be forwarded in writing to the Committee. (e) The Committee shall also consider measures necessary to ensure the security of each Employee on the Employer’s premises and the Local may make recommendations to the Employer in that regard. (f) (i) Should an issue not be resolved by the Committee, the issue shall be referred to the Chief Executive Officer (CEO). A resolution meeting between the Local and the CEO, or designate(s), shall take place within 21 calendar days of the issue being referred to the CEO. The CEO or designate(s) shall reply in writing to the Local within seven (7) calendar days of the resolution meeting.

  • Cleanliness and Safety; Entry Resident agrees to maintain the assigned bedroom space, the apartment and the common areas of the Property in a clean, safe and sanitary condition, to exercise all due care in the use of same, and to cooperate fully with the Property pest control program as requested. Resident will be responsible for the cost of treatment for bedbugs and similar pests to the extent Owner’s pest control vendor reasonably determines that an infestation has originated within Resident’s assigned space and during Resident’s occupancy. Resident will place all trash in provided receptacles and will be responsible for the cost of cleaning the interior or exterior of the apartment if not kept in sanitary condition. When outdoor temperatures are below 40 degrees Fahrenheit, Resident will keep the apartment’s heat turned on to prevent frozen or burst pipes, including during vacations. When outdoor temperatures exceed 85 degrees Fahrenheit, Resident will keep the apartment’s air conditioning turned on and set to a reasonable temperature to prevent mold or mildew growth, including during vacations. Owner and its agents, employees and contractors may enter any apartment and bedroom space to perform routine maintenance, inspections, showings and other ordinary functions, provided that Owner will provide advance notice to residents of an apartment before such entry. Owner reserves the right to enter an apartment and any bedroom space without prior notice (including a passkey and/or disarming the alarm or other means of entry if locks have been changed) for emergency maintenance or repair purposes, or when there is reasonable cause to believe that a situation exists that could cause danger to life, safety, health or property. Owner may confiscate any item deemed to cause a danger and is under no obligation to pay compensation for or to return such items.

  • Safety Shoes 3901 Employees who are required to wear steel-toed safety shoes will receive $200 toward the purchase and/or replacement of these shoes in the first quarter of each year. Any employee out on an authorized leave shall receive payment within thirty days of their return to paid duty. New employees who are required to wear steel- toed safety shoes will receive $200 toward the purchase of shoes in their first paycheck; for employees hired on or after December 1, he/she shall not receive an additional $200 in the first quarter.

  • Safety Footwear 1. The State will provide employees in the positions listed in Section 3 below, and employees who are currently required to wear safety footwear by Department Work Rules, an allowance of one hundred fifty dollars ($150.00) for replacement of safety footwear. This allowance will be paid to employees on a semiannual basis, with half paid in January and half paid in July to eligible employees on the payroll at the time of the payments. Employees of Departments with work rules that provide such safety footwear will not be eligible for the safety footwear allowance. 2. Safety footwear purchased must meet ANSI standards where applicable. Requirements for the wearing of safety footwear will be in accordance with work rules published by the State. 3. Positions required to wear safety footwear:

  • Personal Protective Equipment 64.1 While not being part of any issue of work clothing/equipment supplied (see clause 26), the Employer shall be required to provide personal protective equipment (SAA approved) for use, when necessary for the Employee to perform their required duties including: (a) ear/hearing protection; (b) gloves; and (c) skin protective cream/sun screen (30+/50+ rating). 64.2 In addition, one pair of UV-rated safety glasses or UV-rated clip-ons suitable to overlay prescription spectacles, shall be made available for Employees who are required to work on reflective surfaces such as: (a) metal decking; (b) large concrete slabs exposed to sunlight; (c) roofing; and (d) curtain xxxxxxx.

  • Personal Protective Clothing 11.1 On commencement of employment with the Employer each employee will be issued with the following; 11.2 Where the employee requires prescription glasses, the Employer shall ensure that appropriate eye protection is issued or where the employee has had his/her glasses hardened, reimburse the employee for the cost, provided that such glasses meet appropriate safety standards. 11.3 The above mentioned equipment will be maintained by the employee and replaced by the Employer on a fair wear and tear basis. 11.4 Intentionally left blank

  • CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.

  • Occupational Health and Safety Act The Employer, the Union, and the Employees recognize they are bound by the provisions of the Occupational Health and Safety Act, S.N.S. 1996, c.7, and appropriate federal acts and regulations. Any breach of these obligations may be grieved pursuant to this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!