Scope of Subcontract Works Sample Clauses

Scope of Subcontract Works. ‌ (a) The Subcontractor shall carry out and complete the whole of the Subcontract Works as shown and/or described in the Subcontract Documents (including all minor items of work to be inferred from for the proper execution and completion of the Subcontract Works) as well as Variations to the Subcontract Works directed by the Contactor: (I) in accordance with the Contractor’s Directions and the time required by the Contactor; (II) on or before the Date for Practical Completion; and (III) in a proper and tradesman like manner. (b) The Subcontractor acknowledges that it must make allowance for: (I) minor items not expressly mentioned in the Subcontract Documents but which are necessary for the proper execution and completion the Subcontract Works; and (II) slight variations in dimensions shown on drawings which may be caused by unavoidable inequalities in the size of materials.
Sample 1Sample 2
AutoNDA by SimpleDocs
Scope of Subcontract Works a. The Scope of work shall be complete engineering, supply, delivery to site, installation, handover, warranty and remedying of defects therein of Tile Works including sealers, protection to installed tile works, cutting, adhesive and grout, wastages and attic stocks in the unit rate as per project documents’ requirements, all complete as specified and as shown on drawings and all in accordance with the Contract and in full compliance with the materials/samples/mock-up and other technical submittals duly approved by the Employer’s Representative/ Employer’s Representative’s Consultant / the Employer and local authorities. b. The Scope of works shall include, but not limited to, the supply and installation of the following:  Tile Staircase including Tread, Riser and Skirting  Tile Threshold c. All works to be done as per the recommendation of the manufacturer, relevant specifications & standard applicable codes of practice. d. Supply, deliver, install and warrant the work in strict compliance with the materials and workmanship requirements of the drawings and specification. e. Provision of all necessary warranties and guarantees for the Subcontract Works as set out in the tender documents/contract documents. f. Third Party testing, if required, shall be done in compliance with the Project Contract Specifications at no additional cost. g. Provide and submit all test certificates, warranties and guarantees required as per the contract documents. Submit reports of independent tests demonstrating that products and systems comply with the specified performance requirements. h. To liaise, coordinate and comply with all Local Authorities’ rules and regulations existing up to the date of issuance of Taking Over Certificate by the Employer. i. Cleaning of all completed works and handing-over of your Subcontract Works. j. To liaise and coordinate with the Contractor and other subcontractors working on the Project in accordance with site requirements. k. Preparation and submission of all necessary samples, shop drawings, engineering data, test reports, as-built drawings and maintenance manuals and all necessary submissions and approvals required by the local authorities for the Subcontract works. l. Carry out site measurements of the sizes of items under the subcontract works for the purpose of preparing shop drawings of such items. m. Protection of Subcontract works which shall include supply and installation of appropriate protective materials and removal and disp...
Sample 1
Scope of Subcontract Works. Details will be specific to required actions for the project this will be detailed within the issued Purchase Order. The Subcontractor may be required submit the following deliverables for the project these will be itemised per purchase order within the required actions, • Prior to commencement Plant Pre-Mobilisation Inspection Checklists completing form, • Prior to commencement High Risk Safe Work Method Statements, • Issued with Monthly claim the Monthly HSEQ Data completing form, • Issued with Monthly claim the Monthly Waste Tracking Data completing form, • Issued with Monthly claim the Monthly Environmental Data completing form, • Acknowledgment of compliance to CDA Group Australia WHSEQ System and Client Specifications.
Sample 1

Related to Scope of Subcontract Works

  • Use of Subcontractors Nothing in this Appendix 2 shall prevent the Interconnection Parties from utilizing the services of subcontractors as they deem appropriate to perform their respective obligations hereunder, provided, however, that each Interconnection Party shall require its subcontractors to comply with all applicable terms and conditions of this Appendix 2 in providing such services.

  • Scope of Supply 12.1 The Goods and Related Services to be supplied shall be as specified in the Schedule of Requirements.

  • PAYMENT OF SUBCONTRACTORS Contractor shall pay any of its subcontractors not later than seven (7) days after receipt of any progress payment, unless otherwise agreed to in writing, the respective amounts allowed Contractor on account of the work performed by subcontractor(s), to the extent of each subcontractor’s interest therein, except as otherwise provided in Business and Professions Code Section 7108.5.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.

  • Oversight of Subcontractors In the event that Vendor engages subcontractors or other authorized persons or entities to perform one or more of its obligations under the Master Agreement (including subcontracting hosting of the Protected Data to a hosting service provider), it will require those subcontractors or other authorized persons or entities to whom it will disclose the Protected Data to execute legally binding agreements acknowledging their obligation under Section 2-d of the New York Education Law to comply with all applicable data protection, privacy and security requirements required of Vendor under the Master Agreement and applicable state and federal law and regulations.

  • Solicitations for Subcontracts, Including Procurement of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Local Government for work to be performed under a subcontract, including procurement of materials or leases of equipment, each potential subcontractor or supplier will be notified by the Local Government of the Local Government’s obligations under this Agreement and the Acts and Regulations relative to Nondiscrimination on the grounds of race, color, or national origin.

  • Use of Subservicers and Subcontractors (a) The Master Servicer shall cause any Subservicer used by the Master Servicer (or by any Subservicer) for the benefit of the Depositor to comply with the provisions of Section 3.16 and this Article XI to the same extent as if such Subservicer were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person). The Master Servicer shall be responsible for obtaining from each Subservicer and delivering to the Depositor any servicer compliance statement required to be delivered by such Subservicer under Section 3.16, any assessment of compliance and attestation required to be delivered by such Subservicer under Section 11.07 and any certification required to be delivered to the Certifying Person under Section 11.05 as and when required to be delivered. As a condition to the succession to any Subservicer as subservicer under this Agreement by any Person (i) into which such Subservicer may be merged or consolidated, or (ii) which may be appointed as a successor to any Subservicer, the Master Servicer shall provide to the Depositor, at least 15 calendar days prior to the effective date of such succession or appointment, (x) written notice to the Depositor of such succession or appointment and (y) in writing and in form and substance reasonably satisfactory to the Depositor, all information reasonably requested by the Depositor in order to comply with its reporting obligation under Item 6.02 of Form 8-K. (b) It shall not be necessary for the Master Servicer, any Subservicer or the Trustee to seek the consent of the Depositor or any other party hereto to the utilization of any Subcontractor. The Master Servicer or the Trustee, as applicable, shall promptly upon request provide to the Depositor (or any designee of the Depositor, such as the Master Servicer or administrator) a written description (in form and substance satisfactory to the Depositor) of the role and function of each Subcontractor utilized by such Person (or in the case of the Master Servicer or any Subservicer), specifying (i) the identity of each such Subcontractor, (ii) which (if any) of such Subcontractors are "participating in the servicing function" within the meaning of Item 1122 of Regulation AB, and (iii) which elements of the Servicing Criteria will be addressed in assessments of compliance provided by each Subcontractor identified pursuant to clause (ii) of this paragraph. As a condition to the utilization of any Subcontractor determined to be a Reporting Subcontractor, the Master Servicer or the Trustee, as applicable, shall cause any such Subcontractor used by such Person (or in the case of the Master Servicer or any Subservicer) for the benefit of the Depositor to comply with the provisions of Sections 11.07 and 11.09 of this Agreement to the same extent as if such Subcontractor were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person) or the Trustee, as applicable. The Master Servicer or the Trustee, as applicable, shall be responsible for obtaining from each Subcontractor and delivering to the Depositor and the Master Servicer, any assessment of compliance and attestation required to be delivered by such Subcontractor under Section 11.05 and Section 11.07, in each case as and when required to be delivered.

  • Vendor’s Subcontractors TIPS recognizes that many vendors operate in the open market through the use of subcontractors. For that reason, TIPS permits Vendor to utilize subcontractors as authorized and permitted by the TIPS Member Customer. However, all purchase documents must include: (1) Vendor’s Name, as known to TIPS, and; (2) Vendor’s TIPS Contract Name and Number under which it is making the TIPS Sale. Vendor must report the sale pursuant to the terms herein and Vendor agrees that it is legally responsible for all reporting and fee payment as described herein for TIPS Sales even when subcontractors are utilized. The TIPS Administration Fee is assessed on the amount paid by the TIPS Member to Vendor. The Parties intend that Vendor shall be responsible and for actions of subcontractors during a TIPS Sale. Vendor agrees that it is voluntarily authorizing subcontractors and in doing so, Xxxxxx agrees that it is doing so at its own risk and agrees to protect, indemnify, and hold TIPS harmless in accordance with Sections 14-17 above related to subcontractor TIPS Sales made pursuant to this Agreement or purporting to be made pursuant to this Agreement that may be asserted against Vendor whether rightfully brought or otherwise. The Parties further agree that it is no defense to Vendor’s breach of this Agreement that a subcontractor caused Vendor of breach this Agreement.

  • HUB Subcontracting Plan The Owner has adopted Exhibit H, Policy on Utilization of Historically Underutilized Business ("Policy"), which is incorporated herein by reference. Contractor, as a provision of the Agreement must comply with the requirements of the Policy and adhere to the HUB Subcontracting Plan submitted with Contractor's Proposal and attached as Exhibit I. No changes to the HUB Subcontracting Plan can be made by the Contractor without the prior written approval of the Owner in accordance with the Policy.

  • Selection of Subcontractors Procurement of Materials and Leasing of Equipment: The contractor shall not discriminate on the grounds of race, color, religion, sex, sexual orientation, gender identity, national origin, age, or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors, suppliers, and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!