Components Patheon will purchase and test all Components (with the exception of Client-Supplied Components) at Patheon’s expense and as required by the Specifications.
Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Equipment Cleaning (a) Areas, known by Forest Service prior to timber sale advertisement, that are infested with invasive species of concern are shown on Sale Area Map. A current list of invasive species of concern and a map showing the extent of known infestations is available at the Forest Supervisor’s Office. For purposes of this provision, “Off-Road Equipment” includes all logging and construction machinery, except for log trucks, chip vans, service vehicles, water trucks, pickup trucks, cars, and similar vehicles.
Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The BoxReturn Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. DISH Protect $11.99 $0.00 DISH Protect Plus $11.99 $0.00
MEASURING EQUIPMENT 1. Seller will maintain and operate, atlts own, expense and atthe point of delivery of gas hereunder, a meter or meters and othernecessary equipment by which the volume of gas delivered hereunder shall be measured. Such meters and equipment shall remain the property of the Seller.
2. Buyer agrees lo furnish to Seller electricity for operating Seller's meters, at not cost to Seller.
3. Buyer hereby grants to Seller suitable rlghts-0f-way and easements necessary or Incidental for the installatioo, maintenance, operation and removal of pipeline and other facilities together with rights ofingress thereto and egress there from at all times and hereby agrees to deliver to Seller, for the sum of one dollar ($1.00), an appropriate instrument or grant defining such rights and easements located on Buyer's planlslte.
4. Buyer may install, maintain and operate such check measuring equipment, Including arecording gravltometer and calorimeter as it shall desire, provided that such equipment shall be so installed so as not to Interfere with the operation of Seller's measuring equipment at or near the point of deliver. However, all xxxxxxxx to the Buyer shall be based on the metering of the Seller, subject only to the provisions of Paragraph 8 of this Article.
5. Each party shall have the right to be present at the time of any installing, reading, cleaning, changing, repairing, Inspecting, testing, calibrating, or adjusting done In connection with the other's measuring equlpme!lt used in measuring deliveries hereunder and each party shall advise the other of any Intended major maintenance operation sufficiently in advance in order that the other party may conveniently have its representative present.
6. All installatioo of measuring equipmenL applying to or effecting deliveries hereunder, shall be rnade in such manner as to perrnit an accurate detenninalion of the quantity of gas delivered and ready verification of the accuracy of measurement Orifice meter Installations, If used, shall oonforrn lo the recommendation for design and lnstallatioo contained in the Gas Measurement Commiltee Report No. 3 to the American Gas Association published April, 1955, and any modificatioos and amendments thereof and shall include the use of flange connections.
7. Measurement on Seller's meter or meters shall be conclusive of both parties except where the meter Is defective or fails to register, or if found in E)rror, in either of which case Seller shall repair or replace the meter and the quantity of gas delivered while the meter was out of order or failed to register shall be estimated:
(a) By using the registration of any check meter If installed and accurately registering, or, In the absence of (a): (b) By correcting the error If the percentage of error by calibration, test or mathematical calculation, or, in the absence of both (a) and (b) then: (c) By estimating the quantity of delivery from deliveries during periods under similar oonditions when the meter was registering actUrately; and an appropriate billing adjusbnentshall be made In accordance with the current Rules and Regulations governing gas systems issued by the Commission.
8. Seller will maintain its meters in .good order and to this end Wiii make periodic tests of its meters pursuant to the current Rules and Regulations governing gas systems issued by the Commission, or at such shorter intervals as seem to Seller desirable. lfBuyer Is dissatisfied with the accuracy at eny time, it may call upon Seller to have Iha meter tested in accordance with all regulatioos relating to such tests and results of such tesls as found in the current Rules and Regulations governing gas systems issued by the Commission.
9. Each party shall preserve all records for aperiod of at least two (2) years.
Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.
Equipment The Fund shall obtain and maintain at its own cost and expense all equipment and services, including but not limited to communications services, necessary for it to utilize the Software and obtain access to the System, and Custodian shall not be responsible for the reliability or availability of any such equipment or services.
New Equipment Where new types of equipment and/or operations, for which rates of pay are not established by this Agreement, are put into use after the ratification date of this Agreement within operations covered by this Agreement, rates governing such operations shall be subject to negotiations between the parties. This paragraph shall apply to all new types of equipment including office and clerical equipment. In the event an agreement cannot be reached within sixty (60) days after the date such equipment is put into use, the matter may shall be submitted to the National Grievance Committee for final disposition. Rates agreed upon or awarded shall be effective as of the date equipment is put to use
Special Equipment The Employer agrees to provide specialty tools, emergency supplies/equipment, testing equipment and safety equipment as needed to perform required duties as determined and authorized by the Chief or designee. The emergency supplies/equipment will include appropriate survival provisions and equipment for each permanent Maintenance Mechanic 4 and the Law Enforcement Communications Systems Supervisor when they are performing duties that would require such provisions and equipment. When necessary, the employer will replenish used or expired survival provisions and damaged and unusable equipment. All supplies and equipment will be returned to the employer when the employee is no longer performing the duties that would require the survival provisions and/or equipment.
