Type B Sample Clauses

Type B. (a) To accept an invitation to the witnessed acceptance tests and provide comments on the test scripts the précis of the test data to be used at least 2 weeks in advance. (b) To attend the witnessed tests
Sample 1Sample 2Sample 3See All (7)
AutoNDA by SimpleDocs
Type B. (a) At least 4 weeks in advance of witnessed acceptance tests, to invite the Authority and the Accreditation Schemes to be present at witnessed acceptance tests and to provide the test scripts that are to be witnessed and a précis of the test data‌ (b) To demonstrate the test scripts being run against the system using the test data
Sample 1Sample 2Sample 3See All (7)
Type B. A complaint by an employee that an action taken or refused by an administrator is unfair.
Sample 1Sample 2
Type B. Coating material develops bond strength with concrete so that a bondbreaker is necessary. Shop-applied bondbreakers are to conform to the pull-out load requirements of AASHTO M 254.
Sample 1
Type B. The length of the leave is not known (i.e., illness or accident). For TYPE B leaves, the District may utilize a substitute for up to five (5) work days or until circumstances convert this to a TYPE A leave. If a vacancy is filled by a regular bus driver creating yet another vacancy, that vacancy will be filled by a substitute except in case of an emergency.
Sample 1
Type B. Coating material develops bond strength with concrete so that a bond breaker is necessary. Shop-applied bond breakers are to conform to the pull-out load requirements of AASHTO M 254. (a) Silicone Joint Sealing Material. Revise to read as follows: (a) Silicone Joint Sealing Material. Low modulus, non-sag-silicone, sealing material in a nonacid-curing, one-part formulation, which requires tooling, from a manufacturer listed in Bulletin 15. Furnish silicone joint sealing material conforming to the following physical requirements: • Tensile Stress at 150% elongation, pounds per square inch, max. (ASTM D412, Die C) 7-day cure at 77F ± 3F and 45% to 55 % relative humidity 45 • Elongation at maximum tensile strength, %, min. (ASTM D412, Die C) 600 • Extrusion rate, grams/minute, min. 0F to 100F (Test for extrusion using an air-powered caulking gun, having a 1/8-inch orifice, at 90 pounds per square inch) 75 • Specific gravity (ASTM D792, Method A) 1.010 to 1.515 • Durometer hardness, shore “A” (ASTM D2240) 7-day cure at 77F ± 3F and 45 to 55% relative humidity. 10 to 25 @ 0F • Shelf life, days, min., from date of manufacture. 180 • Ozone and ultraviolet resistance (ASTM C793) No chalking, cracking, or bond loss after 5000 hours. • Flow (ASTM C639-Type II) Nil • Bond to cement mortar, pounds per square inch, min., primed if required. (Mold three cement mortar briquets according to AASHTO T 132 and moisture cure for at least 28 days. Saw briquets in half, clean, and oven dry to a constant weight in an oven at 110 °C ± 5 °C. After cooling, bond halves together with approximately 10 mils of silicone sealant, cure 7 days at 77F ± 3F and 45 to 55% relative humidity, and test using clips conforming to AASHTO T 132. Test specimens in tension at loading rate of 0.3 inch/minute. 50 • Tack free time, minutes, max. (ASTM C679) 90 • Movement capability and adhesion (ASTM C719) Cyclic movement: +100% / -50% (extension/compression), no adhesive or cohesive failure after 10 cycles @ 0F
Sample 1

Related to Type B

  • Data Universal Number System (DUNS) number Requirement Grantee will provide their valid DUNS number contemporaneous with execution of this Agreement.

  • JOC - PRICING OF Regular Hours Coefficient What is your regular hours coefficient for the RS Means Price Book? (FAILURE TO RESPOND PROHIBITS PART 2 JOC EVALUATION)

  • Aircraft Basic Price The Aircraft Basic Price is listed in Table 1 and is subject to escalation in accordance with the terms of this Purchase Agreement.

  • Unit Pricing If required by the Bid Specifications, the Bidder should insert the price per unit specified and the price extensions in decimals, not to exceed four places for each item unless otherwise specified, in the Bid. In the event of a discrepancy between the unit price and the extension, the unit price shall govern unless, in the sole judgment of the Commissioner, such unit pricing is obviously erroneous.

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

  • TREATMENT REQUESTED Buyer shall defend, indemnify and hold harmless Myriant from and against all loss, costs, expenses, damages and liability of any kind arising out of any claims of infringement or alleged infringement of any patent or other intellectual property right with respect to (i) the use of Products in any application by Buyer or its affiliates, contract manufacturers or customers, including but not limited to the use of Products alone or in combination with other substances or components; (ii) any modification to the Products by Buyer or its affiliates, contract manufacturers or customers; or (iii) Products furnished, or methods used, by Myriant in accordance with the specifications or instructions furnished by or expressly or implicitly prescribed by Buyer.

  • WHEXXXX xs xxxx of a plan of reorganization, RESTART PARTNERS V, L.P., a Delaware Limited Partnership ("Restart V"), may acquire an ownership interest in Elsinore Corporation ("Elsinore") or the Four Queens, Inc. ("FQI");

  • Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-­‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.

  • GSA Benchmarked Pricing Additionally, where the NYS Net Price is based upon an approved GSA Supply Schedule:

  • Spare Parts 14.1 As specified, the supplier may be required to provide any or all of the following materials, notifications, and information pertaining to spare parts manufactured or distributed by the supplier: (a) such spare parts as the purchaser may elect to purchase from the supplier, provided that this election shall not relieve the supplier of any warranty obligations under the contract and; (b) In the event of termination of production of the spare parts: (i) advance notification to the purchaser of the pending termination, in sufficient time to permit the purchaser to procure needed requirements and; (ii) Following such termination, furnishing at no cost to the purchaser, the blueprints, drawings, and specifications of the spare parts, if requested.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!