Alignment and Location Sample Clauses

Alignment and Location. Proposed streets and other primary accesses will be aligned with existing streets or accesses as identified in the Transportation Element of the Olympia Comprehensive Plan. Street alignments will relate where practical, to natural topography and will be selected so as to minimize grading and avoid excessive runoff. Alignment and connections of newly constructed public streets will be provided in accordance with the following conditions in Chapter 4, unless otherwise prohibited: a. Street connection will be provided to any existing public street or right-of-way “stub” abutting the proposed development. b. Pedestrian and emergency access will be provided to any abutting public school, public building, urban trail, or transit stops. c. Streets will be located for the development of adjoining land. d. Provisions, such as stub roads, will be made for connection to any adjacent undeveloped, contiguous land area of one acre or more and to any site officially designated for a public facility. Such stubs will be located to provide for future block sizes consistent with these guidelines and connections to other stub roads on adjacent and nearby property. Signs indicating intent to extend in the future are required to be posted at the end of these stub streets. e. Blocks in residential zoning districts (listed in OMC 18.04 and 18.05) shall not exceed a perimeter of 1800 feet, measured at the edge of the right-of-way except one (1) block in a co-housing development (see OMC Section 18.04.060(F)), and all blocks in the R-4 District may have a perimeter of up to 2000 feet, provided street connections are made to adjoining streets and property as required by Section 2.040 B3 (a, c, d, and f). Such residential blocks with a perimeter greater than 1800 feet shall contain a public pathway near mid-block conforming to the Engineering Design and Development Standards. Blocks in commercial districts (listed in OMC Chapter 18.06) shall not exceed a perimeter of 2000 feet. Commercial blocks will not exceed a walking perimeter of 2000 feet. Where larger blocks are necessary due to topography, existing development, or other constraints, intervening public cross-block pedestrian, bicycle, and emergency access will be provided. The City Engineer may consider a deviation to this section (e) to allow development of schools, parks, and other large facilities, which must would otherwise have a large site uninterrupted by a street. Applicants for such uses must submit a deviation request...
Sample 1
AutoNDA by SimpleDocs
Alignment and Location. The Alignment, Longitudinal Section of the Underpasses, Approaches, etc. shall be as shown in the Drawing No. IS / 1402 / HIG / PL / 001 for Junction.
Sample 1

Related to Alignment and Location

  • Ownership and Location of Metering Equipment The Metering Equipment to be constructed, the capability of the Metering Equipment to be constructed, and the ownership thereof, are identified on the attached Schedule C to this ISA.

  • Closing Date and Location The Transaction will be completed at 10:00 a.m. (Pacific time) on the Closing Date, at the offices of the Purchaser’s Solicitors, or at such other location and time as is mutually agreed to by the Purchaser and the Target. Notwithstanding the location of the Closing, each party agrees that the Closing may be completed by the exchange of undertakings between the respective legal counsel for the Purchaser and the Target, provided such undertakings are satisfactory to each party’s respective legal counsel.

  • Project Location [Insert the location of the Project, if applicable]

  • UNDERGROUND LOCATIONS Prior to the Company commencing any work the Customer must advise the Company of the precise location of all underground services on the site and clearly xxxx the location. The underground mains and services the Customer must identify include, but are not limited to, telephone cables, fibre optic cables, electrical services, gas services, sewer services, pumping services, sewer connections, sewer sludge mains, water mains, irrigations pipes, oil pumping mains and any other services that may be on site. Whilst the Company will take all care to avoid damage to any underground services the Customer agrees to indemnify the Company in respect of all any liability claims, loss, damage, cost and fines as a result of damage to services not precisely located and notified pursuant to this clause.

  • Data Location 1.1. The CONTRACTOR shall not store or transfer non-public COUNTY data outside of the United States. This includes backup data and Disaster Recovery locations. The CONTRACTOR will permit its personnel and contractors to access COUNTY data remotely only as required to provide technical support. (Remote access to data from outside the continental United States is prohibited unless approved in advance and in writing by the County.) 1.2. The CONTRACTOR must notify the COUNTY in advance and in writing of any location changes to CONTRACTOR’s data center(s) that will process or store County data.

  • Duties and Location Executive shall perform such duties as are customarily associated with the position of CEO and such other duties as are assigned to Executive by the Board. Executive’s primary office location shall be the Company’s headquarters located in San Diego, California. Subject to the terms of this Agreement, the Company reserves the right to (a) reasonably require Executive to perform Executive’s duties at places other than Executive’s primary office location from time to time and to require reasonable business travel, and (b) modify Executive’s job title and duties as it deems necessary and appropriate in light of the Company’s needs and interests from time to time.

  • Business Locations Set forth on Schedule 6.20(a) is a list of all Real Properties located in the United States that are owned or leased by the Loan Parties as of the Closing Date. Set forth on Schedule 6.20(b) is a list of all locations where any tangible personal property of a Loan Party is located as of the Closing Date. Set forth on Schedule 6.20(c) is the chief executive office, jurisdiction of incorporation or formation and principal place of business of each Loan Party as of the Closing Date.

  • Work Location While employed by the Company hereunder, the Executive shall perform his duties (when not traveling or engaged elsewhere in the performance of his duties) at the offices of the Company in Bermuda. The Executive shall travel to such places on the business of the Company in such manner and on such occasions as the Company may from time to time reasonably require.

  • Access to Work Locations Reasonable access to employee work locations shall be granted officers of the Association and their officially designated representatives for the purpose of processing grievances or contacting members of the Association concerning business within the scope of representation. Such officers or representatives shall not enter any work location without the consent of the City Manager. Access shall be restricted so as not to interfere with the normal operations of the department or with established safety or security requirements. Solicitation of membership and activities concerned with the internal management of the Association, such as collecting dues, holding membership meetings, campaigning for office, conducting elections and distributing literature, shall not be conducted during working hours.

  • Separate Central and Local Terms The collective agreement shall consist of two parts. Part “A” shall comprise those terms which are central terms. Part “B” shall comprise those terms which are local terms.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!