Equipment Maintenance and Inspection Sample Clauses

Equipment Maintenance and Inspection a. The Lessor shall provide such buses, automobiles, trucks, and other vehicles necessary for day-to-day operation, supervision, and maintenance of the service for the Lessee. b. All Vehicles shall be maintained in good repair and working order, and in a clean and sanitary condition. A thorough preventative maintenance program on all vehicles shall be ongoing at all times and documentation of this program shall be provided to the Lessee upon written request. The Lessor will be responsible for all repairs and maintenance on all vehicles during the life of the Contract at its sole cost. c. A copy of all state vehicle inspections shall be forwarded on to Lessee and open for examination at all times by the Superintendent or his/her designee. d. All vehicles shall be equipped with two-way radios and a base station at the Lessor's terminal. The Proposer shall provide a listing of vehicles that will be used in the performance of services. The maximum age of the fleet shall not exceed a retention cycle of twelve (12) years for route buses and fifteen (15) years for spare buses and the average age of the fleet shall not exceed eight (8) years. e. A complete fleet listing shall be provided by the Lessor upon acceptance of this AGREEMENT and each year of the Contract. This listing shall indicate active route buses and substitute vehicles. f. The Lessor shall provide sufficient vehicles in each category (capacity of passengers, wheelchair lift buses, appropriate accommodations for disabled students, etc.), as back up units for breakdowns, preventive maintenance, and accident damaged vehicles. The Lessor also will have available a reasonable number of additional buses to provide for special service such as athletic trips, field trips etc. The number of spare vehicles should be sufficient to ensure that all service requirements are satisfied and to ensure compliance with the Minimum Standards of Performance g. Fleet school buses shall be used only for transporting regularly enrolled students to and from school, midday shuttles, and to extracurricular activities approved and designated by the Superintendent, Contract Manager, or designee. However, Lessor may use fleet school buses during non-school operational time for private charters. h. In the event that Lessee or any governmental agency imposes additional equipment requirements other than those set forth in this AGREEMENT on Lessor's vehicles during the term of this AGREEMENT which are specific requirements for the o...
Sample 1
AutoNDA by SimpleDocs
Equipment Maintenance and Inspection. Regardless of the size or weight of the Equipment being used by PLU to provide Services under this Agreement, PLU agrees, at PLU's expense, to have the Equipment maintained and inspected in accordance with the standards specified in 49 CFR Parts 393 and 396. This includes ensuring that the annual vehicle inspection required by 49 CFR Part 396 is performed for all Equipment used to provide Services, regardless of its size or weight and that all PLU Personnel assigned by it to operate Equipment used to provide Services under this Agreement are trained to conduct pre-trip and post- trip inspections consistent with USDOT-prescribed requirements for such inspections.
Sample 1
Equipment Maintenance and Inspection. While the PROJECT equipment is in the possession or control of the CONTRACTOR, the CONTRACTOR shall operate and maintain the equipment in accordance with detailed warranty, maintenance and inspection schedules provided by the original and final stage manufacturers. The STATE and FTA shall have the right to conduct periodic inspections for the purpose of confirming the existence, condition, and proper maintenance of the PROJECT equipment. No alterations (e.g., mechanical changes, painting) may be made to the PROJECT equipment in its as-received condition without first receiving written approval from the STATE.
Sample 1
Equipment Maintenance and Inspection. (A) Maintenance and Inspection. Regardless of the size or weight of the Equipment being used by JEE to provide Services under this Agreement, JEE agrees, at JEE's expense, to have the Equipment maintained and inspected in accordance with the standards specified in 49 CFR Parts 393 and 396. (B) Proof of Timely Maintenance and Inspection. JEE agrees to provide FXG with documentation of timely maintenance and inspection of the Equipment in accordance with the periodic mandatory vehicle maintenance and inspection regulations required by Applicable Law, including but not limited to 49 CFR Part
Sample 1

Related to Equipment Maintenance and Inspection

  • Maintenance and Inspection Consultant shall maintain complete and accurate records with respect to all costs and expenses incurred under this Agreement. All such records shall be clearly identifiable. Consultant shall allow a representative of City during normal business hours to examine, audit, and make transcripts or copies of such records and any other documents created pursuant to this Agreement. Consultant shall allow inspection of all work, data, documents, proceedings, and activities related to the Agreement for a period of three (3) years from the date of final payment under this Agreement.

  • Maintenance and Inspection of Records A. The SERVICE PROVIDER at such times and in such forms as the CITY may require, shall furnish to the CITY such statements, records, reports, data, and information as the CITY may request pertaining to matters covered by this Agreement. B. The SERVICE PROVIDER shall maintain books, records and documents, which sufficiently and properly reflect all direct and indirect costs related to the performance of this Agreement and shall maintain such accounting procedures and practices as may be necessary to assure proper accounting of all funds paid pursuant to this Agreement. These records shall be subject at all reasonable times to inspection, review, or audit, by the CITY, its authorized representative, the State Auditor, or other governmental officials authorized by law to monitor this Agreement. C. To ensure the CITY’S compliance with the Public Records Act, RCW 42.56, the SERVICE PROVIDER shall retain all books, records, documents and other material relevant to this agreement, for six (6) years after its expiration. The SERVICE PROVIDER agrees that the CITY or its designee shall have full access and right to examine any of said materials at all reasonable times during said period.

  • Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner. 2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.

  • Equipment Maintenance The Contractor agrees that when Contract funds are used to pay for all or part of the purchase costs of any equipment that costs $5,000 or more per item, and the purchase of such equipment is identified in an exhibit to this Contract, such equipment is, upon the purchase or receipt, the property of the County and/or federal/state government. The Contractor shall be responsible for all proper care and maintenance of the equipment, including securing and insuring such equipment.

  • Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.

  • TESTING AND INSPECTION 6.1 Pre-Commercial Operation Date Testing and Modifications.

  • Property Maintenance Maintain all of its property that is necessary to or useful in the proper conduct of its business in good working condition, ordinary wear and tear excepted.

  • Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.

  • Maintenance & Repairs 5.1 Lessee shall at all times be responsible for maintaining at its own expense the leased premises in a clean, orderly and safety condition, except as hereinafter provided. Lessee shall be responsible, at its own expense, to clean and maintain all trade fixtures, machinery and equipment furnished by Lessee within the leased premises. Lessee shall be responsible to deposit normal office waste and rubbish at a location at the Central School as designated by Lessor. 5.2 Lessee shall be responsible to perform all repairs the need for which is caused by Xxxxxx's use of the premises except that Lessor shall be responsible to perform major repairs of a structural nature. Lessor shall be responsible to arrange for removal of waste and rubbish from the location designated as the deposit location for lessees. All costs incurred by Lessor pursuant to the obligations of this Paragraph shall be included within "operating costs". 5.3 Lessor shall provide custodian services for the common areas of Central School. Costs incurred by Lessor in providing such custodian services shall be included within "operating costs".

  • Planned Maintenance (a) Subject to any modification or amendment of this Agreement made pursuant to Section 4.2(c) or Section 7.3(d), Planned Maintenance occurring during the Delivery Term shall be coordinated and scheduled in accordance with this Section 9.6. Seller shall perform all Planned Maintenance (including Major Planned Maintenance) in a manner that optimizes the generation and benefits to Buyer of the Contract Energy, Storage Energy, and other Products (e.g., during off-peak periods and low-irradiance periods) and, without limiting the foregoing, either (i) outside of Daylight Hours or (ii) during the months of October and November only, during Daylight Hours; provided, however, that the foregoing restrictions shall not apply to any Planned Maintenance that Seller is required to perform pursuant to any applicable manufacturer warranty that cannot reasonably be performed by Seller subject to such restrictions. (b) Seller shall deliver to Buyer a proposed schedule for Planned Maintenance in respect of each Contract Year (“Planned Maintenance Schedule”) no later than ninety (90) Days before the start of such Contract Year. Planned Maintenance Schedules submitted by Seller shall (i) comply with the second sentence of Section 9.6(a) and (ii) include reasonably detailed descriptions of the Planned Maintenance to be performed, the Days and times in which each type of Planned Maintenance is scheduled to be performed, the estimated amount(s) of Contract Capacity and Storage Capacity that will be unavailable due to Planned Maintenance and the total number of hours that Seller expects that the Contract Capacity and Storage Capacity will be unavailable due to Planned Maintenance. The general form for the Planned Maintenance Schedule is set forth in Schedule 9.6. (The Planned Maintenance descriptions reflected in the general form set forth in Schedule 9.6 are provided for indicative purposes only, and are not necessarily representative of the detail, time periods, or certainty required for a Planned Maintenance Schedule hereunder.) (c) Buyer shall have the right to disapprove, in its reasonable discretion (provided that Buyer shall have the right to disapprove, in its sole and absolute discretion, any Planned Maintenance proposed by Seller that is inconsistent with the terms of this Agreement), any Planned Maintenance set out in any Planned Maintenance Schedule proposed by Seller for any Contract Year, except for any Planned Maintenance that (i) is scheduled to occur outside of Daylight Hours or during Daylight Hours during the months of October and November or (ii) Seller is required to perform pursuant to any applicable manufacturer warranty and that is scheduled to occur in compliance with Section 9.6(a). If Seller submits its Planned Maintenance Schedule for a Contract Year in accordance with the requirements of this Agreement and Buyer does not disapprove of any Planned Maintenance set out in such Planned Maintenance Schedule by sixty (60) days after submission, then such Planned Maintenance Schedule shall be deemed approved. If Buyer, in the exercise of its discretion as set forth above, disapproves any Planned Maintenance in such Planned Maintenance Schedule within the applicable time period specified above after its submission, Buyer shall notify Seller and the Parties shall use Commercially Reasonable Efforts to agree upon and finalize a mutually acceptable Planned Maintenance Schedule for the applicable Contract Year. Seller shall conduct Planned Maintenance during such Contract Year only in accordance with an agreed Planned Maintenance Schedule; provided, however, that Seller may (A) move Planned Maintenance included in an agreed Planned Maintenance Schedule that is not Major Planned Maintenance, so long as such move is consistent with the terms of this Agreement (including the second sentence of Section 9.6(a)) or, with respect to Major Planned Maintenance, if such Major Planned Maintenance is scheduled to occur outside of Daylight Hours or during Daylight Hours during the months of October and November and (B) schedule and perform Planned Maintenance not reflected in the Planned Maintenance Schedule so long as such Planned Maintenance is scheduled to be performed outside of Daylight Hours or during Daylight Hours during the months of October and November and Seller provides Buyer at least two (2) weeks’ prior written notice of such Planned Maintenance; provided further that Buyer shall have the right to advise Seller of periods when Buyer prefers, based on solar irradiance, supply, market and other conditions, that any Major Planned Maintenance be deferred, and Seller shall use Commercially Reasonable Efforts to comply with such request. (d) Seller shall use Commercially Reasonable Efforts to complete any Planned Maintenance and place the Facility back into full commercial operation as soon as reasonably possible. If Seller determines that any Planned Maintenance scheduled in an agreed Planned Maintenance Schedule no longer needs to be completed or will not consume the entire time scheduled therefor in the agreed Planned Maintenance Schedule, Seller shall provide (i) a Generation Forecast to Buyer reflecting the forecasted amount of Delivered Energy during each affected interval that takes into account such change and (ii) in the case of any Major Planned Maintenance, a written notice declaring the cessation and termination of the applicable Major Planned Maintenance period (in which event, the Major Planned Maintenance period shall terminate in accordance with the terms of such Generation Forecast and written notice).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!