Offloading Sample Clauses

Offloading. 1. Upon receiving notification from the District of its need, the Suburban Us- ers shall: a. Within four (4) years following the date of the District's notification conduct whatever studies are deemed appropriate to develop the Offload- ing plan, site any required facilities and acquire all necessary permits and approvals. b. Within six (6) years following the date of the District's notification initiate construction of any facility that may be required to implement the Offloading plan. c. Within ten (10) years from the date of the District's notification make available to the District its additional need. 2. Should either Suburban User fail to comply with the provisions of Sections 7B1a, 7B1b, or 7B1c within the time periods specified, that User shall make no further commitments for sewer service that will increase its Wastewater Flows to Blue Plains until the Offloading plan is either back on schedule or implemented. Any Blue Plains Treatment Capacity Allocation of that User in excess of that required to treat the sum of its Actual Flow plus Committed Flow shall be placed in reserve until the Offloading plan is back on sched- ule or implemented. If the plan is not implemented within ten (10) years from date of the District's notification, this reserve shall, by operation of this Agreement, be allocated to the District and thereafter be available to the District for its use. 3. Failure to obtain federal and/or state grant funds shall not relieve a User of its obligation to comply fully with the provisions of Section 7B.
Sample 1
AutoNDA by SimpleDocs
Offloading. Where HC Heat effects delivery other than at its own premises the delivery shall be affected by the employees and/or contractors of the Applicant. Delivery shall be deemed to done before offloading. Offloading shall be for and at the Applicant’s sole risk. Should HC Heat’s employees and or contractors assist in the offloading, which assistance shall be in HC Heat’s sole discretion, all injury or damage of whatsoever nature caused as a result of or during the offloading, shall remain the sole risk of the Applicant. Any deviation from EXW shall be recorded in the COA and be: FCS = Free Carrier CPT = Carriage Paid To CIP = Carriage and Insurance Paid DPU = Delivery at Place Unloaded DDP = Delivery Duty Paid FAS = Free Alongside Ship FOB = Free on Board CFF = Cost and Freight CIF = Cost Insurance Freight All the above attracting the general and accepted commercial and practical application from time-to-time, at the time of acceptance of the quote.
Sample 1
Offloading a. Please ensure that there is adequate space for the van/lorry to park up and offload the Goods. b. Should there be no safe space for the van/lorry to park, the driver will use their sound judgement to park in the nearest safest place. c. The driver will not handle any Goods to your premises and it up to your responsibility to transport this to your desired safe place on your premises. d. We do not accept any liability for any damage caused in transportation from kerb to your premises.
Sample 1
Offloading handling and installation of electrical space and baseboard heaters and electrical controls and electrical components for HVAC systems.
Sample 1
Offloading. (a) The Customer shall be responsible for all offloading of Goods from whatever form of transport is employed.
Sample 1
Offloading. Seller will be responsible for the goods offloading from the truck (on truck foot) The personnel and materials expenses that may be necessary for the commissioning and perfect operation of the goods object of this contract will be at the cost of the seller. Comprehensive training will be given to your engineers, operators and maintenance personnel. Flights and hotel full board of the technician for the duration of the stay will be at the cost of the seller. Seller will be responsible for the installation and piping installation from the autoclave flange up to a maximum distance of 5 meters (being each elbow equivalent to 1 meter): Assembly of accessories that were removed for transportation Piping supply and installation related to lines that are not already connected in Olmar compact Plant configuration: o Autoclave pressurization / depressurization lines o Silencer to a safety place o Autoclave safety valves to a safety place o Instrumentation air for pneumatic valves *Round-trip air fare, hotel and subsistence for the duration of the stay are included Distance: 5 meters (being each elbow equivalent to 1 meter) Exclusions: Power connection from the transformation center to Olmar electrical cabinets which must be done by the client Air connection from the air factory line to Olmar pneumatic cabinets Building roof or wall penetrations Civil works, fences, building adaptations and anything else that is not clearly specified in this offer Local permits Anchoring autoclave saddle to the floor
Sample 1

Related to Offloading

  • Loading RPMG shall schedule the loading and shipping of all outbound corn oil purchased hereunder, but all labor and equipment necessary to load trucks and rail cars and other associated costs shall be supplied and borne by Producer without charge to RPMG. Producer shall handle the corn oil in a good and workmanlike manner in accordance with RPMG’s written requirements and normal industry practice. Producer shall maintain the truck and rail loading facilities in safe operating condition in accordance with normal industry standards and shall visually inspect all trucks and rail cars to assure (i) cleanliness so as to avoid contamination, and (ii) that such trucks and railcars are in a condition suitable for transporting the corn oil. RPMG and RPMG’s agents shall have adequate access to the Ethanol Facility to load Producer’s corn oil on an industry standard basis that allows RPMG to economically market Producer’s corn oil. RPMG’s employees shall follow all reasonable safety rules and procedures promulgated by Producer and provided to RPMG reasonably in advance and in writing. Producer shall supply product description tags, certificates of analysis, bills of lading and/or material safety data sheets that are applicable to all shipments. In the event that Producer fails to provide the labor, equipment and facilities necessary to meet RPMG’s loading schedule, Producer shall be responsible for all costs and expenses, including without limitation actual demurrage and wait time, incurred by RPMG resulting from or arising in connection with Producer’s failure to do so.

  • Transport The Parents consent to the Pupil travelling by any form of public transport and / or in a motor vehicle driven by a responsible adult who is duly licensed and insured to drive a vehicle of that type.

  • Storage The ordering agency is responsible for storage if the contractor delivers within the time required and the agency cannot accept delivery.

  • Pipelines Developer shall have no interest in the pipeline gathering system, which gathering system shall remain the sole property of Operator or its Affiliates and shall be maintained at their sole cost and expense.

  • Delivery Point The delivery point is the point of delivery of the Power Product to the CAISO Controlled Grid (the “Delivery Point”). Seller shall provide and convey to Buyer the Power Product from the Generating Facility at the Delivery Point. Title to and risk of loss related to the Power Product transfer from Seller to Buyer at the Delivery Point.

  • Leave Loading The employer and the individual employee must have genuinely made the agreement without coercion or duress.

  • Transportation Transportation expenses include, but are not limited to, airplane, train, bus, taxi fares, rental cars, parking, mileage reimbursement, and tolls that are reasonably and necessarily incurred as a result of conducting State business. Each State agency shall determine the necessity for travel, and the mode of travel to be reimbursed.

  • Delivery Points ‌ Project water made available to the Agency pursuant to Article 6 shall be delivered to the Agency by the State at the delivery structures established in accordance with Article 10.

  • Trash Tenant shall not allow anything to be placed on the outside of the Building, nor shall anything be thrown by Tenant out of the windows or doors, or down the corridors or ventilating ducts or shafts, of the Building. All trash and refuse shall be placed in receptacles provided by Landlord for the Building or by Tenant for the Premises.

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!