Reading of Meters Sample Clauses

Reading of Meters. (a) The Metering System shall continuously read the Net Energy Output of the Plant. Measurements of the Net Energy Output (active & reactive), MW, frequency, voltage etc. shall be electronically recorded on half hourly basis and shall be used for preparing monthly invoice (unless otherwise mutually agreed upon) . In the event the Metering System is not in service due to repair, testing or maintenance by Company, then the electronic record of the Net Energy Output from the Back-Up Metering System shall be used and the Company shall deliver a copy of the Back-Up Metering System record to BPDB with the relevant Monthly invoice(s). (b) Verifications and true-up of the Metering System and the Back-Up Metering System records shall be carried out at the next Monthly reading of the Metering System. BPDB, at its discretion may, by giving forty-eight (48) hours notice to the Company, request joint recording of the reading of the Metering System for verifying the electronically obtained readings provided such requests cannot be for more than two joint recording of the readings in any Month.
Sample 1Sample 2Sample 3See All (20)
AutoNDA by SimpleDocs
Reading of Meters. The meters and metering equipment and instruments owned by the Utility shall be read monthly by a representative of the Utility and a representative of the Authority. The Utility and the Authority shall agree upon a date or dates upon which the meters shall be read for billing purposes, and this date shall normally be the regular meter reading date of the Utility for the area in which said project is located.
Sample 1Sample 2Sample 3
Reading of Meters. (a) As per the CEA (Installation and Operation of Meters) Amendment Regulations 2010, reading of all meters interfacing with the State or Central transmission system, shall be the responsibility of the appropriate State or Central Transmission Utility, which shall also record the metered data, maintain database of all the information associated with the interface meters and verify the correctness of metered data and furnish the same to various agencies as per the procedure laid down by the Appropriate Commission in India. . (b) It shall be the responsibility of the Company to obtain due access to such meter reading information and provide a copy of the same to BPDB, along with the monthly invoice. Costs incurred by the Company to access or obtain such information, including those pertaining to nodal agency charges in India, shall be borne solely by the Company and shall not be separately reimbursed by BPDB.
Sample 1Sample 2
Reading of Meters. (a) As per the CEA (Installation and Operation of Meters) Amendment Regulations 2010, reading of all meters interfacing with the State or Central transmission system, shall be the responsibility of the appropriate State or Central Transmission Utility, which shall also record the metered data, maintain database of all the information associated with the interface meters and verify the correctness of metered data and furnish the same to various agencies as per the procedure laid down by the Appropriate Commission in India. . (b) It shall be the responsibility of the Company to obtain due access to such meter reading information and provide a copy of the same to BPDB, along with the monthly invoice. Costs incurred by the Company to access or obtain such information, including those pertaining to nodal agency charges in India, shall be borne solely by the Company and shall not be separately reimbursed by BPDB. (c) If BPDB requests access to electronic meter reading data, the Company shall liaise with the CTU or the respective STU in India to have the same provided to BPDB.
Sample 1Sample 2
Reading of Meters. 2.1 Procedures for billing purposes 2.1.1 The Main Metering Equipment shall be read monthly on the first Day of each month (or such other Day as may be agreed upon by the Parties) via remote connection for the purpose of determining the Energy Output of the Facility since the preceding reading. The Project Company shall give NEPCO at least two (2) Business Days' prior advance notice of the time the Project Company shall read the Metering System. In the event that a NEPCO representative is present at such reading of the Metering System for the purpose of measuring Energy Output, then such reading shall be jointly taken and recorded. 2.1.2 In the event that a NEPCO representative is not present at a reading of Energy Output, then the Project Company’s representative shall take and record such reading and make a photographic record thereof. The Project Company shall maintain a log of all such meter readings. Measurements recorded shall be delivered by the recording Party to the non-recording Party by facsimile within forty-eight (48) hours after the readings are taken. This shall not apply where the Metering System can be read remotely. 2.1.3 Subject to paragraph 2.1.4 and 2.1.5 the Energy Output of the Facility shall be determined using the Main Metering Equipment. 2.1.4 In the event that the Main Metering Equipment is not in service as a result of maintenance, repairs or testing, then the Check Metering Equipment, shall be used for the determination of Energy Output of the Facility during the period that the Main Metering Equipment is not in service to the extent that such equipment is available. 2.1.5 In case the Main Metering Equipment is not available and the Check Metering Equipment is also not available then the amounts of energy delivered may be calculated based on data from the SCADA system for the whole Facility or as a sum of individual wind turbines validated by an assessment of the wind speed, wind direction, other relevant meteorological data and the Estimated or Measured Facility Power Curve. Such assessment shall consider any Wind Turbines that might have been out of service or producing lower than calculated energy for any reason.
Sample 1
Reading of Meters. The Contractor will read the meters using the existing systems as detailed on the following grid:- Sycamores Heat 74 1 Larches Heat 74 1 Hawthorns Heat 74 1 Cruddas Park House Heat 159 1 Readings will be taken remotely for all installations by Radio. Meter readings will be imported into the Contractor’s billing system where they will be stored and archived for issue to the Authority on request.
Sample 1
Reading of Meters. 14.4.1 The Independent Engineer shall read each of the Primary Metering Systems at 23:59 hours on the last Day of each Month for the purpose of determining the Net Water Output managed by the Company up to the Output Water Connection Point since the last meter reading. The Company shall be entitled to have a representative present during any such reading. 14.4.2 The Independent Engineer shall make all records derived from the Metering Systems, Monitoring Systems, and the physical testing facilities, available to the Parties upon reasonable request for inspection and verification. 14.4.3 The metered data derived from the Primary Metering Systems and the Online Output Quality Monitoring System shall be telemetered to the distribution control system within the KWC, and, subject to clause 14.5.1, shall be used as the binding measurement of the Net Water Output delivered at the Output Water Connection Point. 14.4.4 The Company shall maintain and calibrate the Metering Systems and Monitoring Systems in accordance with the requirements of appendix 1.
Sample 1
AutoNDA by SimpleDocs
Reading of Meters 
Sample 1

Related to Reading of Meters

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Source of Measure Law No. 20 of 2008 Concerning Micro, Small and Medium Enterprises - Law No. 25 of 1992 Concerning Cooperatives

  • RECORDING OF AGREEMENT Tenant shall not record this Agreement on the Public Records of any public office. In the event that Tenant shall record this Agreement, this Agreement shall, at Landlord's option, terminate immediately and Landlord shall be entitled to all rights and remedies that it has at law or in equity.

  • Metering The Interconnection Customer shall be responsible for the Connecting Transmission Owner’s reasonable and necessary cost for the purchase, installation, operation, maintenance, testing, repair, and replacement of metering and data acquisition equipment specified in Attachments 2 and 3 of this Agreement. The Interconnection Customer’s metering (and data acquisition, as required) equipment shall conform to applicable industry rules and Operating Requirements.

  • Meters (a) You must allow safe and unhindered access to your premises for the purposes of reading and maintaining the meters (where relevant). (b) We will use our best endeavours to ensure that a meter reading is carried out as frequently as is needed to prepare your bills, consistently with the metering rules and in any event at least once every 12 months.

  • Recording of Overtime Employees shall record starting and finishing times for overtime worked in a form determined by the Employer.

  • Points of Interconnection and Trunk Types 2.1 Point(s) of Interconnection. 2.1.1 Each Party, at its own expense, shall provide transport facilities to the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA selected by PNG.

  • RECORDING OF SERVICE INSTRUCTIONS The Bank may (but shall not be obliged to) at its absolute discretion tape or otherwise record all Service Instructions, and the Account Holder agrees to the use of such tapes or recordings and any transcripts thereof which the Bank may make for any purpose that the Bank deems desirable, including their use as evidence in any proceedings against the Account Holder or any other person.

  • Delivery Point The delivery point is the point of delivery of the Power Product to the CAISO Controlled Grid (the “Delivery Point”). Seller shall provide and convey to Buyer the Power Product from the Generating Facility at the Delivery Point. Title to and risk of loss related to the Power Product transfer from Seller to Buyer at the Delivery Point.

  • Recording of calls We may record telephone conversations without use of a warning tone to ensure that the material terms of the Transaction, and any other material information relating to the Transaction is promptly and accurately recorded. Such records will be our sole property and accepted by you as evidence of the orders or instructions given.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!