Training Courses 16.4.1 Training courses, as well as the minimum and maximum numbers of trainees per course provided for the Buyer’s personnel, are defined in the applicable training course catalog published by ANACS (the “Training Course Catalog”) and will be scheduled as mutually agreed upon during a training conference (the “Training Conference”) that will be held as soon as practicable after signature of this Agreement and no later than May 31, 2007. AVA - A320 Family PA AMENDED AND RESTATED
16.4.2 The following terms will apply when training is performed ANACS:
(i) Subject to 16.4.2(ii) below, training courses will be standard Airbus courses as described in ANACS applicable Training Course Catalog valid at the time of execution of the course. ANACS will be responsible for all training course syllabi, training aids and training equipment (not to include aircraft) necessary for the organization of the training courses.
(ii) Where ANACS agrees to perform training using Buyer’s standard courses, Buyer will be responsible for taking all steps necessary to assure approval by applicable Aviation Authorities of such training (including any needed approvals of specific ANACS instructors).
(iii) The training curricula and the training equipment used for flight crew, cabin crew and maintenance training will not be fully customized but will be configured in order to obtain the relevant Aviation Authority’s approval and to support the Seller’s training programs. Notwithstanding the foregoing, the training curricula used for training performed under such circumstances shall enumerate any differences that exist between the non-customized material and Buyer’s detailed specification.
(iv) Training data and documentation necessary for training detailed in Appendix A to this Clause 16 will be and will not be revised. Training data and documentation will be marked “FOR TRAINING ONLY” and as such will be supplied for the sole and express purpose of training.
(v) Upon the request of the Buyer [*], the Seller will collect and pack for consolidated shipment to the Buyer’s facility, all training data and documentation of the Buyer’s trainees attending training at the Seller’s Training Center. This training data and documentation will be delivered [*]. It is understood that title to and risk of loss of the training data and documentation will pass to the Buyer [*].
16.4.3.1 If the Buyer decides to cancel fully or partially or reschedule, a training course, a minimum advance notification of at least [*] calendar days prior to the relevant training course start date is required.
16.4.3.2 If such notification is received by the Seller or ANACS less than [*] but more than [*] calendar days prior to such training, a cancellation fee corresponding to [*] of such training will be deducted from the training allowance defined in Appendix A to the extent sufficient allowance then remains, with any balance invoiced at the price corresponding to such training in the then current ANACS Customer Services Catalog.
16.4.3.3 If such notification is received by the Seller less than [*] calendar days prior [*] of such training will be deducted from the training allowance defined in Appendix A to the extent sufficient allowance then remains, with any balance invoiced at the price corresponding to such training in the then current ANACS Customer Services Catalog.
16.4.3.4 [*]
Trainings Appointment of any length involving two (2) or more Consumers who might need to split up to join different trainings, group discussions, etc.
First Aid Training In the interests of the occupational safety and health of employees, the Employer will undertake an in-service program of first aid training aimed at providing a first aid officer for each department.
Technical Training The CAISO and the Participating TOs shall respond to reasonable requests for support and provide relevant technical training to each other’s employees to support the safe, reliable, and efficient operation of the CAISO Controlled Grid and to comply with any NERC or WECC operator certification or training requirements. Examples of such technical training include, but are not limited to: (1) the theory or operation of new or modified equipment (e.g., control systems, Remedial Action Schemes, protective relays); (2) computer and applicator programs; and (3) CAISO (or Participating TO) requirements. The Parties shall enter into agreements regarding the timing, term, locations, and cost allocation for the training.
Training a. The employer, in consultation with the local, shall be responsible for developing and implementing an ongoing harassment and sexual harassment awareness program for all employees. Where a program currently exists and meets the criteria listed in this agreement, such a program shall be deemed to satisfy the provisions of this article. This awareness program shall initially be for all employees and shall be scheduled at least once annually for all new employees to attend.
b. The awareness program shall include but not be limited to:
i. the definitions of harassment and sexual harassment as outlined in this Agreement;
ii. understanding situations that are not harassment or sexual harassment, including the exercise of an employer's managerial and/or supervisory rights and responsibilities;
iii. developing an awareness of behaviour that is illegal and/or inappropriate;
iv. outlining strategies to prevent harassment and sexual harassment;
v. a review of the resolution of harassment and sexual harassment as outlined in this Agreement;
vi. understanding malicious complaints and the consequences of such;
vii. outlining any Board policy for dealing with harassment and sexual harassment;
viii. outlining laws dealing with harassment and sexual harassment which apply to employees in B.C.
Job Training The Employer and the Union shall establish a Joint Committee on Training and Skill Upgrading for the following purposes:
(1) for planning training programs for those employees affected by technological change;
(2) for planning training programs to enable employees to qualify for new positions being planned through future expansion or renovation;
(3) for planning training programs for those employees affected by new methods of operation;
(4) for planning training programs in the area of general skill upgrading. Whenever necessary, this Committee shall seek the assistance of external training resources such as the Federal Human Resources Development Canada and Provincial Ministry of Labour, or other recognized training institutions.
Travel time allowance All employees shall be paid an allowance (See Appendix A) for each day on which they present themselves for work. The allowance shall also be paid for rostered days off.
Training Allowance Operators who are required by the Employer to provide training to a specified level and to certify to the competency of the employees so trained shall receive twelve dollars ($12) per day while training. In such cases, the most senior qualified operator with the capability to provide training in the required class of equipment shall be given the opportunity to provide such training.
Travel Time Leave provided in paragraphs A and B of this Article shall apply to and cover actual and necessary travel to and from such meetings required during normal working hours on the day of the meeting or negotiations, except that MSEA-SEIU bargaining team members traveling 100 miles or more to negotiations shall be entitled to travel time outside of days of negotiations.
Training and Promotion a. The contractor will assist in locating, qualifying, and increasing the skills of minorities and women who are applicants for employment or current employees. Such efforts should be aimed at developing full journey level status employees in the type of trade or job classification involved.
b. Consistent with the contractor's work force requirements and as permissible under Federal and State regulations, the contractor shall make full use of training programs, i.e., apprenticeship, and on-the-job training programs for the geographical area of contract performance. In the event a special provision for training is provided under this contract, this subparagraph will be superseded as indicated in the special provision. The contracting agency may reserve training positions for persons who receive welfare assistance in accordance with 23 U.S.C. 140(a).
c. The contractor will advise employees and applicants for employment of available training programs and entrance requirements for each.
d. The contractor will periodically review the training and promotion potential of employees who are minorities and women and will encourage eligible employees to apply for such training and promotion.