Loaner Units. HPE maintains title and Customer shall have risk of loss or damage for loaner units if provided at HPE's discretion as part of Hardware Support or warranty services and such units will be returned to HPE without lien or encumbrance at the end of the loaner period.
Loaner Units. HP maintains title and you shall have risk of loss or damage for loaner units if provided at HP’s discretion as part of hardware support or warranty services and such units will be returned to HP without lien or encumbrance at the end of the loaner period.
Loaner Units. 3.7.1 LSI will loan NCR equipment for various purposes related to this Agreement (including, but not limited to, evaluation and benchmarking), and may loan NCR certain related hardware, software, firmware, documentation, and information for NCR's use with that equipment. The total value of the equipment permitted to be loaned to NCR is based on [*] ("Loaner Pool Value"). The value of any additional equipment permitted to be loaned over and above the Loaner Pool Value shall be calculated at [*]. Such limitations may be changed at any time upon mutual written agreement of the parties. Any such change shall not affect loaned equipment in NCR's possession as of the effective date of such change, which equipment NCR shall be permitted to continue to use until the expiration of the applicable loan period. In the event that the total value of the equipment loaned to NCR is permitted to [*], NCR shall pay to [*] which needs to be approved by NCR. [*]. Each piece of equipment may be used by NCR for a period of [*] commencing on the date of shipment by LSI and ending upon the date of return of the equipment to LSI. NCR shall issue orders for these loaner units from a single point of contact. When returned to LSI, the units will be refurbished to "as-new" condition and will have the same warranty as a new unit. Refurbishment charges to NCR will not exceed [*] per module. Units refurbished by LSI will be completely updated to the latest revision levels. Returned units are also subject to actual drive erosion charges, to the extent that such charges are stated in the applicable Equipment Request for NCR (of the type marked Exhibit I and attached hereto) which has been signed by NCR and LSI, which will be specified in the individual "Equipment Request for NCR" form issued by LSI in conjunction with each loan. If a loaner unit is not returned within [*], LSI will invoice NCR for the loaner unit(s) at full NCR OEM value and the loaner return will not be accepted at the LSI factory. NCR shall be responsible for shipping charges for the initial shipment out and the return shipment associated with all loaner equipment.
Loaner Units. (a) The Customer may request that FMSU lend it endoscope units (collectively, the “Loaner Units”) on a temporary basis to be utilized at the Customer’s site solely while FMSU is repairing the Equipment. FMSU is not obligated to provide the Customer with Loaner Units, but shall endeavor to do so if Loaner Units are available. If FMSU agrees to provide the Customer with Loaner Units, (i) the additional terms and conditions set forth on Attachment 1 hereto shall apply, which Attachment 1 is incorporated herein by reference, and (ii) FMSU shall ship the Loaner Units to the Customer by FMSU’s standard method of delivery with freight pre-paid.
Loaner Units. Should the Services include provision of a loaner unit for the duration of the Servicing of the IKA Device(s) concerned, Client shall be responsible to (i) ensure that the loaner unit is operated only by suitably competent staff, duly instructed with its safe operation in accordance with IKA’s operating manuals;
Loaner Units. EPG will provide a loaner unit should repair downtime be more than five (5) consecutive normal workdays. All costs associated with securing and delivering the relief unit shall be at EPG's expense, with no cost to the Customer. The relief unit must be functionally equivalent to its replacement.
Loaner Units. As part of Neoprobe’s warranty obligation described in Sections 11.1 and 11.2, Neoprobe agrees at no cost to Ethicon to (a) provide loaner units to Ethicon’s customers within two (2) business days of notification; and (b) to repair and return or replace products under warranty within twenty (20) days from the date of receipt of such return during, unless otherwise agreed to by Ethicon. Neoprobe shall provide Ethicon with a procedure for handling customer returns for servicing and repairing Products covered under the warranty obligations described in Sections 11.1 and 11.2 within thirty (30) days of the Effective Date.
Loaner Units. During the warranty period, in the event the actual Quarterly Failure Rate for a Product purchased hereunder exceeds the Target Reliability Percentages set forth in the table below, then at XPLORE’s written request, and in addition to any additional spares provided under Section 11.1, WISTRON shall supply XPLORE, at no cost to XPLORE, a quantity of Products on loan or bailment in that specific product category (“Loaner Units”). The quantity being determined in accordance with the following formula: Number of Loaner Units = (Unit failures in excess of the Target) times ((number of turn days [5 days per month [20])). Illustrative example: Assuming 10,000 units in the field with a 1100 quarterly failure rate, then; if the target quarterly failures = 1000 units (e.g. 10% of 10,000< the result is; number of loaner units = (1100-1000)*(5/20) = 25 loaner units. Target Reliability Percentages Period after Product Release Average Quarterly Failure Rate Average DOA Failure Rate First 6 months 10% 2.0% Second 6 months 8% 2.0% Exhibit G Service and Support Addendum of the Turnkey Design and Manufacturing Agreement between WISTRON and XPLORE
Loaner Units. Loaner units are not part of SprintRay, Inc.’s standard distribution agreement unless covered under an applicable Service Warranty. Loaner Units may however be allocated to key partners, institutions, or other entities as part of approved research projects, case studies, or concept validation exercises. Loaner Units if applicable to this agreement are set forth in the Addendum C. SprintRay, Inc. 0000 Xxxxx Xxxxxx Xx Los Angeles, CA 90065
Loaner Units. During the warranty period, in the event the actual Monthly Failure Rate for a METROLOGIC Purchasable Product purchased hereunder exceeds the Target Reliability Percentages Set forth in Section 13.4 then at SYMBOL's written request, METROLOGIC shall supply SYMBOL, at no cost to SYMBOL, the number of loaner units for that specific product category ("Loaner Units") determined in accordance with the following formula: Number of Loaner Units = (Monthly failures in excess of the Target) times ((number of turn days [2](days per month [20])). Illustrative example: Assuming 10,000 units in the field with a 350 monthly failure rate, then; if the target monthly failures = 200 units (e.g. 2% of 10,000{ the result is; number of loaner units = (350-200)*(2/20) = 15 loaner units.