Permits and Codes. The Contractor shall obtain the Contracting Officer’s approval of the machinery and mechanical and other (a) The Contractor shall give all notices and comply with all equipment to be incorporated into the work. When applicable laws, ordinances, codes, rules and regulations. requesting approval, the Contractor shall furnish to the Notwithstanding the requirement of the Contractor to Contracting Officer the name of the manufacturer, the comply with the drawings and specifications in the model number, and other information concerning the contract, all work installed shall comply with all applicable performance, capacity, nature, and rating of the codes and regulations as amended by any waivers. Before installing the work, the Contractor shall examine the drawings and the specifications for 14. Temporary Heating compliance with applicable codes and regulations bearing on the work and shall immediately report any The Contractor shall provide and pay for temporary discrepancy it may discover to the Contracting Officer. heating, covering, and enclosures necessary to properly Where the requirements of the drawings and protect all work and materials against damage by specifications fail to comply with the applicable code or dampness and cold, to dry out the work, and to facilitate regulation, the Contracting Officer shall modify the the completion of the work. Any permanent heating contract by change order pursuant to the clause entitled equipment used shall be turned over to the PHA in the Changes herein to conform to the code or regulation. condition and at the time required by the specifications.
Permits and Codes. Contractor agrees to secure and pay for all necessary permits and licenses required for Contractor’s Performance and to adhere to applicable local codes and requirements whether or not covered by the specifications and drawings for the work, including any Contractor registration requirements.
Permits and Codes. (1) The Contractor shall obtain the Contracting Officer’s approval of the machinery and mechanical and other equipment to be incorporated into the work. When requesting approval, the Contractor shall furnish to the Contracting Officer the name of the manufacturer, the model number, and other information concerning the performance, capacity, nature, and rating of the
Permits and Codes. (1) The Contractor shall obtain the Contracting Officer’s approval of the machinery and mechanical and other equipment to be incorporated into the work. When requesting approval, the Contractor shall furnish to the Contracting Officer the name of the manufacturer, the model number, and other information concerning the performance, capacity, nature, and rating of the
(a) The Contractor shall give all notices and comply with all applicable laws, ordinances, codes, rules and regulations. Notwithstanding the requirement of the Contractor to comply with the drawings and specifications in the contract, all work installed shall comply with all applicable codes and regulations as amended by any waivers. Before installing the work, the Contractor shall examine the drawings and the specifications for compliance with applicable codes and regulations bearing on the work and shall immediately report any discrepancy it may discover to the Contracting Officer. Where the requirements of the drawings and specifications fail to comply with the applicable code or regulation, the Contracting Officer shall modify the contract by change order pursuant to the clause entitled Changes herein to conform to the code or regulation.
(b) The Contractor shall secure and pay for all permits, fees, and licenses necessary for the proper execution and completion of the work. Where the PHA can arrange for the issuance of all or part of these permits, fees and licenses, without cost to the Contractor, the contract amount shall be reduced accordingly.
Permits and Codes. The Owner shall obtain all necessary building permits, including those required by the <MUNICIPALITY>, <STATE AGENCY>, and Act 250 as applicable. The Contractor will secure at his/her own expense any other necessary permits and licenses required to do the work and will comply with all building and code regulations and ordinances whether or not covered by the specifications and drawings for the work.
Permits and Codes. (a) The Contractor shall give all notices required by and comply with all applicable federal and state laws, ordinances, and codes of the Local Government. All construction work and/or utility installations shall comply with all applicable ordinances, and codes including all written waivers. Before installing any work, the Contractor shall examine the drawings and technical specifications for compliance with applicable ordinances and codes and shall immediately report any discrepancy to Xxxx County. Where the requirements of the drawings and technical specifications fail to comply with such applicable ordinances or codes, Xxxx County will adjust the Contract by Change Order to conform to such ordinances or codes (unless waivers in writing covering the difference have been granted by the governing body or department) and make appropriate adjustment in the Contract Price or stipulated unit prices.
(b) Should the Contractor fail to observe the foregoing provisions and proceed with the construction and/or install any utility at variance with any applicable ordinance or code, including any written waivers (notwithstanding the fact that such installation is in compliance with the drawings and technical specifications), the Contractor shall remove such work without cost to Xxxx County.
(c) The Contractor shall at his own expense, secure and pay for all permits for street pavement, sidewalks, shed, removal of abandoned water taps, sealing of house connection drains, pavement cuts, buildings, electrical, plumbing, water, gas and sewer permits required by the local regulatory body or any of its agencies.
(d) The Contractor shall comply with applicable local laws and ordinances governing the disposal of surplus excavation, materials, debris and rubbish on or off the Project Area and commit no trespass on any public or private property in any operation due to or connected with the Improvements contained in this Contract.
(e) The Contractor will be required to make arrangements for and pay the water, electrical power, or any other utilities required during construction.
(f) During construction of this project, the Contractor shall use every means possible to control the amount of dust created by construction. Prior to the close of a day's work, the Contractor, if directed by Xxxx County, shall moisten the surrounding area to prevent a dusty condition.
Permits and Codes. All permits and licenses necessary for the completion and execution of the work shall be secured and paid for by the Contractor. All work shall be done in conformance with applicable laws, ordinances, and municipal codes. The Contractor is responsible for providing any and all information required to secure approval for all necessary permits and licenses. The Contractor shall provide the LPA with a copy of any permits required. Should the Contractor perform work without securing the necessary permits or licenses, they shall bear all costs and liabilities arising therefrom.
Permits and Codes. (a) The Contractor shall give all notices and comply with all applicable laws, ordinances, codes, rules and regulations. Notwithstanding the requirement of the Contractor to comply with the drawings and specifications in the contract, all work installed shall comply with all applicable codes and regulations as amended by any waivers. Before installing the work, the Contractor shall examine the drawings and the specifications for compliance with applicable codes and regulations bearing on the work and shall immediately report any discrepancy it may discover to the Contracting Officer. Where the requirements of the drawings and specifications fail to comply with the applicable code or regulation, the Contracting Officer shall modify the contract by change order pursuant to the clause entitled Changes herein to conform to the code or regulation.
(b) The Contractor shall secure and pay for all permits, fees, and licenses necessary for the proper execution and completion of the work. Where the PHA can arrange for the issuance of all or part of these permits, fees and licenses, without cost to the Contractor, the contract amount shall be reduced accordingly.
Permits and Codes. Lessee shall not discriminate in use of Premises against any person because of race, creed, color, religion, or national origin.
Permits and Codes. Unless otherwise set out in the specifications or required by the agencies involved, the Contractor shall make application for, obtain and pay for all licenses and permits necessary for the prosecution of the Work and shall pay for all fees and charges in connection therewith. The Contractor shall be required to comply with all state or municipal ordinances, laws, and/or codes in so far as the same are binding on the Owner.
