Energy Conservation Measures Sample Clauses

Energy Conservation Measures a. Insulation of roofs, crawl spaces, ceilings, attics, floors and around pipes/ducts as long as these measures do not induce, retain, or introduce moisture into a building, utilization of spray foam insulation is not covered under this agreement and must be reviewed in accordance with 36 CFR Part 800. b. Caulking and weather stripping consistent with appearance of the building. c. Installation of radiant barriers in unoccupied attic spaces. d. Installation of solar panels not visible from the public right-of-way. APPENDIX B DEFINITIONS
Sample 1
AutoNDA by SimpleDocs
Energy Conservation Measures. 3.1 Performance of the Work ESP shall perform or cause to be performed the Work in strict accordance with the Contract Documents. The Work shall also include whatever is done by or required of ESP to perform and complete its duties under the Contract Documents, including but not limited to the following: the provision or furnishing of labor, supervision, services, materials, supplies, equipment, fixtures, appliances, facilities, tools, transportation, storage, power, permits and licenses required, and fuel, heat, light, cooling and all other utilities as required by this Agreement. Notwithstanding the preceding sentence, ESP may request Owner to provide power, fuel, heat, cooling, or other utilities. Upon such request Owner may, in its sole and complete discretion, elect to provide such utilities at a price set by Owner, but Owner shall have no obligation to provide such utilities. If Owner elects to provide such utilities, ESP shall indemnify, hold harmless, and defend Owner against any damages, losses, or expenses arising from ESP’s use of Owner’s facilities or utilities at the Premises. No later than INSERT DAYS days after execution of this Agreement, ESP shall provide detailed drawings and specifications concerning the ECMs and associated equipment and materials, and all impacted areas of the Premises, for Owner’s review and comment. Such documents shall become the property of Owner without restriction. ESP shall make such reasonable modifications to the drawings and specifications as Owner may require. Upon Owner’s approval of the drawings and specifications, ESP shall proceed to provide ECM Submittals as set forth in Section 3.4. Owner’s approval of any drawings, specifications, or submittals shall not be evidence that such documents, and associated Work pursuant thereto, conform to the requirements of the Contract Documents, nor shall such approval relieve or diminish in any way ESP’s obligation to comply with the Contract Documents. 3.2 ESP’s Responsibility for the Work ESP shall perform all Work strictly in conformance with the Contract Documents. Compliance with the Contract Documents shall be and remain the responsibility of ESP. Owner or its representatives and consultants may review, inspect, and test the Work from time to time. Any review, approval, testing, or acceptance of, or payment for, any or all of the Work shall not relieve ESP of its responsibility for the Work and compliance with the Contract Documents. 3.3 Standards of the Work ESP...
Sample 1
Energy Conservation Measures. The Project shall include the following energy conservation measures which are currently requirements of the SMMC. Nothing in this Section 2.7.14 shall preclude the City from applying Subsequent Code Changes permitted in accordance with Section 5.2. (a) Consistent with EIR Section 4.9.3.4, the Project shall be designed to be five percent (5%) more efficient than the code established by the 2019 California Energy Code. (b) Developer shall install a photovoltaic (PV) system that has a minimum total wattage of 2.0 times the square footage of the building’s footprint (2.0 xxxxx per square foot of building footprint) in accordance with SMMC 8.160.080; (c) For new pool construction in the Project, if the pool is to be heated, an electric heat pump water heater or a solar thermal system shall be used for such heating in accordance with SMMC 8.106.080, or successor thereto; and (d) The Project shall include the following electric vehicle charging infrastructure in the parking areas of the Subterranean Space in accordance with SMMC 4.106.4: (i) EV chargers in forty-three (43) parking spaces, (ii) Infrastructure to make an additional twenty six (26) parking spaces EV Ready (breaker, wiring, panel capacity, receptacle and raceways and associated conductors capable of accommodating 208/240-volt dedicated branch circuits), and (iii) Raceways/conduits and associated conductors capable of accommodating 208/240-volt dedicated branch circuits in an additional one hundred eighty-two (182) parking spaces.
Sample 1
Energy Conservation Measures. This project consists of the design and construction of energy conservation measures on the Carbondale campus. The conservation measures would consist of a combination of high efficiency lighting and plumbing upgrades, high efficiency HVAC components, energy management system upgrades, as well as miscellaneous items such as high efficiency motors and occupancy sensors.
Sample 1
Energy Conservation Measures. This project consists of the design and construction of energy conservation measures on the Springfield campus. The conservation measures could consist of, but are not limited to, upgrades to or replacement of components for the lighting, heating, air conditioning, temperature control, mechanical, energy management control, and domestic water. A guaranteed energy savings contract will be requested of the provider(s) so that guaranteed savings are in amount which are anticipated to be sufficient to pay the cost of that portion of the annual Installment Payments relating to this project. INDENTURE OF TRU U.S. BANK NATIONAL ASSO TION, as Trust Dated as of February 1, 2014 Draft.Indenture.doc 2212033 • AGB • 11/1/13 INDENTURE
Sample 1
Energy Conservation Measures. The PMSA shall report conditions that are contrary to energy/water efficiency and shall recommend energy conservation measures, discovered during Scheduled Maintenance and when processing a DMO or IJO.
Sample 1
Energy Conservation Measures. In progress. Carollo completed the initial investigations in 2020. The 2021 task effort includes additional coordination work with Nexant and SRP related to energy conservation and power monitoring. Carollo investigated alternative energy generation, energy reduction, and automation opportunities at each plant. As part of this effort, Carollo identified energy conservation measures (ECMs) that reduce energy use in areas like process controls, lighting, pumps, and motors.
Sample 1
AutoNDA by SimpleDocs
Energy Conservation Measures. During the Contract Documents Phase consisting of preparation of final mechanical engineering calculations, Drawings and Specifications based on approved Design Development Documents, setting forth in detail the mechanical construction requirements for the Project.
Sample 1

Related to Energy Conservation Measures

  • Energy Conservation The Contractor agrees to comply with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

  • Energy Policy and Conservation Act Both parties hereby agree to comply with all mandatory standards and policies relating to energy efficiency, which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act (Pub. L. 94-163, 89 Stat. 871).

  • ENERGY POLICY AND CONSERVATION ACT COMPLIANCE To the extent applicable, Supplier must comply with the mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

  • Conservation Operations hereunder and production of unitized substances shall be conducted to provide for the most economical and efficient recovery of said substances without waste, as defined by or pursuant to State or Federal law or regulation.

  • Certification of Compliance with the Energy Policy and Conservation Act When appropriate and to the extent consistent with the law, Vendor certifies that it will comply with the Energy Policy and Conservation Act (42 U.S.C. 6321 et seq; 49 C.F.R. Part 18) and any mandatory standards and policies relating to energy efficiency which are contained in applicable state energy conservation plans issued in compliance with the Act. Does Vendor agree? Yes

  • COMMON UTILITIES Expenses for serving/supply of common facilities and utilities and all charges incidental thereto.

  • Department of Housing and Urban Development Iowa Civil Rights Commission 000 Xxxx 00xx Xxxxxx

  • Health and Safety Plan Consultant shall prepare and submit a Health and Safety Plan (“HASP”) for the portion of Consultant’s work that will involve field work, assessments, or investigations of certain Project elements. The HASP shall describe how Consultant plans to complete field work, assessments, and/or investigations at the RWF. Consultant’s HASP must comply with the CIP HASP and shall be updated as new conditions are encountered.

  • Pollution Control The Employer and the Union agree to limit all forms of environmental pollution.

  • HEALTH AND SAFETY 25.01 The Employer is subject to the provisions of the Occupational Health and Safety Act of the Province of Ontario and its regulations, including the provision that calls for a worker representative selected by the Union on the University Joint Health and Safety Committees. It is agreed that the University and the Union will cooperate to the fullest possible extent in the prevention of accidents and the promotion of safety and health at University workplaces. To this end, the parties acknowledge and agree that all University Employees on University and third-party premises where Employees work, are required to comply with work- site specific policies, procedures, regulations, and standards relating to health and safety. 25.02 The Employer recognizes the right of workers to be informed about hazards in the workplace, to be provided with appropriate training, and the right to refuse unsafe work in accordance with the Occupational Health and Safety Act where there is an immediate danger to the Employee’s health and safety or to the health and safety of others. 25.03 The Union will select a worker representative for each applicable Joint Health and Safety Committee formed under the Occupational Health and Safety Act. Time spent attending meetings of the Committee or carrying out duties as a worker representative shall be considered time worked. 25.04 A worker representative on a Joint Health and Safety Committee may become a certified worker representative on the Committee. The University will provide the required training for certification at no cost to the Employee or the Union. Time spent in such training shall be considered time worked, as outlined in Article 13 – Hours of Work and Overtime. 25.05 When a worker representative on a Joint Health and Safety Committee ceases to be employed in the Bargaining Unit, he/she will cease to be a worker representative on the Committee. 25.06 The University will supply, and Employees will wear and/or utilize, personal protective equipment and the other devices that the University requires Employees to wear and/or utilize. 25.07 The Employer shall provide information, training and supervision to an Employee to protect the health and safety of that Employee. With reference to Article 13, time spent in such training shall be considered time worked, as outlined in Article 13 – Hours of Work and Overtime. 25.08 The name and contact information of the Health and Safety Officer in each Academic Unit shall be posted in the Department/Academic Unit. 25.09 In accordance with the Occupational Health and Safety Act, persons with authority in the workplace, including any Employees, shall ensure that persons under their authority are informed of health and safety hazards, and advised of policies and procedures associated with the safe handling of materials and equipment.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!