Equipment to be Used by Contractor Sample Clauses

Equipment to be Used by Contractor a) Contractor shall furnish, and maintain in a neat, clean, and sanitary condition, enclosed modern collection equipment approved by the Village for use in performing the Work. Contractor may use replacement, open trucks on a temporary basis in case of emergency, but only with the prior express written approval of the Village. No vehicle used in the performance of this contract shall have a gross vehicle weight rating (GVWR) of greater than 55,000 pounds. All vehicles shall be maintained in good working order and appearance, free of rust, and shall be clean at the start of each collection day. In the event that any vehicle is not properly operable, a substitute vehicle shall immediately be provided that complies with the terms herein. All vehicles shall display the name of the Contractor, a local phone number, and a vehicle identification number that is clearly visible on both sides. No vehicle shall be operated on a Village street that leaks any fluids from the engine or compaction mechanism. All vehicles shall be fully enclosed and operated in such a way that no waste leak, spill or blow off the vehicles. Should any waste leak, spill or blow off a vehicle due to the vehicle operator’s failure to properly monitor the load or to close opening, or due to failure of any mechanism, the Contractor shall be responsible for collecting or cleaning up such litter or fluids. If such litter or fluids are not cleaned up after notice (verbal or written) from the Village, the Village may clean up same, and the Village may xxxx the cost to the Contractor for services rendered. Drain plugs, if available, shall be kept closed except during collections in rainy weather. All vehicles shall be made available for inspection during regular business hours at the request. Contractor may use replacement, open trucks on a temporary basis in case of emergency, but only with the prior express written approval of the Village. b) Contractor acknowledges the desire of the Village to promote the use of alternative fuels and agrees to give priority to the Village in deploying its vehicles that use fuels other than conventional gasoline and diesel. c) Containers used in connection with the provision of Residential Services by the Contractor pursuant to this Agreement shall be operable, safe and free of graffiti. Contractor shall replace any container in disrepair of this sort within three (3) days of notification by the Village or the customer. Containers with plastic lids that are ill-fi...
Sample 1See All (7)
AutoNDA by SimpleDocs
Equipment to be Used by Contractor. The Contractor agrees to collect all materials described in Section 4.1 in fully enclosed, leak-proof, modern trucks. The District shall have the right to inspect all vehicles to ensure that the vehicles are safe and capable of collecting solid waste and other material.
Sample 1Sample 2
Equipment to be Used by Contractor a) The Contractor agrees to collect all materials described in Section 4.1 in fully enclosed, leak-proof, modern trucks. All vehicles and collection equipment will be kept in safe, operable condition. Any equipment that is used by the Contractor, that is determined to be unsafe, or in an overall poor condition by the Municipality, shall be replaced at the request of the Municipality. Equipment used for Private Service described in Section 4.3 may be open-body trucks, dump trucks and similar type equipment. When open-body trucks are used, the Contractor shall take such action as is necessary to prevent littering and blowing debris. b) Containers used under the franchised service shall be operable, safe and free of graffiti. Any container in disrepair of this sort shall be replaced within three (3) days of notification by the Municipality. Containers with plastic lids that are ill-fitted due to obolences or warping shall be replaced within three (3) days of notification by the Municipality, in order to maintain a tight fitting seal to prevent access for pests. All containers will be adequately demarcated with the Contractor's logo. Each container will have an inventory control number demarcated on each container that is cross-referenced to the service matrix.
Sample 1
Equipment to be Used by Contractor a) The Contractor agrees to collect all materials described in Article V of this Agreement in fully enclosed, leak-proof, modern trucks. All vehicles and collection equipment will be kept in safe, operable condition. Any equipment that is used by the Contractor and determined to be unsafe, or in an overall poor condition by the City shall be replaced at the request of the City. b) Containers used in connection with the provision of Residential Services by the Contractor pursuant to this Agreement shall be operable, safe and free of graffiti. Contractor shall replace any container in disrepair of this sort within three (3) days of notification by the City. Containers with plastic lids that are ill-fitted or warping shall be replaced within three (3) days of notification by the City, in order to maintain a tight-fitting seal to prevent access by pests. All containers will be adequately demarcated with the Contractor’s logo. Each container will have an inventory control number demarcated on each container that is cross-referenced to the service matrix. c) All equipment used by Contractor for the provision of Residential Services and Private Services pursuant to this Agreement shall be properly licensed by the State and shall conform to all federal and State equipment safety standards.
Sample 1
Equipment to be Used by Contractor. The Contractor agrees to collect all materials described in Section 4.1 in fully enclosed, leakproof, modern trucks. For the collection of Recyclable Materials, the Contractor shall use trucks specifically designed for recycling service. The Contractor shall provide an adequate number of vehicles for regular collection and recyclable materials collection services. All vehicles shall be kept in good repair, appearance, and maintained in a sanitary condition at all times. Each vehicle shall have clearly visible on each side the name, a vehicle identification number, and local phone number of the Contractor. Vehicles shall not leak fluids, oil, hydraulic fluids, etc. If found to do so, they shall be repaired by the Contractor within ten (10) business days of reported incident or of knowledge by the Contractor. A listing of vehicles to be utilized in carrying out this Agreement shall be provided to the Village Manager upon request throughout the term of the Agreement and he shall be advised of any changes made. Vehicles shall be capable of delivering material directly to a disposal site or processing center. In the event any listed vehicle is determined by the Village or otherwise not properly operable, the Contractor shall immediately provide a substitute complying with the terms outlined herein. Equipment used for Private Service described in Section 4.3 may be open-body trucks, dump trucks, and similar type equipment. When open-body trucks reused, the Contractor shall take such action as is necessary to prevent littering.
Sample 1
Equipment to be Used by Contractor a) The Contractor agrees to collect all materials described in Article V of this Agreement in fully enclosed, leak-proof, modern trucks. All vehicles and collection equipment will be kept in safe, operable condition. Any equipment that is used by the Contractor and determined to be unsafe, or in an overall poor condition by the City shall be replaced at the request of the City. Equipment used for Private Service described in Section 4.4 of this Agreement may be open-body trucks, dump trucks and similar type equipment when necessary. When open-body trucks are used, the Contractor shall take such action as is necessary to prevent littering and blowing debris. b) Containers used in connection with the provision of Residential Services by the Contractor pursuant to this Agreement shall be operable, safe and free of graffiti. Contractor shall replace any container in disrepair of this sort within three (3) days of notification by the City. Containers with plastic lids that are ill-fitted or warping shall be replaced within three (3) days of notification by the City, in order to maintain a tight fitting seal to prevent access by pests. All containers will be adequately demarcated with the Contractor’s logo. Each container will have an inventory control number demarcated on each container that is cross-referenced to the service matrix. c) All equipment used by Contractor for the provision of Residential Services and Private Services pursuant to this Agreement shall be properly licensed by the State and shall conform to all federal and State equipment safety standards.
Sample 1
Equipment to be Used by Contractor. The CONTRACTOR agrees to collect all municipal waste in fully enclosed leak-proof modern packer-type trucks. Equipment used for special pick-up service may be open body trucks, dump trucks, and similar type equipment. When open body trucks are used, the CONTRACTOR will use care to see that no litter or scattering of waste material occurs by providing a suitable covering.
Sample 1
AutoNDA by SimpleDocs

Related to Equipment to be Used by Contractor

  • By Contractor Should the Contractor be liable for any payments to the State hereunder, interest, late payment charges and collection fee charges will be determined and assessed pursuant to Section 18 of the State Finance Law.

  • Services to be performed by Contractor In consideration of the payments set forth herein and in Exhibit “B,” Contractor shall perform services for County in accordance with the terms, conditions and specifications set forth herein and in Exhibit “A.”

  • Claim by Contractor After receipt of the Notice of Termination from the state, the Contractor shall submit any claim for additional costs not covered herein or elsewhere in the Contract within 60 days of the effective termination date, and not thereafter. Should the Contractor fail to submit a claim within the 60-day period, the State may, at its sole discretion, based on information available to it, determine what, if any, compensation is due the Contractor and pay the Contractor the determined amount.

  • Contract Work Contract work means capital project work within existing plant facilities, major maintenance and/or revamp work, plant modifications and/or shutdown work, minor maintenance and/or repair work, breakdown maintenance.

  • Personnel Equipment and Material Engineer shall furnish and maintain, at its own expense, quarters for the performance of all Engineering Services, and adequate and sufficient personnel and equipment to perform the Engineering Services as required. All employees of Engineer shall have such knowledge and experience as will enable them to perform the duties assigned to them. Any employee of Engineer who, in the reasonable opinion of County, is incompetent or whose conduct becomes detrimental to the Engineering Services shall immediately be removed from association with the Project when so instructed by County. Engineer certifies that it presently has adequate qualified personnel in its employment for performance of the Engineering Services required under this Contract, or will obtain such personnel from sources other than County. Engineer may not change the Project Manager without prior written consent of County.

  • Equipment and Materials CONTRACTOR shall provide all equipment, materials, and supplies necessary for the performance on the Agreement except:

  • Student Data to Be Provided In order to perform the Services described in this Article and Exhibit “A”, LEA shall provide the categories of data described in the Schedule of Data, attached hereto as Exhibit “B”.

  • SERVICES TO BE PROVIDED BY CONSULTANT 1.1 In compliance with all of the terms and conditions of this Agreement, CONSULTANT shall provide to ANAHEIM all labor, materials, tools, equipment, services, and incidental and customary work necessary to fully and adequately supply the professional consulting services necessary for the Services when required by ANAHEIM. The Services are more particularly described in the General Scope of Work attached hereto as Exhibit A and incorporated herein by this reference (“General Scope of Work”). In addition to the General Scope of Work, the Services will also be described in a Request for Work Order Proposal (“RFWOP”) and in a Notice to Proceed, as described in Section 1.4. ANAHEIM may elect to delete certain tasks of the General Scope of Work or the RFWOP at its sole discretion. The Services will not be performed by the CONSULTANT until ANAHEIM selects CONSULTANT in accordance with this Section 1. If selected, CONSULTANT shall perform the Services as directed by ANAHEIM and in accordance with the RFWOP, the Notice to Proceed, and this Agreement. By entering into this Agreement, ANAHEIM does not guarantee CONSULTANT that ANAHEIM will select CONSULTANT to provide any Services under this Agreement. 1.2 When the Services are required, ANAHEIM will issue an RFWOP in writing or electronically for the project-specific Services, including a specific scope of work, schedule for completion of the Services, task specifications, name of the Project Administrator, and other data specific to that RFWOP. CONSULTANT shall submit, within the time stated in the RFWOP, a sealed Work Order Proposal (“Work Order Proposal”) indicating the cost, task completion schedule, and other information requested in that RFWOP. CONSULTANT shall submit an electronic sealed Work Order Proposal when it is required by the RFWOP, and CONSULTANT shall abide by all RFWOP electronic proposal requirements. 1.3 For any RFWOP with an anticipated fee : (i) under $50,000, ANAHEIM will send, in writing or electronically, the RFWOP to one (1) pre-qualified consultant, which may or may not include CONSULTANT; (ii) of $50,000 to $150,000, ANAHEIM will send, in writing or electronically, the RFWOP to up to three (3) pre-qualified consultants, which may or may not include CONSULTANT; (iii) of $150,000 and up to $250,00, ANAHEIM will send, in writing or electronically, the RFWOP to up to five (5) pre-qualified consultants, which may or may not include CONSULTANT. ANAHEIM does not give any guarantee to CONSULTANT that ANAHEIM will send such an RFWOP to CONSULTANT at any point during the term of this Agreement. If (a) ANAHEIM sends CONSULTANT an RFWOP and (b) CONSULTANT desires to be considered for the RFWOP, CONSULTANT shall submit, within the time stated in the RFWOP, a sealed Work Order Proposal indicating the cost, task completion schedule, and other information requested in that RFWOP. CONSULTANT shall submit an electronic sealed Work Order Proposal when it is required by the RFWOP, and CONSULTANT shall abide by all RFWOP electronic proposal requirements. 1.4 Selection of a prequalified consultant to complete the Services requested in any RFWOP shall be based on the criteria set forth herein. ANAHEIM will issue a Notice to Proceed (“Notice”) to the successful consultant who has submitted a Work Order Proposal. The Notice and the RFWOP shall constitute the “Work Order”. If CONSULTANT fails to promptly commence work and/or diligently pursue a Work Order as set forth therein, ANAHEIM may elect to terminate the Work Order or this Agreement. 1.5 CONSULTANT acknowledges that ANAHEIM may enter into agreements similar to this Agreement with other consultants. It is understood and agreed that a Work Order will be awarded to the prequalified consultant most qualified in ANAHEIM's opinion to provide services set forth in the RFWOP within the scheduled completion date based upon the following criteria: .01 Ability of the consultant to perform the specific tasks outlined in the RFWOP; .02 Qualifications of the specific individuals to perform the specific tasks outlined in the RFWOP; .03 Amount and quality of time key personnel will be involved in their respective portions of the Services outlined in the RFWOP; .04 Reasonableness of the fee requested to provide the Services outlined in the RFWOP; .05 Demonstrated record of success by the consultant on work previously performed for ANAHEIM or for other municipalities or enterprises and .06 The specific methods and techniques to be employed by the consultant in providing the Services outlined in the RFWOP. 1.6 In the event of conflicting provisions, the provisions shall govern in the following order: (1) the Notice to Proceed; (2) the RFWOP; (3) CONSULTANT’s Work Order;

  • Data to Be Provided In order for the Operator to perform the Services described in the Service Agreement, LEA shall provide the categories of data described in the Schedule of Data, attached as Exhibit B.

  • All new supplies equipment and services shall include manufacturer's minimum standard warranty unless otherwise agreed to in writing. Vendor shall be legally permitted to sell all products offered for sale to TIPS Members. All goods proposed and sold shall be new unless clearly stated in writing. The Vendor shall provide timely and accurate customer support for orders to TIPS Members as agreed by the Parties. Vendors shall respond to such requests within a commercially reasonable time after receipt of the request. If support andƒor training is a line item sold or packaged with a sale, support shall be as agreed with the TIPS Member. Most TIPS Members are tax exempt and the related laws andƒor regulations of the controlling jurisdiction(s) of the TIPS Member shall apply. No assignment of Agreement may be made without the prior notification of TIPS. Written approval of TIPS shall not be unreasonably withheld. Payment for delivered goods and services can only be made to the awarded Vendor, Vendor designated reseller or vendor assigned company.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!