Time and Materials Work Order Sample Clauses

Time and Materials Work Order. In performing the Contract Scope of Work set forth in the “Time and Materials” Work Order, the Contractor will be compensated on an Hourly Basis for labor, with a Not-To-Exceed (NTE) amount set forth in such Work Order, in accordance with the Contractor’s Standard Billing Rates (Attachment B) and on an incurred basis for Reimbursable Expenses Schedule (Attachment C) up to, but not to exceed, the estimated amount set forth in the Work Order. The reimbursable expenses shall be charged to VEIC at Contractor’s actual cost, with no xxxx-up. Contractor shall not exceed these dollar amounts set forth above for labor and reimbursable expenses in performing the Contract Scope of Work, unless approved in advance in writing by an authorized representative of VEICDuring each yearly anniversary of the Term of this Contract, Contractor may only increase the Standard Billing Rates for labor set forth on Attachment B by the lesser of (i) three percent (3%) or (ii) the average percentage change in the annual Consumer Price Index Northeast for all urban consumers (CPI-U) (1982-1984) over the then current contract year (CPI). The average percentage CPI change will be calculated by VEIC by January 1 of each year and will be used until the following January. [Do Not Use If a Single Year Contract]. The schedule of rates set forth on Attachment C shall not change during the Term of this Contract, with the exception of mileage, which will be adjusted on a calendar year basis in accordance with changes in the IRS approved mileage rate for use of a personal automobile. With the exception of the increases provided for in the preceding two sentences regarding mileage and labor rates, Contractor shall not increase any other expenses set forth on Attachments B and C during the Term of this Contract. No obligations for expenses beyond the estimated amount in Attachment C shall be reimbursed without prior written approval by VEIC. The Standard Billing Rates include all General and Administrative Overhead; all Contractor administrative functions are understood to be compensated through the factor applied to determine the Standard Billing Rates, and only administrative assistance that is in direct support of production of the deliverables in the Scope of Work will be compensated on an hourly basis. Invoices shall be submitted monthly, including a breakdown showing the staff, hourly rate, hours, and the tasks progressed or completed for the invoice period. Prior to making any monthly paymen...
Sample 1
AutoNDA by SimpleDocs
Time and Materials Work Order. Each invoice submitted by Contractor must specify: ▪ County numbers of the Work Order and Contractor’s Master Agreement; ▪ Period of performance of work being invoiced; ▪ Name(s) of persons who performed the work; ▪ Number of hours being billed for the individual(s) and the labor rate(s) as specified in the Work Order; and ▪ Total amount of the invoice.
Sample 1
Time and Materials Work Order. 5.9.7.2.1 Each invoice submitted by Contractor shall specify:
Sample 1

Related to Time and Materials Work Order

  • Time and Materials If this contract is designated as a Time and Materials contract, invoicing and payment shall be as follows:

  • Work Order (s) means a detailed scope of work for a Service required by Transnet, including timeframes, Deliverable, Fees and costs for the supply of the Service to Transnet, which may be appended to this Agreement from time to time.

  • Stop Work Order (a) NYSERDA may at any time, by written Order to the Contractor, require the Contractor to stop all or any part of the Work called for by this Agreement for a period of up to ninety (90) days after the Stop Work Order is delivered to the Contractor, and for any further period to which the parties may agree. Any such order shall be specifically identified as a Stop Work Order issued pursuant to this Section. Upon receipt of such an Order, the Contractor shall forthwith comply with its terms and take all reasonable steps to minimize the incurrence of costs allocable to the Work covered by the Order during the period of work stoppage consistent with public health and safety. Within a period of ninety (90) days after a Stop Work Order is delivered to the Contractor, or within any extension of that period to which the parties shall have agreed, NYSERDA shall either:

  • Stop Work Orders A. The JBE may, at any time, by Notice to Contractor, require Contractor to stop all or any part of the Services for a period up to ninety (90) days after the Notice is delivered to Contractor, and for any further period to which the parties may agree (“Stop Work Order”). The Stop Work Order shall be specifically identified as such and shall indicate it is issued under this provision. Upon receipt of the Stop Work Order, Contractor shall immediately comply with its terms and take all reasonable steps to minimize the incurrence of costs allocable to the Services covered by the Stop Work Order during the period of stoppage. Within ninety (90) days after a Stop Work Order is delivered to Contractor, or within any extension of that period to which the parties shall have agreed, the JBE shall either (i) cancel the Stop Work Order; or (ii) terminate the Services covered by the Stop Work Order as provided for in this Agreement.

  • Work Orders If the Contract is for indefinite quantities of Services, as specified in the Signature Document, all Work will be performed in accordance with properly executed Work Orders.

  • Statement of Work The Contractor shall provide the services and staff, and otherwise do all things necessary for or incidental to the performance of work, as set forth below:

  • Services, Materials, and Equipment Unless otherwise specified, the Contractor shall provide and assume full responsibility for all services, materials, equipment, labor, transportation, construction equipment and machinery, tools, appliances, fuel, power, light, heat, telephone, water, sanitary facilities, temporary facilities, and all other facilities, incidentals, and services necessary for the construction, performance, testing, start-up, inspection and completion of the Work.

  • Equipment and Materials Contractor at its sole cost and expense shall provide and furnish all tools, labor, materials, equipment, transportation services and any other items (collectively, "Equipment") which are required or necessary to perform the Services in a manner which is consistent with generally accepted standards of the profession for similar services. Notwithstanding the foregoing, District shall not be responsible for any damages to persons or property as a result of the use, misuse or failure of any Equipment used by Contractor of the Contracted Parties, even if such Equipment is furnished, rented or loaned to Contractor or the Contracted Parties by District. Furthermore, any Equipment or workmanship that does not conform to the regulations of this Agreement may be rejected by District and in such case must be promptly remedied or replaced by Contractor at no additional cost to District and subject to District’s reasonable satisfaction.

  • Service Specification The Parties have agreed upon the scope and specification of the Services provided under this Service Agreement in the Service Specification.

  • Software License Terms (a) Software that is made available by a Provider to Recipient in connection with any Service (any such Software being referred to herein as “TSA-Licensed Software”) provided hereunder will be subject to the terms set forth in this Section 3.5 except as otherwise provided in the applicable Service Schedule. The Provider hereby grants to the Recipient a non-exclusive, non-transferable license to use, in object code form, any TSA-Licensed Software that is made available by the Provider pursuant to a Service Schedule. For the avoidance of doubt, the Provider that makes available any TSA-Licensed Software in connection with the provision of any Service retains the unrestricted right to enhance or otherwise modify such TSA-Licensed Software at any time, provided that such enhancements or other modifications do not disrupt the provision of such Service to the Recipient.

Time is Money Join Law Insider Premium to draft better contracts faster.