Work Preparation. Proper preparation of the work area before an asbestos abatement project begins helps to contain fibers that are released within the work area. Pre-work activities include, but are not limited to the following: • Conduct Walkthrough Survey: Before work commences, ATI’s project director will conduct a walkthrough survey to inventory and photograph existing damages. We will create a photo catalog of the abatement project to document pre-job conditions. • Hold Pre-Job Briefing: All asbestos removal jobs have different problems and each require different solutions. ATI supervisors will provide a briefing to workers detailing the special conditions they will encounter on that job. The scope of work and nature of the abatement project will be based upon the results of the survey reports and/or asbestos removal specifications. • Post Warning Signs: ATI will place OSHA warning signs at each entrance to the work area. Signs will conform to regulatory standards and inform the reader that breathing asbestos dust may cause serious bodily harm. • Secure Electrical System: ATI will de-energize the electrical supply to the work area to eliminate the potential for a shock hazard. The crew will make provisions for supplying the work area with electricity from outside the work area. The source will be equipped with a ground fault interrupt system. • Shut Down HVAC System: The HVAC system supplying the work area must be shut down and isolated to prevent entrainment of asbestos dust throughout the facility. All vents and air ducts inside the work area will be covered and sealed with two layers of 6 mil polyethylene and duct tape. • Seal Remaining Items with Polyethylene: Items not being removed from the work area, will be wet-wiped or HEPA vacuumed and wrapped in place with 6 mil polyethylene and sealed with duct tape. ATI will also seal windows, flooring and walls to contain the work area. • Set-Up Work Area Ventilation System: Negative air filtration units will be set up within the containment and exhausted directly to the outside of the facility to filter the air and create a pressure differential between the containment and the outside area. At a minimum, the units will supply one air change every 15 minutes.
Work Preparation. Employees covered by this Agreement and who provide direct services to students shall have adequate preparation time for material preparation and meeting with teachers. Custodians, covered under this Agreement, will have the last fifteen minutes of their shift to complete “end-of-shift” duties.
Work Preparation. The hours of work shall include the period which they met with other instructors to plan their student learning experience in the classroom, clinical area or community and the period during which they are responsible for students planned learn- ing experiences in the classroom, clinical area or community. The Employer shall make provision for time to be available during the regular work period for instructors to do prepara- tory and other types of work required of them in connection with their teaching duties. Subject to the operational require- ments of the School of Nursing, instructors shall be permitted to use learning resources outside the school during working hours to obtain up to date and pertinent literature for student instruction.
Work Preparation. The hours of work shall include the period which she/he meets with other instructors to plan her/his student learning experi- ence in the classroom, clinical area or community and the pe- riod during which she/he is responsible for students planned learning experiences in the classroom, clinical area or com- munity. The Employer shall make provision for time to be available during the regular work period for instructors to do preparatory and other types of work required of them in con- nection with their teaching duties. Subject to the operational requirements of the School of Nursing, instructors shall be permitted to use learning resources outside the school during working hours to obtain up to date and pertinent literature for student instruction.
