Optional Requirements. Where a choice of materials or methods, or both, is permitted in the contract or Contract Task Order, the Contractor shall have the discretion to choose an alternative unless otherwise required by the specification.
Optional Requirements. Sellers are requested to stipulate in Schedule A3 their willingness to provide any free bonus offer or value-added services other than the mandatory requirement as mentioned in Clause 32(a) above.
Optional Requirements. 7.1 SafePLC and E-stop Concerning safety on production lines, it is in accordance with European law, the individual seller of units to CE approve its own equipment/machine. An external company or buyer will prepare the final CE approval of the entire system. The seller must indicate the number of emergency stop and emergency stop locations. This information is to be used to program the SafePLC which can become a part of the Line Controller. The Line Controller must be able to conduct a controlled shutdown of the line. The Line Controller will monitor all emergency stops on the Units, therefore the requirements for emergency stop circuit needs to be coordinated with the Buyer and the seller of the Line Control. The E-stop circuit’s needs to be 100 % separated from other devices, for example door switches etc. It is not the intention that the whole line is to be stopped, if for instance a safety door on a Unit is opened. The principle of the line E-stop are to ensure that the Unit with an emergency is stopped immediately, and the Units upstream are stopped by the line controller E-stop function. Figure 15: E-stop interface for units on a line with SafePLC. Units with an active E-stop needs to be manually cleared (physically cleared) and restart on the Unit is necessary. The units that are stopped as a consequence of a controlled shutdown from Line controller, must be able to restart after a manually clearing of E-stop. Units must not be able to be reset or started when a E-stop is active. The emergency stop function must be available and operational at all times, regardless of the operating mode. Emergency stop must be a back-up to other safeguarding measures and not a substitute for them. The SafePLC function within the Line Controller needs to obtain the following demands in accordance with Standard EN ISO 13849-1 and the following issues is to be defined • Performance level ? (For example: D) • Architecture category ? (For example: D) • Stop category ? (For example: 0) It must be possible to start the line again after maximum 10 seconds when the unit with emergency stop is reset and ready for production. It is to be examined what are the situation when new and old Units are mixed.
Optional Requirements. Customers may include within their requirements supplementary service requirements. These are a Customer’s optional ancillary requirements that enhance or otherwise supplement the core requirement(s).
Optional Requirements. Customers may include within their requirements supplementary service requirements. These are a Customer’s optional ancillary requirements that enhance or otherwise supplement the core requirement(s). The Supplier may provide supplementary service requirement(s) that fall within the scope of the requirements of the DMP Agreement and which Customers may require to deliver their Apprenticeships schemes. The supplementary service requirements may include, but not limited to the following: Delivery of apprenticeship training and management of the funding administration in accordance with the funding rules within the devolved administrations, either directly, or through Training Providers registered with the devolved administration; Supporting the sourcing, selection and assessment, recruitment and administration of the Apprentices; including drafting job descriptions, attracting candidates, skills screening, long-listing and shortlisting, interview scheduling and references; Bespoke, contextualise and/or package the Apprenticeship learning to suit the specific needs of the Apprentice and meet with the Customer requirements. In all cases the integrity of the learning outcome to the relevant SASE framework or Apprenticeship Standard shall be maintained.
Optional Requirements. 1. Crib Hire, (Call for prices) £
Optional Requirements. Where a choice of materials or methods, or both, is permitted in the contract or CTO, the Contractor shall have the discretion to choose an alternative unless otherwise required by the specification, so long as the materials chosen meet the required standards per Federal regulations.
Optional Requirements. The Supplier shall be able provide the optional requirements to Buyers which shall include additional well-being services.
