Wall reinforcement Sample Clauses

Wall reinforcement. Where so specified hollow block walls shall be reinforced vertically with 10 mm diameter mild steel bars or 6 mm square twisted bars at 450 mm centres unless otherwise specified, the bars being tied in with the reinforcement of the floors at the top and bottom in an approved manner. No scheduled for steel in walls will be provided.
AutoNDA by SimpleDocs
Wall reinforcement. A bathroom must be provided with wood blocking installed within wall framing to support grab bars as needed. The wood blocking, when measured to the center, will be located between thirty-three inches (33") and thirty-six inches (36") above the finished floor. The wood blocking must be located in all walls adjacent to and behind a toilet, shower, or bathtub. The property card for Washington Plaza indicates it obtained a “New Buildingbuilding permit on May 14, 2012. Based on the information gathered, it is reasonable to accept as true Respondents’ affirmation that they installed the wall reinforcement adjacent to toilets and bathing facilities, which will allow for the future installation of grab bars, as required by the FHA and ICRA.
Wall reinforcement. All xxxxxxx of thickness 150 mm and less shall be reinforced with hoop iron 25 mm wide or similar reinforcement centrally in every alternate joint (vertically for the full length of the walls, lapped and crimped 300 mm at running joints and full width of wall at angles and intersections).

Related to Wall reinforcement

  • Infrastructure Vulnerability Scanning Supplier will scan its internal environments (e.g., servers, network devices, etc.) related to Deliverables monthly and external environments related to Deliverables weekly. Supplier will have a defined process to address any findings but will ensure that any high-risk vulnerabilities are addressed within 30 days.

  • Evacuation (1) If the Combatant Commander orders a mandatory evacuation of some or all personnel, the Government will provide assistance, to the extent available, to United States and third country national contractor personnel.

  • Staging In addition to the staging categories listed in paragraph 1 of Annex 2-A, this Schedule contains staging categories 15-A, PR-8, PR-15, PR-35 and PR-50:

  • Dewatering (a) Where the whole of a site is so affected by surface water following a period of rain that all productive work is suspended by agreement of the Parties, then dewatering shall proceed as above with Employees so engaged being paid at penalty rates as is the case for safety rectification work. This work is typically performed by Employees engaged within CW1, CW2 or CW3 classifications. When other Employees are undertaking productive work in an area or areas not so affected then dewatering will only attract single time rates.

  • Disturbance Analysis Data Exchange The Parties will cooperate with one another and the NYISO in the analysis of disturbances to either the Large Generating Facility or the New York State Transmission System by gathering and providing access to any information relating to any disturbance, including information from disturbance recording equipment, protective relay targets, breaker operations and sequence of events records, and any disturbance information required by Good Utility Practice.

  • Mowing Mowing, edging (of sidewalks, paved approaches and curbs), litter removal, herbicide treatment, grass clipping removal, and brush control are included under one bid item. Regular mowing under this contract is generally limited to mowing areas of shoulders, front and back slopes of ditches less than or equal to three-to-one (3:1) slope, roadside retention areas, dry roadside ditch bottoms, median islands and various width utility strips and similar areas. Slope mowing, which is also a contract requirement, is generally limited to slopes greater or steeper than three-to-one (3:1) and are relatively inaccessible to the use of conventional mowing equipment (e.g., steep slopes, retention area banks and shores, bridge/overpass banks, canal banks, wet roadside ditches, etc). These types of areas will normally require equipment specifically designed for this type of work. When slope mowing is performed, it will incorporate the use of string trimmers to protect the integrity of the slope and prevent damage to the turf. Sign posts, mailboxes, guardrails, trees, roadside outfall structures, fences, divider walls, shrubs, plants, light poles, utility flags or other such obstacles to mowing will be hand mowed or trimmed around as necessary to present a groomed appearance. Top of vegetation on wet bottom ditches areas must be cut-off to the water’s level. Particular attention will be paid to planted areas. Any damage that occurs to plants, trees, shrubs, mulched beds, tree rings, sprinkler heads, etc., will be repaired or restored, at the Contractor’s expense, before the cycle is completed. Mowing will also include grass clipping removal and litter removal, edging, and herbicide treatment. These costs will be included in the unit price bid for right-of-way mowing.

  • Protection of Watershed PURCHASER shall take all necessary precautions to prevent damage to stream banks, any stream course, lake, reservoir, or forested wetland within or adjacent to the timber sale area. Definitions of Type F, Type D, and Type N streams contained in the Forest Practices Act apply to this contract. In addition to other protective measures required, PURCHASER shall discontinue all or part of the operations under this contract upon notice from STATE that operations will cause excessive damage to the watershed.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!