Electrical Power Distribution Sample Clauses

Electrical Power Distribution. A. Design, furnish and install (including total required coordination with local electrical utility) electrical utility service to the site/building. Minimum size of the electrical utility service shall be (2) 2,000 amp pad-mount type transformers furnished and installed by local electrical utility. B. The electrical utility supply and transformer and the main service entrance switchgear installation shall not be in a location that will interfere with potential future expansion of the warehouse building. Both the utility pad mount type transformer and the main service entrance switchgear shall be protected from physical damage (such as by properly spaced concrete filled bollards, highway guardrail, or other protective means). This electrical utility primary distribution feeder to the pad-mount transformer shall be via underground conduit, where on the site. C. Electrical supply/distribution voltage for the site & building shall be 480/277V, 3 phase, 4 wire, 60 hz (solidly grounded neutral). D. Design, furnish and install one 480/277V, 3 phase, 4 wire main service entrance switchboard, equipped at a minimum with the below listed features & accessories; 1. Utility metering compartment (CT’s, PT’s, metering, etc.) – if applicable for this installation. 2. Electronic/microprocessor based metering package (similar to Power Logic by Square D, or IQ Analyzer by Xxxxxx-Xxxxxx). 3. Minimum amp rating of 2,000 amperes (at 480V, 3 phase, 4 wire) including service entrance conductors/conduit (2) locations. 4. Electrically operated, insulated case type main circuit breaker rated at 2,000 amperes (minimum) and equipped with solid state, microprocessor based rip unit having adjustable long time, short time, instantaneous and ground fault tripping features – properly set in accordance with short circuit/withstand rating/selective coordination study (2) locations. 5. 480/277V electrical power distribution section(s) properly sized and equipped with appropriately sized circuit breakers and/or fused switches to serve the below listed facility electrical loads: a. warehouse HVAC distribution b. warehouse lighting distribution c. warehouse receptacle outlet distribution d. warehouse vending machines, drinking fountain water coolers, overhead door operators, dock locks, sump pumps, trash compactor, etc. e. provide (40) 30A electrical connection points for vehicle battery chargers. f. office power distribution (HVAC/lighting/receptacles/etc.) g. site electrical power distributio...
Sample 1
AutoNDA by SimpleDocs
Electrical Power Distribution. 2.1.7.1.1 A weatherproof, power distribution panel shall be provided for controlling electrical operations. 2.1.7.1.2 All controls shall be clearly marked. 2.1.7.1.3 The electrical system shall conform to the current National Electrical Code.
Sample 1
Electrical Power Distribution. 1. The power feed to the bridge serves the bridge operator’s house, the traffic gates, sign structures on the bridge, bridge cameras, and the overhead height detector for the west bound approach to the tunnel.
Sample 1
Electrical Power Distribution. 3.6.1 The Contractor will ensure access from the point at which the Utilities service is provided (HV switches and transformers included) to a permanent, constant and consistent electrical power supply, adequate for BGS’s requirements. 3.6.2 The Contractor will undertake regular load / phase monitoring to enable appropriate balancing of the system and identification of service failure risks. Where necessary the Contractor shall re- balance the system. 3.6.3 The Contractor will maintain electrical power and all associated equipment and plant to support the operation of IT and telecom systems including: 3.6.3.1 cabling distribution systems; 3.6.3.2 non-standard socket outlets and outlet apertures; and 3.6.3.3 temperature control.
Sample 1
Electrical Power Distribution. 4.34.1 The Contractor will maintain the internal electrical distribution system to provide a permanent, constant and consistent electrical power supply, adequate for BGS’s requirements. 4.34.2 The Contractor shall ensure the electrical systems are maintained in accordance with the relevant legislation and best practice.
Sample 1
Electrical Power Distribution a. Well Area - Electrical power shall be supplied to the well site via a 115 kV overhead distribution line with a transformer. b. Truck Shop & Lime Bin Area - Electrical power shall be provided from a branch off the 13.8 kV overhead distribution line with a transformer. Power to the Lime Bin control board will be fed via underground. Lighting and local control for the lime bin is included in the scope of work.
Sample 1

Related to Electrical Power Distribution

  • Electrical Power Corporation shall provide Contractor with convenient access to electrical power required to perform the work. The electrical outlets used by Contractor shall be those designated or approved by Corporation.

  • Unbundled Sub-Loop Distribution Voice Grade (USLD-VG) is a copper sub- loop facility from the cross-box in the field up to and including the point of demarcation at the End User’s premises and may have load coils.

  • Other Distributions In case the Company shall fix a record date for the making of a distribution to all holders of shares of its Common Stock of securities, evidences of indebtedness, assets, cash, rights or warrants (excluding Ordinary Cash Dividends, dividends of its Common Stock and other dividends or distributions referred to in Section 13(A)), in each such case, the Exercise Price in effect prior to such record date shall be reduced immediately thereafter to the price determined by multiplying the Exercise Price in effect immediately prior to the reduction by the quotient of (x) the Market Price of the Common Stock on the last trading day preceding the first date on which the Common Stock trades regular way on the principal national securities exchange on which the Common Stock is listed or admitted to trading without the right to receive such distribution, minus the amount of cash and/or the Fair Market Value of the securities, evidences of indebtedness, assets, rights or warrants to be so distributed in respect of one share of Common Stock (such amount and/or Fair Market Value, the “Per Share Fair Market Value”) divided by (y) such Market Price on such date specified in clause (x); such adjustment shall be made successively whenever such a record date is fixed. In such event, the number of Shares issuable upon the exercise of this Warrant shall be increased to the number obtained by dividing (x) the product of (1) the number of Shares issuable upon the exercise of this Warrant before such adjustment, and (2) the Exercise Price in effect immediately prior to the distribution giving rise to this adjustment by (y) the new Exercise Price determined in accordance with the immediately preceding sentence. In the case of adjustment for a cash dividend that is, or is coincident with, a regular quarterly cash dividend, the Per Share Fair Market Value would be reduced by the per share amount of the portion of the cash dividend that would constitute an Ordinary Cash Dividend. In the event that such distribution is not so made, the Exercise Price and the number of Shares issuable upon exercise of this Warrant then in effect shall be readjusted, effective as of the date when the Board of Directors determines not to distribute such shares, evidences of indebtedness, assets, rights, cash or warrants, as the case may be, to the Exercise Price that would then be in effect and the number of Shares that would then be issuable upon exercise of this Warrant if such record date had not been fixed.

  • Contract Distribution The Employer will provide all current and new employees with a link to the new Agreement. Each department or unit will maintain a paper copy of the contract accessible to all employees.

  • Other Distribution Fee by any Holder of ADS(s), a fee not in excess of U.S. $5.00 per 100 ADSs (or fraction thereof) held for the distribution of securities other than ADSs or rights to purchase additional ADSs (e.g., spin-off shares);

  • COSTS DISTRIBUTED THROUGH COUNTYWIDE COST ALLOCATIONS The indirect overhead and support service costs listed in the Summary Schedule (attached) are formally approved as actual costs for fiscal year 2022-23, and as estimated costs for fiscal year 2024-25 on a “fixed with carry-forward” basis. These costs may be included as part of the county departments’ costs indicated effective July 1, 2024, for further allocation to federal grants and contracts performed by the respective county departments.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Qualified Reservist Distributions If you are a qualified reservist member called to active duty for more than 179 days or an indefinite period, the payments you take from your IRA during the active duty period are not subject to the 10 percent early distribution penalty tax.

  • Initiating Interconnection 4.1 If ENT determines to offer Telephone Exchange Services and to interconnect with Verizon in any LATA in which Verizon also offers Telephone Exchange Services and in which the Parties are not already interconnected pursuant to this Agreement, ENT shall provide written notice to Verizon of the need to establish Interconnection in such LATA pursuant to this Agreement. 4.2 The notice provided in Section 4.1 of this Attachment shall include (a) the initial Routing Point(s); (b) the applicable technically feasible Point(s) of Interconnection on Verizon’s network to be established in the relevant LATA in accordance with this Agreement; (c) ENT’s intended Interconnection activation date; (d) a forecast of ENT’s trunking requirements conforming to Section 14.2 of this Attachment; and (e) such other information as Verizon shall reasonably request in order to facilitate Interconnection. 4.3 The interconnection activation date in the new LATA shall be mutually agreed to by the Parties after receipt by Verizon of all necessary information as indicated above. Within ten (10) Business Days of Verizon’s receipt of ENT’s notice provided for in Section 4.1of this Attachment, Verizon and ENT shall confirm the technically feasible Point of Interconnection on Verizon’s network in the new LATA and the mutually agreed upon Interconnection activation date for the new LATA.

  • Residual Distributions If the Liquidation Preference has been paid in full to all holders of Designated Preferred Stock and the corresponding amounts payable with respect of any other stock of the Issuer ranking equally with Designated Preferred Stock as to such distribution has been paid in full, the holders of other stock of the Issuer shall be entitled to receive all remaining assets of the Issuer (or proceeds thereof) according to their respective rights and preferences.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!