Environmental Management Objectives Clause Samples

Environmental Management Objectives. ‌ (a) Lessee shall comply and shall cause its employees, agents and contractors to comply with all Applicable Laws and Requirements pertaining to the protection of human health and the environment. (b) Continuously throughout the Term, Lessee shall demonstrate environmental leadership by incorporating sustainable practices to the maximum extent practicable in its operations, Repair and Maintenance, Alterations, acquisition, provision of services, and other activities performed under this Lease.

Environmental Management Objectives. The Concession Contractor shall comply with the environmental management objectives identified in the Reclamation’s Environmental Management System policy ▇▇▇▇://▇▇▇.▇▇▇▇.▇▇▇/recman/ and Reclamation’s Inspection and Cleaning Manual for Equipment and Vehicles to Prevent the Spread of Invasive Species Technical Memorandum (86-68220-07-05), which Reclamation will provide at the execution of this contract. The manual may also be accessed at: ▇▇▇▇://▇▇▇.▇▇▇▇.▇▇▇/mussels/prevention. Compliance with the Mid-Pacific Region Environmental Management System requires, but is not limited to, the incorporation of the following practices into Concession Area operations.

Environmental Management Objectives. The Concession Contractor shall meet the following environmental management objectives in the conduct of its operations under this Concession Contract: 1. The Concession Contractor, including its employees, agents, and contractors, shall comply with all Applicable Laws pertaining to the protection of the public, employees, and natural and cultural resources within the Pleasure Cove Marina concession area. 2. The Concession Contractor shall incorporate Best Management Practices in its operation, construction, maintenance, acquisition, provision of visitor services, and other activities under this Concession Contract. 3. The design, construction, and operation of the facilities and the provision of services under this Concession Contract shall be performed in a manner that prevents, identifies, and reduces pollution at the source. The Concession Contractor shall comply with all Applicable Laws and Reclamation policies and instructions promulgated and enacted during the term of this Concession Contract concerning any hazardous materials that will be used, produced, transported, stored, or disposed of on or in lands, water, or facilities owned by the United States of America or administered by Reclamation. 4. The Concession Contractor may not knowingly allow contamination of lands, water, or facilities within the Pleasure Cove Marina concession area by hazardous materials, thermal pollution, refuse, garbage, sewage effluent, industrial or commercial waste, petroleum products, mine tailings, mineral salts, pesticides, pesticide containers, or any other pollutants, including, but not limited to, misuse of pesticides. 5. The Concession Contractor‟s operation, maintenance, acquisition, and purchasing activities will, to the extent practical, promote the use of environmentally preferable products, including materials and supplies with recycled content, and will avoid or minimize the quantity of toxic and hazardous materials entering the waste stream. 6. The Concession Contractor shall immediately report to the Contracting Officer any event that may or does result in pollution or contamination adversely affecting lands, water, or facilities within the Pleasure Cove Marina concession area. 7. The Concession Contractor will become ISO 14001 certified no later than December 31, 2012 and maintain such certification for the life of this Concession Contract. The ISO 14001 certification represents a level of commitment to the environment regarding efforts to 1) minimize ha...

Environmental Management Objectives. The goal of improving the management of the customer environment was accomplished by implementing two subsystems: • CCTV • SCADA 1. Develop an integrated platform for remote control and monitoring of CCTV cameras, initially at selected passenger stations. Examples of SCADA objectives are: 1. Support the monitoring and control of station-based devices via a graphical user interface. 2. Provide the capability to monitor and control external equipment/devices. Examples of equipment that might be monitored/controlled are: – Escalators and elevators – Turnstiles – Fire and security alarms – Security doors 3. Depict the location and basic state of devices on graphical representations of station floor plans. 4. (Ideally) integrate the SCADA GUI with the interface for selecting and using CCTV and help points. 5. Provide the capability to filter the device categories displayed on the screen (e.g., the user should be able to toggle on and off the display of turnstiles as appropriate). 6. Present the user with information about the state of the device and the appropriate controls. 7. Provide the System Administrator with the ability to restrict user privileges for monitoring and/or controlling all device categories within different users or user groups. 8. Provide the capability to configure SCADA inputs to trigger a specific response by the PA, CIS, CCTV components or other devices, via the SCADA component of the system. For example, the system could continuously poll/monitor the ‘on/off’ status of an escalator. Upon receipt of an ‘off’ signal, the SCADA system would: – Trigger a nearby CCTV camera to automatically point at the escalator – Issue an alarm on a designated IAP workstation(s)