Installation, Maintenance and Repair. (A) Seller, at its own expense, shall install and maintain one (1) stand-alone meteorological station at the Site to monitor and report the meteorological data required in Section 3.1(l)(i) of this Agreement, and for wind Projects, each wind turbine must be equipped with meteorological measurement equipment (e.g. anemometers) which are individually linked to Seller’s plant information system. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement.
Installation, Maintenance and Repair. (A) Seller, at its own expense, shall install and maintain one (1) stand-alone meteorological station per Site to monitor and report the meteorological data required in Section 3.1(l)(i) of this Agreement. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement.
Installation, Maintenance and Repair. Seller, at its own expense, shall install and maintain one (1) stand-alone meteorological station at the Site to monitor and report the meteorological data required in Section 3.1(l)(i) of this Agreement. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement. Seller shall maintain the meteorological stations, telecommunications path, hardware, and software necessary to provide accurate data to Buyer or Third Party SC (as applicable). Seller shall promptly repair and replace as necessary such meteorological stations, telecommunications path, hardware and software and shall notify Buyer as soon as Seller learns that any such telecommunications paths, hardware and software are providing faulty or incorrect data. If Buyer notifies Seller of the need for maintenance, repair or replacement of the meteorological stations, telecommunications path, hardware or software, Seller shall maintain, repair or replace such equipment as necessary within five (5) days of receipt of such Notice. For any occurrence in which Seller’s telecommunications system is not available or does not provide quality data and Buyer notifies Seller of the deficiency or Seller becomes aware of the occurrence, Seller shall transmit data to Buyer through any alternate means of communication (i.e, cellular communications from onsite personnel, facsimile, blackberry or equivalent mobile e-mail) until the telecommunications link is re-established. Seller agrees and acknowledges that Buyer may seek from third parties any information relevant to its duties as SC for Seller, including from the Participating Transmission Operator. Seller hereby voluntarily consents to allow the Participating Transmission Operator to share Seller’s information with Buyer in furtherance of Buyer’s duties as SC for Seller, and agrees to provide the Participating Transmission Owner with written confirmation of such voluntary consent at least thirty (30) days prior to the Initial Energy Delivery Date. No later than ninety (90) days before the Initial Energy Delivery Date, Seller shall provide one (1) year, if available, but no less than six (6) months, of recorded meteorological data to Buyer in a form reasonably acceptable to Buyer from a weather station at the Site. Such weather station shall provide, via remote access to Buyer, all data relating to (A) total global horizontal irradiance or direct...
Installation, Maintenance and Repair. (A) Seller, at its own expense, shall install and maintain [one (1)] [__(__)] [Solar and wind Projects should insert a number, at least one (1) based on capacity of the Project and square mileage and topography of the Site. For wind Projects include one (1) per 5 square miles, unless Buyer determines that fewer meteorological stations are required] stand-alone meteorological station[s] at the Site to monitor and report the meteorological data required in Section 3.1(l)(i) of this Agreement. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement.
Installation, Maintenance and Repair. AT&T shall provide and maintain its Equipment from its central office to the AT&T Service demarcation point(s) for the Property (“Demarc(s)”) if Association makes available the necessary space and power. AT&T will provide technical support for the Bulk Services that is equivalent to that generally available to customers of AT&T’s residential services comparable to the Bulk Services. AT&T shall maintain and repair Bulk Services from the network side of the Demarc through its network in addition to the CPE (as defined in Section 6.3 below). In the event an End User trouble is located on the End User side of the Demarc and is not CPE, and the End User and AT&T agree that AT&T will repair the trouble, AT&T shall xxxx the End User, where applicable, at AT&T’s standard repair rate. AT&T may, at its own expense, take any actions which are necessary or convenient, in AT&T’s reasonable opinion, to install, operate, alter, maintain, replace, supplement or remove Equipment and to deliver the AT&T Services. Notwithstanding the above, if installation of the Equipment will require a significant disturbance at the Property or coordination with the Association, AT&T will provide its plans for the Equipment to Association prior to installation, including the location of all above-ground Equipment in the common areas of the Property that AT&T proposes to install at the Property. AT&T's selection of the particular Equipment, and Equipment manufacturers, shall be at AT&T's discretion. Association shall approve or reject AT&T's plans within ten (10) days following receipt. Failure of Association to approve or reject such plans within ten (10) days shall constitute approval. Association's approval of the plans for the Equipment may not be unreasonably withheld or delayed, except that Association's approval of the location of above-ground Equipment is in Association’s sole discretion, subject to reasonable technical feasibility constraints from AT&T. Association and AT&T shall work in good faith to resolve any objections related to the installation and placement of Equipment, including above-ground Equipment sites. Such approvals are not required for similar or like replacements of the components of the Equipment, unless the replacements will change the aesthetics of the Property. AT&T shall restore any damaged portion of the Property to a condition that is as close to its original condition prior to the performance of such work on the Equipment as is commercially reasonable and...
Installation, Maintenance and Repair. (a) Seller, at its own expense, shall install and maintain one (1) stand-alone meteorological station at the Facility to monitor and report the meteorological data required in Appendix E, Section1. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Appendix E, Section 1.
Installation, Maintenance and Repair. Provision of Services is subject to availability of adequate capacity and CenturyLink’s acceptance of a complete Order Form. Customer will reasonably cooperate with CenturyLink or its agents to install, maintain, and repair Services. Customer will provide or secure at Customer's expense appropriate space and power; and rights or licenses if CenturyLink must access the building of Customer’s premises to install, operate, or maintain Service or associated CenturyLink equipment. CenturyLink may refuse to install, maintain, or repair Services if any condition on Customer’s premises is unsafe or likely to cause injury. Customer is responsible for any facility or equipment repairs on Customer’s side of the demarcation point. Customer may request a technician dispatch for Service problems. CenturyLink will assess a dispatch fee if it determines the problem is on Customer's side of the demarcation point or was not caused by CenturyLink’s facilities or equipment on CenturyLink’s side of the demarcation point.
Installation, Maintenance and Repair. The following are supplemental terms to the Scheduled Maintenance and Local Access section of the Agreement: (a) Provision of Services is subject to availability of adequate capacity and CenturyLink’s acceptance of a complete Order Form and (b) Customer is responsible for any facility or equipment repairs on Customer’s side of the demarcation point. Customer may request a technician dispatch for Service problems. Before dispatching a technician, CenturyLink will notify Customer of the dispatch fee. CenturyLink will assess a dispatch fee if it determines the problem is on Customer's side of the demarcation point or was not caused by CenturyLink’s facilities or equipment on CenturyLink’s side of the demarcation point. “Order Form” includes both order request forms and quotes issued by CenturyLink. If a CenturyLink service requires a quote to validate the Order Form pricing, the quote will take precedence over the order request form, but not over the Service Exhibit.
Installation, Maintenance and Repair. (A) Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement.
Installation, Maintenance and Repair. (A) Seller, at its own expense, shall install and maintain [one (1)] [__(__)] [Solar and wind Projects should insert a number, at least one (1) based on capacity of the Project and square mileage and topography of the Site.] stand-alone meteorological station[s] at the Site to monitor and report the meteorological data required in Section 3.1(l)(i) of this Agreement, and for wind Projects, each wind turbine must be equipped with meteorological measurement equipment (e.g. anemometers) which are individually linked to Seller’s plant information system. Seller, at its own expense, shall install and maintain a secure communication link in order to provide Buyer with access to the data required in Section 3.1(l)(i) of this Agreement.
