TEACHING HOURS AND TEACHING LOAD Section 1 Work Day For the applicable agreement period, the normal work day will be seven and one-quarter (7 ¼) hours including arrival time fifteen (15) minutes before and departure time (15) minutes after the students’ school day. The normal work day will include uninterrupted prep time. The Building Principal, as authorized by the Superintendent, upon request of a teacher or group of teachers, may waive the requirement to remain fifteen (15) minutes after the school day for a specific day or days. It is recognized; however, that the proper performance of their duties may, on occasion, require these persons to work longer than the normal work day, i.e. for conferences, faculty meetings, department meetings, etc. Therefore, “mandatory meetings will occur two times per month and be no longer than 90 minutes in length, inclusive of the additional 15 minutes beyond the scheduled student school day. A schedule of the meetings will be distributed by June 30th of the previous school year, but may be changed at the discretion of the Principal with 48 hours’ notice.” Teachers will also remain at school after the fifteen (15) minutes described above, during one (1) day each calendar week for such periods of time as is necessary to provide students extra help, and/or to meet with parents or guardians, concerning the progress of their children or wards. No teacher shall be required to work more than a normal seven and one- quarter (7 ¼) hour day, including fifteen (15) minutes before and (15) minutes after the students’ school day, which will include uninterrupted prep time; this provision does not apply to other contractually agreed upon time and meetings. Should state law require a longer instructional day, or more days, the teachers shall work the added time and the parties shall immediately commence impact bargaining on the issue. This article does not purport to cover the arrival and departure time of teachers involved in special assignments. Section 2 Other Personnel Personnel other than classroom teachers will work at their assigned tasks for the length of the regular teachers' work day. The exact daily schedule will be worked out on an individual basis between the Administration and the employee with notification to the Association. Instructional Coaches are required to work an additional five (5) days at their per diem rate, beyond the work year for a total of 189 days. These days will be determined prior to the start of the new school year and at the discretion of the Superintendent and the Chief Academic Officer.
Apprentices and trainees a. Apprentices (programs of the USDOL). Apprentices will be permitted to work at less than the predetermined rate for the work they performed when they are employed pursuant to and individually registered in a bona fide apprenticeship program registered with the U.S. Department of Labor, Employment and Training Administration, Office of Apprenticeship Training, Employer and Labor Services, or with a State Apprenticeship Agency recognized by the Office, or if a person is employed in his or her first 90 days of probationary employment as an apprentice in such an apprenticeship program, who is not individually registered in the program, but who has been certified by the Office of Apprenticeship Training, Employer and Labor Services or a State Apprenticeship Agency (where appropriate) to be eligible for probationary employment as an apprentice. The allowable ratio of apprentices to journeymen on the job site in any craft classification shall not be greater than the ratio permitted to the contractor as to the entire work force under the registered program. Any worker listed on a payroll at an apprentice wage rate, who is not registered or otherwise employed as stated above, shall be paid not less than the applicable wage rate on the wage determination for the classification of work actually performed. In addition, any apprentice performing work on the job site in excess of the ratio permitted under the registered program shall be paid not less than the applicable wage rate on the wage determination for the work actually performed. Where a contractor is performing construction on a project in a locality other than that in which its program is registered, the ratios and wage rates (expressed in percentages of the journeyman's hourly rate) specified in the contractor's or subcontractor's registered program shall be observed. Every apprentice must be paid at not less than the rate specified in the registered program for the apprentice's level of progress, expressed as a percentage of the journeymen hourly rate specified in the applicable wage determination. Apprentices shall be paid fringe benefits in accordance with the provisions of the apprenticeship program. If the apprenticeship program does not specify fringe benefits, apprentices must be paid the full amount of fringe benefits listed on the wage determination for the applicable classification. If the Administrator determines that a different practice prevails for the applicable apprentice classification, fringes shall be paid in accordance with that determination. In the event the Office of Apprenticeship Training, Employer and Labor Services, or a State Apprenticeship Agency recognized by the Office, withdraws approval of an apprenticeship program, the contractor will no longer be permitted to utilize apprentices at less than the applicable predetermined rate for the work performed until an acceptable program is approved. b. Trainees (programs of the USDOL). Except as provided in 29 CFR 5.16, trainees will not be permitted to work at less than the predetermined rate for the work performed unless they are employed pursuant to and individually registered in a program which has received prior approval, evidenced by formal certification by the U.S. Department of Labor, Employment and Training Administration. The ratio of trainees to journeymen on the job site shall not be greater than permitted under the plan approved by the Employment and Training Administration. Every trainee must be paid at not less than the rate specified in the approved program for the trainee's level of progress, expressed as a percentage of the journeyman hourly rate specified in the applicable wage determination. Trainees shall be paid fringe benefits in accordance with the provisions of the trainee program. If the trainee program does not mention fringe benefits, trainees shall be paid the full amount of fringe benefits listed on the wage determination unless the Administrator of the Wage and Hour Division determines that there is an apprenticeship program associated with the corresponding journeyman wage rate on the wage determination which provides for less than full fringe benefits for apprentices. Any employee listed on the payroll at a trainee rate who is not registered and participating in a training plan approved by the Employment and Training Administration shall be paid not less than the applicable wage rate on the wage determination for the classification of work actually performed. In addition, any trainee performing work on the job site in excess of the ratio permitted under the registered program shall be paid not less than the applicable wage rate on the wage determination for the work actually performed. In the event the Employment and Training Administration withdraws approval of a training program, the contractor will no longer be permitted to utilize trainees at less than the applicable predetermined rate for the work performed until an acceptable program is approved.
APPRENTICES/TRAINEES 25.1 Apprentices/Trainees shall be entitled to all of the applicable rates and conditions of employment prescribed by this Agreement. 25.2 For clarification, in addition to the rates in APPENDIX 1, Trainees are entitled to receive full Daily Travel, XXXX, BEWT, CIPQ, Superannuation and any other entitlements in accordance with this document. Such entitlements shall not be paid at rates applicable to Apprentices. 25.3 Training arrangements for Apprentices/Trainees shall be as provided in the Building and Construction General On-site Award 2020. 25.4 Apprentices/Trainees shall be entitled to be paid the daily fares and travel allowance whilst attending training. 25.5 The Employer shall be responsible for meeting all costs associated with Apprenticeship/Traineeship training, including any student registration, tuition fee or other course costs. 25.6 During the first year of an Apprenticeship, tools to the minimum retail value of $600.00 shall be supplied by the Employer within a period of three months after the expiry of the probationary period or within a period of six months from the date of commencement of the employment, whichever first occurs. 25.7 During the second and subsequent years (or part of a year) of apprenticeship tools to the retail value of $600.00 shall be supplied by the Employer within a period of three months from the commencement date of each such year (or part of a year) of the indentured Apprenticeship. 25.8 Where an Apprentice has entered a Competency Based Training Agreement, the provision of tools will be on the following basis: (a) During the term of Apprenticeship, an Employer shall, in respect of each level of the apprenticeship program, supply the Apprentice with tools of trade, to a minimum retail value of $600.00. (b) The supply of tools of trade for each level of the program shall be linked to the successful achievement of competencies or, where appropriate, the demonstration of approved levels of progression towards the achievement of competencies as prescribed by the relevant National Training Package or in the relevant Award. (c) Supply of tools will occur no later than three (3) months after the expiry of the probationary period or within a period of six (6) months from the date of commencement of the employment, whichever first occurs, and no later than three (3) months into subsequent levels of the apprenticeship. (d) Apprentices employed under part-time or school based arrangements shall be entitled to a supply of tools consistent with the requirements as outlined in clause 25.6 and clause 25.7 above.
Trainees Except as provided in 29 CFR 5.16, trainees will not be permitted to work at less than the predetermined rate for the work performed unless they are employed pursuant to and individually registered in a program which has received prior approval, evidenced by formal certification by the U.S. Department of Labor,
First Aid Training In the interests of the occupational safety and health of employees, the Employer will undertake an in-service program of first aid training aimed at providing a first aid officer for each department.
Supplier Diversity Seller shall comply with Xxxxx’s Supplier Diversity Program in accordance with Appendix V.
Technical Training The CAISO and the Participating TOs shall respond to reasonable requests for support and provide relevant technical training to each other’s employees to support the safe, reliable, and efficient operation of the CAISO Controlled Grid and to comply with any NERC or WECC operator certification or training requirements. Examples of such technical training include, but are not limited to: (1) the theory or operation of new or modified equipment (e.g., control systems, Remedial Action Schemes, protective relays); (2) computer and applicator programs; and (3) CAISO (or Participating TO) requirements. The Parties shall enter into agreements regarding the timing, term, locations, and cost allocation for the training.
TECHNICAL EVALUATION (a) Detailed technical evaluation shall be carried out by Purchase Committee pursuant to conditions in the tender document to determine the substantial responsiveness of each tender. For this clause, the substantially responsive bid is one that conforms to all the eligibility and terms and condition of the tender without any material deviation. The Institute’s determination of bid’s responsiveness is to be based on the contents of the bid itself without recourse to extrinsic evidence. The Institute shall evaluate the technical bids also to determine whether they are complete, whether required sureties have been furnished, whether the documents have been properly signed and whether the bids are in order. (b) The technical evaluation committee may call the responsive bidders for discussion or presentation to facilitate and assess their understanding of the scope of work and its execution. However, the committee shall have sole discretion to call for discussion / presentation. (c) Financial bids of only those bidders who qualify the technical criteria will be opened provided all other requirements are fulfilled. (d) AIIMS Jodhpur shall have right to accept or reject any or all tenders without assigning any reasons thereof.
Safety Training Pursuant to Missouri Revised Statute Section 292.675, Contractors and subcontractors who sign a contract to work on public works projects must provide a 10-hour OSHA construction safety program, or similar program approved by the Department of Labor and Industrial Relations, to be completed by their on-site employees within sixty (60) days of beginning work on the construction project. Contractors and subcontractors in violation of this provision will forfeit to the public body $2,500 plus $100 a day for each employee who is employed without training. Public bodies and contractors may withhold/assess these penalties from the payment due to those contractors and subcontractors if found to be in non-compliance.
Dimensions Education Bachelor’s Degree in Computer Science, Information Systems, or other related field. Or equivalent work experience. A minimum of 4 years of IT work experience in data modeling, data analysis, relational DBMS design and support and relevant computing environments.