Meal Period A Contractor shall schedule an unpaid period of not more than 1/2 hour duration at the work location between the 3rd and 5th hour of the scheduled shift. A Contractor may, for efficiency of operation, establish a schedule which coordinates the meal periods of two or more crafts. If an employee is required to work through the meal period, the employee shall be compensated in a manner established in the applicable Schedule A.
Rest and Meal Periods (a) There shall be a 15 minute rest period in each half of any full shift. Employees working less than a full shift, but a minimum of four hours, will receive one 15 minute paid rest period.
Rest Periods and Meal Breaks (a) All employees shall have two (2) fifteen (15) minute rest periods in each work period in excess of six (6) hours, one (1) rest period to be granted before and one (1) after the meal period, provided the staff to child ratio can be maintained. It is understood that meal breaks and rest periods may be combined subject to operational requirements.
INTERIM MAINTENANCE PERIOD During the interim maintenance period between obtaining of the completion certificate of Project and formation and operationalization of the Association the Promoter shall through itself or through a facility management company constitute a committee to run, operate, manage and maintain the Common Areas.
Break Period All employees working in full time (7 or 7.5 hour) positions shall be permitted a fifteen (15) minute rest period both in the first half and the second half of a shift.
Overtime-Eligible Unpaid Meal Periods The Employer and the Union agree to unpaid meal periods that vary from and supersede the unpaid meal period requirements of WAC 000-000-000. Unpaid meal periods for employees working more than five (5) consecutive hours, if entitled, will be a minimum of thirty (30) minutes and will be scheduled as close to the middle of the work shift as possible. Employees working three (3) or more hours longer than a normal workday will be allowed an additional thirty (30) minute unpaid meal period. When an employee’s unpaid meal period is interrupted by work duties, the employee will be allowed to resume their unpaid meal period following the interruption, if possible, to complete the unpaid meal period. In the event an employee is unable to complete the unpaid meal period due to operational necessity, the employee will be entitled to compensation, which will be computed based on the actual number of minutes worked within the unpaid meal period. Meal periods may not be used for late arrival or early departure from work and meal and rest periods will not be combined.
Maintenance Period During the Maintenance Period the Developer shall at its own expense maintain repair and otherwise S.9 keep the Works in good working order and repair to the reasonable satisfaction of xxx Xxxxxxxxxx unless xxx Xxxxxxxxxx shall declare that any required maintenance and/or repair is an emergency in which case the Developer shall carry out the said maintenance and/or repair immediately Access to the Works and consequences of inspections The Developer shall arrange for xxx Xxxxxxxxxx to have access to the Works and the Site at all
Period of Use Each category of flight will be allocated time on a Gate according to the number of seats in the aircraft being used to operate the flight as specified in the table below. Period of Use on gate in minutes Aircraft seats Turnaround Arrival Only Departure Only 400 or greater 180 75 120 200-399 150 60 90 100-199 120 60 75 Less than 100 90 45 45
Fixed Term This Agreement is concluded for a fixed term specified in the ‘Contract Term’ section of the Order Form. Neither Party can terminate this Agreement for convenience, however any rights of termination for cause remain unaffected.
Transition Period LVRT Standard The transition period standard applies to wind generating plants subject to FERC Order 661 that have either: (i) interconnection agreements signed and filed with the Commission, filed with the Commission in unexecuted form, finally executed as conforming agreements, or filed with the Commission as non-conforming agreements between January 1, 2006 and December 31, 2006, with a scheduled in-service date no later than December 31, 2007, or (ii) wind generating turbines subject to a wind turbine procurement contract executed prior to December 31, 2005, for delivery through 2007.