Correction of Deficiencies. The contractor must correct promptly any work of his/her own or his/her subcontractors found to be defective or not complying with the terms of the contract.
Correction of Deficiencies a. The Contractor must replace materials or correct workmanship not conforming to this Contract's requirements at no additional cost to WMATA. In addition, the Contractor is subject to any liquidated damages specified in this Contract or actual damages that WMATA incurs. If the Contractor fails to correct deficiencies, the Contracting Officer, may take specific action as follows:
Correction of Deficiencies. If the Work or Equipment or Spare Part is in breach of any Warranty set forth in this Section 7.1, Contractor shall, subject to Section 7.2, cure such breach as promptly as practicable upon being given written notice thereof (“Warranty Service”). Owner shall provide Contractor with reasonable access to the Project in order to perform its obligation under this Article VII and the Parties shall schedule such work as necessary so as to minimize disruptions to the operation of the Project. Owner shall have the right to operate and otherwise use the Equipment until such time as Owner deems prudent to suspend such operation or use in order to accommodate Contractor’s Warranty Services. If Equipment has been placed in service, Contractor shall perform such Warranty Service as soon as Owner deems it prudent to remove the same from service for any Warranty Service by Contractor; provided that the Warranty Period will continue until Contractor has completed such Warranty Service. Neither payment by Owner, nor any other provision of this Agreement, nor partial or entire use or possession of the Work by Owner shall relieve Contractor of liability with respect to the Warranty contained in this Article VII. Contractor shall bear all costs and expenses directly associated with the Warranty Services, including, all costs of services and equipment and of any necessary disassembly, removal, replacement, transportation, reassembly, reinstallation, and retesting, as well as reworking, repair or replacement of such Work, and reassembly of structures, electrical work, machinery, Equipment, or any other obstruction as necessary to give access to the non-conforming item for correction, and for removal, repair or replacement of any damage to other work or property that arises from the breach of Warranty and any applicable insurance deductibles. Upon completion of Warranty Service, all Equipment shall be returned or restored to its proper condition (subject to normal wear and tear), including but not limited to fit alignment, adjustment, operability and finish. If Contractor is obligated to repair, replace or renew any Equipment, item or portion of the Work hereunder, Contractor will undertake a technical analysis of the problem and correct the “root cause” unless Contractor can demonstrate to Owner’s reasonable satisfaction that there is no material risk of the reoccurrence of such problem. Contractor’s obligations under this Section 7.1 shall not be impaired or otherwise adversel...
Correction of Deficiencies. CONTRACTOR shall be responsible for correcting and/or adjusting all deficiencies in New Equipment/Systems that may be observed by any party to the Contract during system commissioning, measurement and verification, and testing procedures. Prior to issuance of Final ECM Acceptance Notice, CONTRACTOR shall also provide DCAMM with satisfactory documentary evidence that the New Equipment/Systems installed are the New Equipment/Systems specified in the Design.
Correction of Deficiencies. Upon termination or cancellation of this Lease, Tenant shall indemnify Landlord for any loss, damage, cost or expense incurred by Landlord to correct all deficiencies of a physical nature identified by the governmental agency responsible for licensing Personal Care Facilities in the state in which the applicable Facility is located, local health, fire and safety agencies or any other government agency or Medicare or Medicaid (or any successor program) providers in the course of the change of ownership inspection and audit.
Correction of Deficiencies. If any portion of pavement fails to comply with minimum acceptable quality requirements, the Contractor is required to make corrections as directed by the Engineer and as herein specified. It is required that such corrections will be made as work progresses and not reserved for a separate operation at some later date. No payment will be made for material placed in excess outside of the specified allowable tolerances over grade or nominal plan dimensions, for corrective work of any type, or for material that must be removed to correct deficiencies. Time lost on the Contractor’s CPM schedule due to the necessity to perform corrective work is time fully under the Contractor’s control and is neither compensable nor excusable. The Contractor shall replace deficient pavements as directed by the Engineer and in accordance with §105-08 Removal of Unacceptable and Unauthorized Work so as not to interfere with the operations of the Thruway Authority or others using the area. Existing pavement shall be removed as necessary to provide square joints for the full depth of the course. The Engineer will verify the thickness of the hot mix asphalt mat after compaction using a penetration probe; average thickness of a sublot would be determined by averaging five such readings. The area for correction of deficiencies in surface smoothness and surface grade tolerance shall be those areas which fail to satisfy quality requirements. The area to be replaced for deficiency of in-place voids shall be the total area paved with the deficient paving lot.
Correction of Deficiencies. The Contracting Officer may order the correction of a deficiency in the Carrier's quality assurance program or fraud prevention program. The Carrier shall take the necessary action promptly to implement the Contracting Officer's order. If the Contracting Officer orders a modification of the Carrier's quality assurance program or fraud prevention program pursuant to this paragraph after the contract year has begun, the costs incurred to correct the deficiency may be excluded from the administrative expenses -- for the contract year -- that are subject to the administrative expenses limitation specified at Appendix B; provided the Carrier demonstrates that the correction of the deficiency significantly increases the Carrier's liability under this contract.
Correction of Deficiencies. (1) The Contractor shall notify the Contracting Officer, in writing, when the Contractor has corrected the business system's deficiencies.
Correction of Deficiencies. If an observation shows unsatisfactory progress toward a unit member’s contract renewal, the evaluator shall promptly provide that individual with written recommendations for improvement, and shall work with the member to provide assistance in correcting deficiencies.
Correction of Deficiencies. WMC Resources shall remedy, rectify, or perform again, at its own expense, any particular Service which proved deficient as a result of its negligence or failure to perform its obligations under this Agreement.