Monitoring Stations Sample Clauses

Monitoring Stations. Water quality data is collected via water samples at river and stream monitoring stations. The list below shows monitoring stations within the relevant WRIAs (i.e., that contain Enrolled Lands). However, not all of the monitoring stations listed below are actually on the Enrolled Lands. • 2 active monitoring stations currently in WRIA 7 (Snohomish) • 5 active monitoring stations currently in WRIA 10 (Puyallup – White) • 5 active monitoring stations currently in WRIA 17 (Quilcene-Snow) • 9 active monitoring stations currently in WRIA 18 (Elwha – Dungeness) • 5 active monitoring stations currently in WRIA 19 (Lyre – Hoko) • 1 active monitoring station currently in WRIA 20 (Sol Duc-Hoh) • 1 active monitoring station currently in WRIA 22 (Lower Chehalis) • 12 active monitoring stations currently in WRIA 23 (Upper Chehalis) • 2 active monitoring stations currently in WRIA 24 (Willapa) 2 • 5 active monitoring stations currently in WRIA 25 (Grays – Elochoman) 5 • 3 active monitoring stations currently in WRIA 26 (Cowlitz) • 1 active monitoring station currently in WRIA 27 (Xxxxx) There are no active monitoring stations in WRIA 11 (Nisqually), WRIA 13 (Deschutes), WRIA 15 (Kitsap), WRIA 16 (Skokomish-Dosewallips), and WRIA 21 (Queens – Quinault).
Sample 1Sample 2
AutoNDA by SimpleDocs
Monitoring Stations. The monitoring station locations have been established to identify potential impacts to water quality sensitive receivers which are shown in Figure 5.1. Prior to, during and after the dredging and sandfilling works, water quality sampling will be undertaken at stations situated around the dredging area and at the sensitive receivers. The monitoring at those stations is to ensure the dredging and sandfilling works of the Project will not cause deterioration in water quality outside the impact (mixing) zone, in particularly at the nearby sensitive areas (shown in Figure 5.1). • R1 is a Reference Station located to the south of the dredging/sandfilling area, which is not supposed to be impacted by the dredging/sandfilling wo rks. R1 is a representative station for the background water quality for Tolo Harbour as it is at the channel where the water exchange between the enclosed Plover Cove and Tolo Harbour take place; • R2 is a Reference Station located to the southwest of the dredging/sandfilling area, which is not supposed to be impacted by the dredging/sandfilling works. R2 is a representative station for the background water quality in the Plover Cove region; • I1, I2 and I3 are the Impact Stations just outside the mixing zo ne, which is unlikely to be impacted by the dredging/sandfilling works; • FCZ1 represents the Sensitive Receiver located at the Xxx Tin Xxxx East Fish Culture Zone, which is about 1.5 km to the southwest of the dredging/sandfilling area. Deterioration of water quality at this station is not anticipated; • M1 represents the Sensitive Receiver located at the Xxxx Xxx SSSI, which is about 800 m to the west of the dredging/sandfilling area. Deterioration of water quality at this station is not anticipated; • W1 represents the Sensitive Receiver located at the Water Sport Centre, which is about 250 m to the southeast of the dredging/sandfilling area, which is unlikely to be impacted by the dredging/sandfilling works. • G1 is the Gradient Station to assist in the identification of the source of any impact.
Sample 1
Monitoring Stations. 5.3.1.1 The proposed water quality monitoring stations are listed in Table 5.1 and shown in Figure 5.1. The monitoring stations proposed in this section are indicative subject to further review before commencement of the water quality monitoring works. The status and locations of water quality monitoring stations and the works activities may change after issuing this Manual. For such occasion, the ET Leader shall propose with justification for changes to monitoring locations or other requirements of the EM&A programme, taking into account the following considerations and seek approval from the IEC and EPD:
Sample 1
Monitoring Stations. Water quality data is collected via water samples at river and stream monitoring stations. The list below shows monitoring stations within the relevant WRIAs (i.e., that contain Enrolled Lands). However, not all of the monitoring stations listed below are actually on the Enrolled Lands.
Sample 1
Monitoring Stations. Monitoring stations will be put in place to measure the amount of water corning into the ditches and the amount of water going into the streams below the diversions on a continuous real­ time basis. KIUC, assuming that it receives the understandings called for in the Permits and Approvals section of this agreement, will install and maintain monitoring equipment at the existing flow gauging location immediately above the Puu Lua Reservoir and for the following streams: Waiakoali Kawaikoi Kauaikinana Kokee ADC (either itself or through its licensee KAA), if the Commission approves this agreement, will install and maintain monitoring equipment for the following streams: Waiahulu Koaie Waimea at the Mauka hydroelectric plant time. The information gathered by these stations shall be made available to all parties at the same The Commission and the U.S. Geological Survey may install and maintain its own monitoring equipment along the streams and/or ditches in the watershed. If the KIUC project does not receive the understandings called for in the Permits and Approvals section, the monitoring equipment will be installed and maintained by ADC (either itself or through its licensee KAA). If the KIUC project ultimately does not proceed, ADC (either itselfor through its licensee KAA) will assume responsibility for the monitoring equipment.'
Sample 1
Monitoring Stations. KJUC will operate and maintain the equipment discussed in the Monitoring Stations section above.
Sample 1
Monitoring Stations monoxide was achieved (no readings greater than the standard more than once per year) in l997. The standards for ozone have been exceeded every year since the standard was adopted. Now there are two new standards fine particulate matter and ozone-8-hour. Those standards may be exceeded in some parts of the state — the location and extent of these possible violations will be determined over the next 2-S years. In the effort to clean up the air, the easiest portion of the job is already done. As the remaining portion of emissions are controlled, the expense per ton of pollutant controlled will increase, but the goal of clean air will be a little closer. Junk Mail It creates four million tons of unecessary waste It fills 3% of American landfills The average person receives 700 pieces of it or unsolicted mail each year 44% of it is thrown in the trash, unopened and unread The place to start the process to reduce all that junk mail you receive is by sending a post card to the address below and asking them to remove your name from their list. Direct Marketing Association PO Box 9008 Farmington, NY 11735 MDE Announces Reduction in Interest Rates by Xxxxxxx Xxxxx The Water Quality Financing Administration is announcing a reduction in the cost of borrowing from the Water Quality Revolving Loan Fund (WQRLF) effective July l, l998. The interest rate being offered to all borrowers has been reduced from 60% of the Bond Buyer Revenue Bond Index to 45%. For loans closing in July, the interest rate is just 2.4% for a term not to exceed 20 years. The only fees charged to RLF borrowers are a $S,000 out of pocket origination fee and an administrative fee equal to 5% of total debt service which is annual- ized over the life of the loan. The origination and administrative fee add 0.50% to the cost of the loan for a True Interest Cost of borrowing of only 2.9%. This new rate will apply only to Water Quality RLF. The Drinking Water RLF interest rates will remain unchanged at 60% of the Revenue Index. This is tremendous news for WQRLF borrowers who can achieve significant savings over more traditional financ- ing mechanisms. For an "AAA” rated issuer, the debt service savings on borrowing from the WQRLF exceeds $2.S million over a typical €eneral Obligation bond issue on a $l0 million loan for a term of 20 years. "AA” jurisdictions can achieve even higher savings of approximately $2.5 million. This rate reduction is part of an overall Revolving Loan Fund en- hancement program tha...
Sample 1
AutoNDA by SimpleDocs

Related to Monitoring Stations

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Electrical connections Equipment requiring electrical connections for operation shall either be hard wired to the Authorized User's provided connections or the Contractor shall be responsible for a male electrical union. All connections shall be made by the Contractor and accomplished in accordance with National Electrical Code requirements. Electrically operated equipment shall be available in the following volts and phases: 208 volt 1 or 3 phase, 60 HZ 220 volt 1 or 3 phase, 60 HZ 440 volt 1 or 3 phase, 60 HZ

  • Interconnection Facilities Engineering Procurement and Construction Interconnection Facilities, Network Upgrades, and Distribution Upgrades shall be studied, designed, and constructed pursuant to Good Utility Practice. Such studies, design and construction shall be based on the assumed accuracy and completeness of all technical information received by the Participating TO and the CAISO from the Interconnection Customer associated with interconnecting the Large Generating Facility.

  • System Logging The system must maintain an automated audit trail which can 20 identify the user or system process which initiates a request for PHI COUNTY discloses to 21 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY, 22 or which alters such PHI. The audit trail must be date and time stamped, must log both successful and 23 failed accesses, must be read only, and must be restricted to authorized users. If such PHI is stored in a 24 database, database logging functionality must be enabled. Audit trail data must be archived for at least 3 25 years after occurrence.

  • Telephone Monitoring/Recording From time to time we may monitor and/or record telephone calls between you and us to assure the quality of our customer service or as required by applicable law.

  • Network Interconnection 26.1 Interconnection between the networks of different SERVICE PROVIDERs shall be as per National Standards of CCS No.7 issued from time to time by Telecom Engineering Centre (TEC) and also subject to technical feasibility and technical integrity of the Networks and shall be within the overall framework of interconnection regulations issued by the TRAI from time to time. However, if situation so arises, INTERCONNECTION with R2MF signaling may be permitted by LICENSOR.

  • Interconnection Customer’s Interconnection Facilities Construction The Interconnection Customer’s Interconnection Facilities shall be designed and constructed in accordance with Good Utility Practice. Within one hundred twenty (120) Calendar Days after the Commercial Operation Date, unless the Participating TO and Interconnection Customer agree on another mutually acceptable deadline, the Interconnection Customer shall deliver to the Participating TO and CAISO “as-built” drawings, information and documents for the Interconnection Customer’s Interconnection Facilities and the Electric Generating Unit(s), such as: a one-line diagram, a site plan showing the Large Generating Facility and the Interconnection Customer’s Interconnection Facilities, plan and elevation drawings showing the layout of the Interconnection Customer’s Interconnection Facilities, a relay functional diagram, relaying AC and DC schematic wiring diagrams and relay settings for all facilities associated with the Interconnection Customer's step-up transformers, the facilities connecting the Large Generating Facility to the step-up transformers and the Interconnection Customer’s Interconnection Facilities, and the impedances (determined by factory tests) for the associated step-up transformers and the Electric Generating Units. The Interconnection Customer shall provide the Participating TO and the CAISO specifications for the excitation system, automatic voltage regulator, Large Generating Facility control and protection settings, transformer tap settings, and communications, if applicable. Any deviations from the relay settings, machine specifications, and other specifications originally submitted by the Interconnection Customer shall be assessed by the Participating TO and the CAISO pursuant to the appropriate provisions of this LGIA and the LGIP.

  • Interconnection 2.1.10 Startup Testing and Commissioning

  • System Monitoring to ensure safe and continuous operation, the Customer must monitor key services and resource use as recommended by Deswik, and provide Deswik with details of monitoring and any relevant alerts as needed. Services to be monitors include, without limitation, disk space, CPU usage, memory usage, database connectivity, and network utilization.

  • Interconnection Points 8.5.1 The IP of a Party (“Receiving Party”) for Measured Internet Traffic delivered to the Receiving Party by the other Party shall be the same as the IP of the Receiving Party for Reciprocal Compensation Traffic under Section 7.1 above.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!