Education and Training The foundation of this Program is education and voluntary compliance. It is recognized that alcohol and chemical dependency may make voluntary cessation of use difficult, and one of the Program’s principal aims is to make voluntary steps toward ending substance abuse easily available. The outside contractor shall review and develop on-going educational and training information on the adverse consequences of substance abuse and the responsibility to avoid being under the influence of alcohol or chemicals at work. Certain training required by the DOT Regulations shall be the responsibility of the Substance Abuse Program.
First Aid Training In the interests of the occupational safety and health of employees, the Employer will undertake an in-service program of first aid training aimed at providing a first aid officer for each department.
Access to NID 2.7.3.1 NewPhone may access the customer’s premises wiring by any of the following means and NewPhone shall not disturb the existing form of electrical protection and shall maintain the physical integrity of the NID: 2.7.3.1.1 BellSouth shall allow NewPhone to connect its Loops directly to BellSouth’s multi-line residential NID enclosures that have additional space and are not used by BellSouth or any other telecommunications carriers to provide service to the premises; 2.7.3.1.2 Where an adequate length of the customer’s premises wiring is present and environmental conditions permit, either Party may remove the customer premises wiring from the other Party’s NID and connect such wiring to that Party’s own NID; 2.7.3.1.3 Either Party may enter the subscriber access chamber or dual chamber NID enclosures for the purpose of extending a cross-connect or spliced jumper wire from the customer premises wiring through a suitable “punch-out” hole of such NID enclosures; or 2.7.3.1.4 NewPhone may request BellSouth to make other rearrangements to the customer premises wiring terminations or terminal enclosure on a time and materials cost basis. 2.7.3.2 In no case shall either Party remove or disconnect the other Party’s loop facilities from either Party’s NIDs, enclosures, or protectors unless the applicable Commission has expressly permitted the same and the disconnecting Party provides prior notice to the other Party. In such cases, it shall be the responsibility of the Party disconnecting loop facilities to leave undisturbed the existing form of electrical protection and to maintain the physical integrity of the NID. It will be NewPhone’s responsibility to ensure there is no safety hazard, and NewPhone will hold BellSouth harmless for any liability associated with the removal of the BellSouth Loop from the BellSouth NID. Furthermore, it shall be the responsibility of the disconnecting Party, once the other Party’s loop has been disconnected from the NID, to reconnect the disconnected loop to a nationally recognized testing laboratory listed station protector, which has been grounded as per Article 800 of the National Electrical Code. If no spare station protector exists in the NID, the disconnected loop must be appropriately cleared, capped and stored. 2.7.3.3 NewPhone shall not remove or disconnect ground wires from BellSouth’s NIDs, enclosures, or protectors. 2.7.3.4 NewPhone shall not remove or disconnect NID modules, protectors, or terminals from BellSouth’s NID enclosures. 2.7.3.5 Due to the wide variety of NID enclosures and outside plant environments, BellSouth will work with NewPhone to develop specific procedures to establish the most effective means of implementing this section if the procedures set forth herein do not apply to the NID in question.
Fitness Center Subject to the provisions of this Section, so long as Tenant is not in Default under this Lease, and provided Tenant’s employees execute a standard waiver of liability form used at the Fitness Center (hereinafter defined) and pay the applicable one time or monthly fee, then Tenant’s employees (the “Fitness Center Users”) shall be entitled to use the KINETIC fitness center (the “Fitness Center”) in the building located at 600 Xxxxxxx Xxxxxx Xxxxx, Xxxxxxx Xxxxx, Xxxxxxxxxx. The use of the Fitness Center shall be subject to the rules and regulations (including rules regarding hours of use) established from time to time by the Fitness Center operator. Landlord and Tenant acknowledge that the use of the Fitness Center by the Fitness Center Users shall be at their own risk. Tenant acknowledges that the provisions of this Section shall not be deemed to be a representation by Landlord that the Fitness Center (or any other fitness facility) shall be continuously operated and maintained throughout the Term of this Lease, and no termination of Tenant’s or the Fitness Center Users’ rights to the Fitness Center shall entitle Tenant to an abatement or reduction in Basic Rent, constitute a constructive eviction, or result in an event of default by Landlord under this Lease. Tenant hereby voluntarily releases, discharges, waives and relinquishes any and all actions or causes of action for personal injury or property damage occurring to Tenant or its employees or agents arising as a result of the use of the Fitness Center, or any activities incidental thereto, wherever or however the same may occur, and further agrees that Tenant will not prosecute any claim for personal injury or property damage against Landlord or any of its officers, agents, servants or employees for any said causes of action. It is the intention of Tenant with respect to the Fitness Center to exempt and relieve Landlord from liability for personal injury or property damage caused by negligence. Tenant’s rights hereunder to permit its employees to use the Fitness Center shall belong solely to Tenant and may not be transferred or assigned without Landlord’s prior written consent, which may be withheld by Landlord in Landlord’s sole discretion.
Orientation and Training A transferring employee will be orientated separately to both or their new home in accordance with Article 20 the collective agreement of the designated employer.
Modification of the Small Generating Facility The Interconnection Customer must receive written authorization from the NYISO and Connecting Transmission Owner before making any change to the Small Generating Facility that may have a material impact on the safety or reliability of the New York State Transmission System or the Distribution System. Such authorization shall not be unreasonably withheld. Modifications shall be done in accordance with Good Utility Practice. If the Interconnection Customer makes such modification without the prior written authorization of the NYISO and Connecting Transmission Owner, the Connecting Transmission Owner shall have the right to temporarily disconnect the Small Generating Facility. If disconnected, the Small Generating Facility will not be reconnected until the unauthorized modifications are authorized or removed.
STUDENTS AND TRAINEES Payments which a student, or an apprentice or business, technical, agricultural or forestry trainee, who is or was immediately before visiting a Contracting State a resident of the other Contracting State and who is present in the first-mentioned State solely for the purpose of his education or training receives for the purpose of his maintenance, education or training shall not be taxed in that State, provided that such payments arise from sources outside that State.
Fares and Travel Allowance All Employees shall be entitled to receive the fares and travel allowance as follows:
Access to PHI Business Associate shall provide access to PHI in a Designated Record Set to Covered Entity or as directed by Covered Entity to an Individual to meet the requirements under 45 CFR § 164.524. Business Associate shall provide such access in the time and manner reasonably designated by Covered Entity. Within three (3) business days, Business Associate shall forward to Covered Entity for handling any request for access to PHI that Business Associate directly receives from an Individual.
APPRENTICES/TRAINEES 25.1 Apprentices/Trainees shall be entitled to all of the applicable rates and conditions of employment prescribed by this Agreement. 25.2 For clarification, in addition to the rates in APPENDIX 1, Trainees are entitled to receive full Daily Travel, XXXX, BEWT, CIPQ, Superannuation and any other entitlements in accordance with this document. Such entitlements shall not be paid at rates applicable to Apprentices. 25.3 Training arrangements for Apprentices/Trainees shall be as provided in the Building and Construction General On-site Award 2020. 25.4 Apprentices/Trainees shall be entitled to be paid the daily fares and travel allowance whilst attending training. 25.5 The Employer shall be responsible for meeting all costs associated with Apprenticeship/Traineeship training, including any student registration, tuition fee or other course costs. 25.6 During the first year of an Apprenticeship, tools to the minimum retail value of $600.00 shall be supplied by the Employer within a period of three months after the expiry of the probationary period or within a period of six months from the date of commencement of the employment, whichever first occurs. 25.7 During the second and subsequent years (or part of a year) of apprenticeship tools to the retail value of $600.00 shall be supplied by the Employer within a period of three months from the commencement date of each such year (or part of a year) of the indentured Apprenticeship. 25.8 Where an Apprentice has entered a Competency Based Training Agreement, the provision of tools will be on the following basis: (a) During the term of Apprenticeship, an Employer shall, in respect of each level of the apprenticeship program, supply the Apprentice with tools of trade, to a minimum retail value of $600.00. (b) The supply of tools of trade for each level of the program shall be linked to the successful achievement of competencies or, where appropriate, the demonstration of approved levels of progression towards the achievement of competencies as prescribed by the relevant National Training Package or in the relevant Award. (c) Supply of tools will occur no later than three (3) months after the expiry of the probationary period or within a period of six (6) months from the date of commencement of the employment, whichever first occurs, and no later than three (3) months into subsequent levels of the apprenticeship. (d) Apprentices employed under part-time or school based arrangements shall be entitled to a supply of tools consistent with the requirements as outlined in clause 25.6 and clause 25.7 above.