Project Commencement and Completion. Contractor shall commence the Work on the date of the Notice to Proceed or as agreed to with DFCM (“Commencement Date”) and complete the Work by the Click here to enter a date (“Completion Date”). Contractor shall pay DFCM Liquidated Damages in the amount of $Liquidated Damages for each calendar day that Contractor fails to complete the Work after the Completion Date.
Project Commencement and Completion. 57 ARTICLE 18 PERFORMANCE TESTING 57
Project Commencement and Completion. 55 Section 17.1 Notice To Proceed 55 Section 17.2 Time for Completion 57 Section 17.3 Buyer’s Request for Earlier Completion 57 Section 17.4 Delay in Completion 57 ARTICLE 18 PERFORMANCE TESTING 57 Section 18.1 Performance Tests 57 Section 18.2 Emissions Guarantee 58 Section 18.3 Cost and Direction 58 Section 18.4 Buyer’s Right to Validate 58 Section 18.5 Additional Tests; Test Energy 59 Section 18.6 Timing 59 Section 18.7 Test Reports 59 Section 18.8 Failure on Tests or Inspection 60 Section 18.9 Duty to Advise of Defects, Errors and Omissions in Plant and Equipment 60 WORK 60 Section 19.1 Identification of Defects 60 Section 19.2 Replacement of Defects 61
Project Commencement and Completion. (a) The Member shall provide written notice to the Access Supervisor at least fifteen (15) days prior to the commencement of the Covered Work, unless otherwise approved by the Access Supervisor for emergency circumstances.
(b) The Member shall also provide written notice upon completion of the Covered Work to the Access Supervisor. For Covered Work on BPBCA Property (e.g., not on Member Property), the Member’s completion notice shall be accompanied by the design engineer’s letter of completion and any As-Built diagrams required by federal, state, or local permitting agencies. The Access Supervisor may conduct an inspection to confirm the Covered Work was performed in accordance with the application Approval and may require “As-Built” drawing(s) of Covered Work. A certificate of completion, as per Exhibit C, will be issued upon full BPBCA Property restoration to the satisfaction of the Access Supervisor.
(c) Upon completion, the Member shall submit xxxx xxxxxx(s) executed by any contractors, engineers, or other consultants, who performed and/or supported the Covered Work , to evidence that the Member has satisfied all invoices. A copy of the lien waiver form is attached as (Exhibit D).
(d) In the event construction has commenced but has failed to be completed by the Member within the approved timeline, or in the event the Member and/or their contractor(s) can no longer perform the Covered Work, unless otherwise approved by the Access Supervisor, the Access Supervisor will issue a failure to complete notice as per the attached (Exhibit E).
(e) The Member, upon receipt of such notice, will be provided a fourteen (14) day cure period to complete the Covered Work per the Approval, or if unable to finish due to weather conditions or other circumstances beyond the control of Member, provide a Performance Bond, if required by the Access Supervisor, for the remaining Covered Work.
(f) If after the 14-day cure period the Covered Work remains incomplete, the Board reserves the right to retain a successor contractor to perform the Covered Work, at the sole expense of the Member, and/or to call the Performance Bond to pay for the completion of the Covered Work on BPBCA Property.
(g) Failure to return BPBCA Property to pre-construction or better condition will result in a delayed Certificate of Completion from the Access Supervisor and/or Certificate of Zoning Compliance to obtain a Certificate of Occupancy from Zoning Enforcement Officer, until reparations have been sa...
Project Commencement and Completion. 2
Section 2.1 Notice To Proceed 2 Section 2.2 Time for Completion 4 Section 2.3 Company’s Request for Earlier Completion 4 Section 2.4 Delay in Completion 4 Section 3.1 Payment Milestones 4 Section 3.2 Conditions Precedent 5 Section 3.3 Wire Transfer 7 Section 3.4 Invoice Instructions 7 Section 3.5 Contractor Taxes 7 Section 3.6 Project Taxes 8
Project Commencement and Completion. Partners shall commence the Project by August 1, 2023. Partners shall complete the Project within four years thereafter. Partners shall not allow tenancy in any of the Properties until the City has issued a Certificate of Occupancy for such Property. The issuance of a Certificate of Occupancy shall constitute “completion” for that property. In the event Partners determines that the cost to repair and rehabilitate a Property exceeds the cost of razing and rebuilding, Partners shall notify the City of the same. City shall have the opportunity to conduct its own assessment as to the cost of repairs. The City Building Inspector shall have the ability to authorize the razing of a Property in lieu of repairs, and in such event, Partners will pay City the repayment set forth in Section 4.5 of this Agreement.
Project Commencement and Completion. The Applicant will procure that the Project commences by the Project Start Date and that (once commenced) it is carried out and completed in a good and workmanlike manner and (subject to Force Majeure) by the Target Date of Practical Completion (but in any event by the Project Longstop Date). The Applicant will notify the Agency within 15 Working Days of the date on which the relevant Works commence(d) on the Site and the Date of Practical Completion. The Applicant will procure that each Contractor complies with its Works Contract(s) and the Applicant will enforce the terms of the Works Contracts at all times. The Applicant shall take all reasonable steps to satisfy the Agency that its procurement policies and procedures in relation to employees, suppliers and sub‑contractors (including, but not limited to, the Contactors) are suitable and competent in all respects to allow the proper performance of all work or tasks in relation to the Project. The Applicant will notify the Agency of the identity of each Contractor and any other Project partners within 10 Working Days of commencement of their involvement, and will keep the Agency informed of any change to such parties.
Project Commencement and Completion. The Applicant will procure that the Project is carried out and completed in a good and workmanlike manner and in accordance with: - the Works Programme; the Works Specifications; the Required Standards; and the Project Specification(s). The Applicant will procure that (subject to Force Majeure) the Project commences by [Insert Date] and Practical Completion is achieved by the Target Date (but in any event by the LGF Funding Longstop Date). The Applicant will notify the CPCA within 21 days of the Works Start Date and the Date of Practical Completion. The Applicant will produce the Qualifying Expenditure Plan prior to the first Claim and will update the Qualifying Expenditure Plan annually thereafter. The Applicant will procure that each Contractor complies with its Works Contract(s) and the Applicant will enforce the terms of the Works Contracts at all times. The Applicant will take all reasonable steps to satisfy the CPCA that its procurement policies and procedures in relation to employees, suppliers and sub-contractors (including, but not limited to, the Contactors) are suitable and competent in all respects to allow the proper performance of all work or tasks in relation to the Project.
Project Commencement and Completion. The Contractor will perform the Work in an expedient and efficient manner to complete the Work within the times specified in the Contract Documents and the Notice-to-Proceed.
Project Commencement and Completion. The Developer must achieve Commencement of the Project and must be Fully Enclosed as a condition precedent to the full TIF Payment as specified in Section 4.3.
